Alpha Alpha CB Boiler Manual de usuario

Installation Instructions

Alpha CB/C/SY Boiler

Vertical FlueTerminal Assembly

Concentric (60/100) Flue System

(Kit Part No. 6.1000350)

KIT CONTENTS

1. GENERAL

a. ThefluesystemmustbeinstalledinaccordancewithBS5440:1;1990.

b. The boiler must be installed in accordance with the Installation

instructions supplied with the boiler.

c. The vertical flue terminal assembly is equivalent to a 1 m length of

flue.

d. Each 45° bend is equivalent to a 0.5 m length of flue.

Note: A 90° bend must not be used with the vertical flue.

e. Refer to the vertical flue options (Fig. 4) and ensure the flue length

does not exceed the equivalent of 4 m (including the terminal

assembly).

f. Additional flue lengths of 0.75 m and 1.0 m are available for extending

the flue up to a maximum equivalent flue length of 4 m (including the

terminal assembly).

g. The vertical flue terminal assembly may be connected directly to the

boiler adaptor.

h. To determine the actual length of flue required (L), measure the

distance from the top of the side panel to the weathering slate position

and subtract 640 mm for the terminal assembly, i.e. L = A - 640 mm

(see Fig. 4).

i. When the flue length is more than 2.5 m, the flue restrictor (Fig. 1) must

be removed. - remove the screw securing it in the boiler adaptor and lift

out.

2. INSTALLATION

a. When the template is on the wall in the boiler position, continue the

vertical line from the centre of the flue hole to the roof/ceiling position.

Mark the centre position of the flue hole 215 mm from this line as shown in Fig. 2.

Fig. 1

Fig. 2

Compiled and designed by Publications 2000, Tel (01670) 356211 08/04/D131

Fig. 4

b. Cut a hole and/or remove tiles so that there is at least a 150

mm diameter hole in the roof. Ensure there is at least a 25

mm gap between the outer duct and any combustible

material.

c. Fit a 125 mm diameter weathering slate over the hole in the

roof. A suitable weathering slate (Part No. 6.1000380) is

available from Alpha Therm Ltd.

d. Position the vertical terminal assembly into the weathering

slate ensuring that the slate is located under the lip of the

terminal as shown in Fig. 3.

Note: Ensure that the minimum distances are maintained

(see Fig. 4). Do not secure the terminal into position at this

stage.

e. Assemble the flue ducts together and cut the outer air duct

and inner flue duct assemblies to the correct lengths, i.e. up

to the terminal.

f. Place the inner duct into the outer duct and fit the ducts to

the boiler, as shown in Fig. 3, using the clamps supplied.

g. Connect the terminal ducts to the flue assembly, as shown

in Fig. 3. Secure the inner ducts with the clamps supplied

before locating the outer duct clamp.

h. After assembling all of the ducts, check that the terminal is

correctly located above the roof.

Note: Ensure that the flue assembly is supported at roof

level using suitable brackets, and that the weathering slate

is fitted correctly. Fig. 3

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

Nepicar House,LondonRoad, Wrotham Heath,

Sevenoaks, Kent TN15 7RS

Technical Helpline: 0870 3001 964

email: info@alphatherm.co.uk

website: www.alpha-innovation.co.uk

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Caldera de Alpha

Alpha

Alpha Alpha CD13R Manual de usuario

Alpha

Alpha InTec 12S (NG) Guía del usuario

Alpha

Alpha Alpha CB Boiler Manual de usuario

Alpha

Alpha ARES Pro 150 Guía del usuario

Alpha

Alpha Alpha C Boiler Manual de usuario

Alpha

Alpha Alpha CD25C Manual de usuario

Alpha

Alpha Alpha CD24C Guía del usuario

Alpha

Alpha Alpha CD24 Guía del usuario

Alpha

Alpha 47 532 69 Guía del usuario

Alpha

Alpha E-Tec 28 Manual de usuario

Alpha

Alpha Alpha CB50 Boiler Manual de usuario

Alpha

Alpha 30C Guía del usuario

Alpha

Alpha Alpha CB24 Manual de usuario

Alpha

Alpha ARES Pro 150 Guía del usuario

Alpha

Alpha Alpha InTec 12SNG Guía del usuario

Alpha

Alpha Alpha CD50S Guía del usuario

Alpha

Alpha 41 532 05 Guía del usuario

Alpha

Alpha Alpha C23 Manual de usuario

Alpha

Alpha InTec 40GS2 Guía del usuario

Alpha

Alpha Alpha 240 Boiler Range Manual de instrucciones y seguridad

Alpha

Alpha SY9-24 Manual de usuario

Alpha

Alpha Alpha CD32 Manual de usuario

Alpha

Alpha InTec2 20SE Guía del usuario

Alpha

Alpha Ocean Style FF Manual de usuario

Manuales populares de Caldera de otras marcas

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manual de usuario

Radijator

Radijator BIO max 23.1 Manual de usuario

Brunner

Brunner BSV 20 Manual de usuario

Buderus

Buderus Logamax GB062-24 KDE H V2 Manual de usuario

Potterton

Potterton 50e Hoja de datos

UTICA BOILERS

UTICA BOILERS TriFire Manual de usuario

Joannes

Joannes LADY Series Manual

ECR International

ECR International UB90-125 Manual de instrucciones

Froling

Froling FHG Turbo 3000 Manual de usuario

Froling

Froling P4 Pellet 8 - 105 Manual de usuario

U.S. Boiler Company

U.S. Boiler Company K2 Manual de usuario

Henrad

Henrad C95 FF Manual de usuario

NeOvo

NeOvo EcoNox EF 36 Manual de usuario

Potterton

Potterton PROMAX SL 12 Manual de usuario

Eco Hometec

Eco Hometec EC 25 COMPACT Manual de usuario

Viessmann

Viessmann VITODENS 200 Guía

Baxi

Baxi Prime 1.24 Manual de usuario

REXNOVA

REXNOVA ISA 20 BITHERMAL Manual de usuario