Aries 2164003 Manual de usuario

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 1

INSTALLATION MANUAL

Parts List

1Bull bar

1Driver / left mounting bracket

1Passenger / right mounting bracket

4Hex bolt, M8

4Flat washer, M8

4Nylock nut, M8

4Bolt plate, M12

4Flat washer, M12

4Nylock nut, M12

1* LED wiring harness*

* Wiring harness only included

with LED equipped models

Tools Required

Ratchet Extension

Level Wrench set

Socket set -- Maintenance

To protect the product, wax after installing. Regular waxing is recommended

to add a protective layer over the finish. Do not use any type of polish or wax

that may contain abrasives that could damage the finish.

For polished, gloss and other smooth finishes,

polish may be used to clear small scratches and scuffs on the finish.

Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive

cleaners, abrasive pads, wire brushes or other similar products that may damage the ﬁnish.

Product Photo

2164003 2164103

Torque Speciﬁcations

M8 bolt 7 ft-lbs.

M12 bolt 28 ft-lbs.

Use above torque setting unless otherwise noted

Level of Difﬁculty

Moderate

NOTICE

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of installation and reduce the time required.

To help prevent damage to the product or vehicle, refer to the specified

torque specifications when securing hardware during the installation process.

Product Registration and Warranty

CURT Group stands behind our products with industry-leading warranties.

Provide feedback and help us to improve our products by registering your purchase at:

warranty.curtgroup.com/surveys

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 2

Step 1

For vehicles without tow hooks, skip to step 2.

Remove and set aside the driver-side and passenger-side tow hooks.

Step 4

With help, lift the bull bar into place and

align the bolts into the mounting brackets.

Secure the bull bar to the brackets

using the M8 flat washers and locking

nuts (Chevrolet - pictured). Snug the

hardware, but do not fully tighten.

Step 2

Place the driver-side mounting bracket

up to the vehicle and secure the bracket

using the supplied M12 hardware. Snug

the hardware, but do not fully tighten.

Chevrolet: Mount the bracket inside the

frame to the outboard wall with ﬂanges bent in.

GMC: Mount the bracket inside the frame to

the inboard wall with ﬂanges bent out (pictured).

Repeat on the passenger side of the vehicle. GMC

Step 3

Lay the bull bar on a flat surface.

Insert two M8 hex bolts on each side

into the inner rail slot (GMC - pictured)

or outer rail slot (Chevrolet).

GMC

Chevrolet

Step 5

Level and adjust the bull bar into the desired

position and tighten all hardware to the

recommended torque specifications

listed on the table on the first page.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •RA •PAGE 3

Step 7

Connect the red fused wire with the

ring terminal to the positive battery post.

Connect the black wire ring terminal

to the negative battery post or other

suitable vehicle ground point.

Mount the supplied relay to the vehicle

and secure all wires with zip ties away

from moving parts to avioid damage.

Test the lights to ensure proper function.

Step 6

If your bull bar is not equipped

with lights skip to step 8.

NOTICE

If the LED lights are being used

with a 24V system, the 12V relay will

need to be replaced with a 24V unit.

Disconnect the supplied switch from the

wire harness and install in desired location.

With the switch installed, route the wire

harness to the LED lights and the switch.

Reconnect the blue, red, and black spade

connectors to the switch as shown. The black

wire connects to the gold switch terminal.

Plug the male connector on the wire harness into

the female connector attached to the LED lights

Step 8

Congratulations on the installation of

your new ARIES AdvantEDGE bull bar.

With the bull bar installed, periodic

inspections should be performed to ensure

all mounting hardware remains tight.

To protect your investment, see the

‘Notes and Maintenance’ section on

the first page of this instruction manual.

Este manual sirve para los siguientes modelos

Otros manuales de Accesorios para automóviles de Aries

Aries

Aries 2051182 Manual de usuario

Aries

Aries AL239042 Manual de usuario

Aries

Aries 2156001 Manual de usuario

Aries

Aries 204017 Manual de usuario

Aries

Aries 2081300 Manual de usuario

Aries

Aries 2074141 Manual de usuario

Aries

Aries 1110311 Manual de usuario

Aries

Aries 3044 Manual de usuario

Aries

Aries 1500302 Manual de usuario

Aries

Aries 2055100 Manual de usuario

Aries

Aries 215039 Manual de usuario

Aries

Aries S223015-2 Manual de usuario

Aries

Aries 2074106 Manual de usuario

Aries

Aries B35-2004-3 Manual de usuario

Aries

Aries S223043 Manual de usuario

Aries

Aries 5056 Manual de usuario

Aries

Aries 205003 Manual de usuario

Aries

Aries S223044-2 Manual de usuario

Aries

Aries 205039 Manual de usuario

Aries

Aries 2082082 Manual de usuario

Aries

Aries Avicenum LYMPHO 360 Manual de usuario

Aries

Aries S224046-2 Manual de usuario

Aries

Aries 2153000 Manual de usuario

Aries

Aries AL233043 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario

Prorack

Prorack K1163 Manual de usuario