APART MASK12 Manual de usuario
MASK12(T)
Instruction manual
Instruction manualMASK12(T)
3
Features
4
FULL RANGE SPEAKER
Introduction
Thank you for buying the Apart MASK12(T) speaker. With this
new member of the MASK series, we have once again broken
new ground in sonic performance and installer convenience. The
MASK12(T) speaker is meant for fixed indoor installations. Available
in 8 ohms and 100 volt, MASK12(T) can be used in many full
range applications where a medium to high sound pressure level is
required.
The multi-angle plywood cabinet, equipped with 14 rigging points
for shoulder eye bolts, and the optional wall/ceiling brackets allow
you to safely install the speaker in many different positions, be it in
a horizontal or vertical position, close to the ceiling or at the wall.
With a weight of only 19.2 kgs (8 ohm version) or 21.4 kgs (100 volt
version), the speaker is easy to install.
As usual, these Apart speakers will convince you in terms of sound
quality, reliability and setup versatility. Paired with our Revamp
series amplifiers, your sound system will be taken to a new level of
performance.
Please read this manual carefully before using the product. This will
give you the necessary product and installation instructions to assure
a seamless installation and non-compromised overall sound quality.
Unpacking
Upon receipt of this product, check the carton and packing materials
for any damage caused by transport. Carefully unpack the product
and check that all parts are present and in undamaged condition.
Notify your dealer and/or the shipping company immediately if any
damage has occurred during transport. Keep the carton and packing
materials in case you have to return the product.
Instruction manualMASK12(T)
5
Safety precautions
• Everyone who is involved with the installation and/or operation
of this product must read and understand all local safety
regulations and instructions.
• Keep this manual for future reference.
• Avoid the presence of fire and flames and do not operate the
product in the presence of heat sources, flammable liquids or
gases.
• Take care of your speaker wires, they must be free of damage.
Damaged speaker wires may result in poor sound quality and
can damage amplifiers, other parts of the audio chain and can
cause injury caused by exposure to high voltages.
• No main power shall be connected to the loudspeakers, doing
so will damage the speaker.
• This speaker should only be serviced by qualified personnel. If
not, warranty will be void.
• Use cables of the right gauge, certainly for long runs.
• Use cables with clear color indication and maintain polarity
throughout the whole system.
• For indoor use only. Do not expose the unit to outdoor weather
conditions.
• Use mounting hardware that can support the weight of the
device in a safe way.
• Inspect all mounting hardware periodically and tighten screws
when necessary.
• Do not expose the speaker to excessive temperature, moisture
or vibrations.
6
FULL RANGE SPEAKER
• Do not spill liquids on the product and/or other parts in the
audio chain.
• Always pair the speaker with a matching amplifier, in terms of
load impedance and output power.
• Avoid amplifier clipping, loud feedback, popping noise from
other devices and continuous high power output or distorted
signals.
• When turning on the power of your audio system, always turn
on the power amplifier last to avoid popping signals. For this
reason, always turn of the power amplifier first.
• Avoid ground loops in audio systems.
• Always follow these basic instructions when operating or
installing the product.
• Warning: this speaker is capable of producing high sound
pressure levels that can cause permanent hearing loss.
• Apart audio is not responsible for any damage or injury caused
by improper installation or use of this product.
• Repairs, servicing and electrical connections must be carried out
by qualified personnel only.
Instruction manualMASK12(T)
7
Speaker connection (8 ohm version)
Input: the signal from a power amplifier must be connected to the
input/link speakon®connector. The connectors are equivalent and
internally wired in parallel. Connector 1+ (positive) and 1- (negative)
are used. 2+ and 2- are not connected.
8
FULL RANGE SPEAKER
Speaker connection (100 volt version)
Input: the signal from a power amplifier must be connected to the
input/link euroblock connector. The connectors are equivalent and
internally wired in parallel.
Power select: set to 120W or 240W position according to your
specific needs.
Speaker line voltage select: set to 100 volt or 70 volt position
depending on the actual speaker line specification.
Instruction manualMASK12(T)
9
Speaker installation
Install the speaker on the wall or ceiling using our optional
U-bracket. Make sure the wall, ceiling, surface, structure and
additional mounting hardware are capable of safely supporting the
speaker’s weight. When suspending the speaker with chains, make
sure to mount the M10 shoulder eye bolts (not supplied) on more
than one side of the speaker. Use at least 3 chains, for example,
one at the top of the speaker, and 2 on each side. Adjust the length
of the chain(s) to position the speaker correctly. Do not attempt to
suspend multiple speakers on the same set of chains or brackets.
For safety reasons, every speaker must be mounted using its own
set of chains or brackets.
washer 10.5 x 40
M10 Shoulder eye bolt and washer
(not supplied)
10
FULL RANGE SPEAKER
Installation using MASK12PBRA-BL (optional)
To install the MASK12 speaker on the bracket, remove the center
M10 bolt from the bottom of the speaker. Attach the pole mount
(supplied with the MASK12PBRA-BL) securely by fastening the
mount on the speaker.
Fix the wall plate on a sufficiently strong wall using all 6 mounting
holes. Always use mounting hardware (not supplied) capable of
supporting the load safely. The speaker arm can be swiveled over a
180° angle from left to right and can be tilted down up to 20° by
turning the tilt screw. Mount the speaker with the attached speaker
pole mount on the bracket and secure it by tightening the lock
screws.
Otros manuales para MASK12
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Oradores de APART
APART
APART COLS41 Manual de usuario
APART
APART CM20T Manual de usuario
APART
APART SDQ5Pir Manual de usuario
APART
APART CMSQ108 Manual de usuario
APART
APART CM1008D Manual de usuario
APART
APART VINCI 5 Manual de usuario
APART
APART lsc4s Manual de usuario
APART
APART CMAR5T-W Manual de usuario
APART
APART CM6TSMF Manual de usuario
APART
APART VINCI 7 Manual de usuario
APART
APART OVO3T Manual de usuario
APART
APART MASK series Manual de usuario
APART
APART CM6QFT Manual de usuario
APART
APART KUBO3 Manual de usuario
APART
APART SDQ5P Manual de usuario
APART
APART MASK SERIES Manual de usuario
APART
APART MASK2 Manual de usuario
APART
APART OVO5P-W Manual de usuario
APART
APART CM8E Manual de usuario
APART
APART CM3T Manual de usuario
