Alpha Alpha CD Condensing Boiler Manual de usuario

Installation Instructions

Alpha CD Condensing Boiler

CDVertical FlueTerminal Assembly

Concentric (60/100) Flue System

(Kit Part No. 6.2000520)

KIT CONTENTS

1. GENERAL

Note: The CD Vertical flue terminal MUST ONLY be used with an Alpha CD condensing boiler.

a. The flue system must be installed in accordance with BS 5440:1;1990.

b. The boiler must be installed in accordance with the Installation instructions supplied with the CD boiler.

c. The vertical flue terminal assembly is equivalent to a 1 m length of flue.

d. Each 45° bend is equivalent to a 0.9 m length of flue.

Note: A 90° bend must not be used with the vertical flue.

e. Refer to the vertical flue options (Fig. 3) and ensure the flue length does not exceed the equivalent of 15 m

(including the terminal assembly).

f. Additional flue lengths of 0.75 m (CD flue extension, Part No. 6.2000750) are available for extending the flue up to a

maximum equivalent flue length of 15 m (including the terminal assembly).

g. The CD vertical flue terminal assembly may be connected directly to

the boiler adaptor. However, under no circumstances must it be

shortened.

h. To determine the actual length of flue required (L), measure the

distance from the top of the side panel to the weathering slate position

and subtract 640 mm for the terminal assembly, i.e. L = A - 640 mm

(see Fig. 3).

2. INSTALLATION

a. When the template is on the wall in the boiler position, continue the

vertical line from the centre of the flue hole to the roof/ceiling position.

Mark the centre position of the flue hole 165 mm from this line as

shown in Fig. 1.

b. Cut a hole and/or remove tiles so that there is at least a 150 mm

diameter hole in the roof. Ensure there is at least a 25 mm gap

between the outer duct and any combustible material. Fig. 1

Compiled and designed by Publications 2000, Tel (01670) 356211 11/03/D155

Fig. 3

c. Fit a 125 mm diameter weathering slate over the hole in

the roof. A suitable weathering slate (Part No.

6.1000380) is available from Alpha Therm Ltd.

d. Position the vertical terminal assembly into the

weathering slate ensuring that the slate is located under

the lip of the terminal as shown in Fig. 2.

Note: Ensure that the minimum distances are maintained

(see Fig. 3). Do not secure the terminal into position at

this stage.

e. Assemble the flue extensions together by locating the

inner duct into the seal joint and secure each extension

together with the clamps supplied (three screws). Ensure

that the clamps are positioned centrally over the joints.

Note: If it is required to cut an extension, DO NOT cut

the end of the inner duct that incorporates the seal joint.

Ensure the inner duct end without the seal joint is cut so

that it is 15 mm longer than the outer duct.

f. Connect the vertical terminal ducts to the flue assembly,

as shown in Fig. 2. Secure with the outer duct clamp

(three screws).

g. After assembling all of the ducts, check that the terminal

is correctly located above the roof.

Note: Ensure that the flue assembly is supported at roof

level using suitable brackets, and that the weathering

slate is fitted correctly. Fig. 2

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

NepicarHouse,LondonRoad,WrothamHeath,

Sevenoaks, Kent TN15 7RS

Tel: 0870 3001964

email: [email protected]

website: www.alpha-boilers.com

Tabla de contenidos

Otros manuales de Caldera de Alpha

Alpha

Alpha Alpha CD50 Manual de usuario

Alpha

Alpha Alpha CD13R Guía del usuario

Alpha

Alpha Alpha CB24 Manual de usuario

Alpha

Alpha E-Tec 28 Guía del usuario

Alpha

Alpha InTec 12S (NG) Guía del usuario

Alpha

Alpha 47 532 69 Guía del usuario

Alpha

Alpha Alpha 240XP Guía del usuario

Alpha

Alpha E-Tec Plus 28 Guía del usuario

Alpha

Alpha Alpha Plus DH Units Guía

Alpha

Alpha 240eco Guía del usuario

Alpha

Alpha 280E Manual de usuario

Alpha

Alpha Alpha CD35C Manual de usuario

Alpha

Alpha Eco Manual de usuario

Alpha

Alpha Alpha CD50S Guía del usuario

Alpha

Alpha Alpha CB Boiler Manual de usuario

Alpha

Alpha Alpha CD50 Manual de usuario

Alpha

Alpha 240P Manual de usuario

Alpha

Alpha Alpha CombiMax 350 Manual de usuario

Alpha

Alpha Alpha HE25 Guía del usuario

Alpha

Alpha ARES 440 Tec Guía del usuario

Alpha

Alpha Alpha 240XP Manual de usuario

Alpha

Alpha Alpha 500E Manual de usuario

Alpha

Alpha ARES 150 Tec Guía del usuario

Alpha

Alpha CB28X Manual de servicio

Manuales populares de Caldera de otras marcas

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manual de usuario

Radijator

Radijator BIO max 23.1 Manual de usuario

Brunner

Brunner BSV 20 Manual de usuario

Buderus

Buderus Logamax GB062-24 KDE H V2 Manual de usuario

Potterton

Potterton 50e Hoja de datos

UTICA BOILERS

UTICA BOILERS TriFire Manual de usuario

Joannes

Joannes LADY Series Manual

ECR International

ECR International UB90-125 Manual de instrucciones

Froling

Froling FHG Turbo 3000 Manual de usuario

Froling

Froling P4 Pellet 8 - 105 Manual de usuario

U.S. Boiler Company

U.S. Boiler Company K2 Manual de usuario

Henrad

Henrad C95 FF Manual de usuario

NeOvo

NeOvo EcoNox EF 36 Manual de usuario

Potterton

Potterton PROMAX SL 12 Manual de usuario

Eco Hometec

Eco Hometec EC 25 COMPACT Manual de usuario

Viessmann

Viessmann VITODENS 200 Guía

Baxi

Baxi Prime 1.24 Manual de usuario

REXNOVA

REXNOVA ISA 20 BITHERMAL Manual de usuario