Aruba AP-270-MNT-H2 Manual de usuario
AP-270-MNT-H2 Mounting Kit
Installation Guide
0511782-03 | April 2015 1
Package Content
AP-270-MNT-H2 Mounting Bracket x 1
M6x20 Screws x 2
Installation Guide (this document)
Installation
1. Use the AP-270-MNT-H2 as the template to mark the four mounting points on the wall.
2. Use a drill to make four holes on the four markings from the previous step.
3. Insert an anchor bolt (not included in the package) into each drilled hole.
4. Place the mounting bracket over the anchor bolts and press the bracket against the wall.
5. Place the washers and nut onto the bolt’s threaded end and tighten the nut until the mounting
bracket is firmly attached to the wall.
Figure 1 Attaching the Mounting Bracket to a Wall
The AP-270-MNT-H2 mounting kit supports multiple access point (AP) models. All installation images show the
277 AP.
2AP-270-MNT-H2 Mounting Kit | Installation Guide
6. Slide the holder of the AP into the opening of the mounting bracket and use two M6x20 screws
included in the package to fix the AP to the mounting bracket.
Figure 2 Attaching the AP to the Mounting Bracket
Figure 3 Attaching the AP to the Mounting Bracket (Completed)
Tabla de contenidos
Otros manuales de Rack y soporte de Aruba
Aruba
Aruba AP-103H-MNT1 Manual de usuario
Aruba
Aruba AP-270-MNT-H1 Manual de usuario
Aruba
Aruba AP-303H-MNTU Manual de usuario
Aruba
Aruba AP-220-MNT-W2 Manual de usuario
Aruba
Aruba 205H-MNT1 Manual de usuario
Aruba
Aruba AP-130-MNT-W1 Manual de usuario
Aruba
Aruba AP-320-MNT-T Manual de usuario
Aruba
Aruba AP-205H-MNT1 Manual de usuario
Aruba
Aruba LS-BT1-MNT-50 Manual de usuario
Aruba
Aruba AP-500H-MNT1 Manual de usuario
