Advantech IPC-622MS Manual de usuario
IPC-622MS
Industrial PC Chassis
Copyright Notice
This document is copyrighted, January 1999 , by Advantech Co., Ltd. All rights are reserved. Advan-
tech Co., Ltd. reserves the right to make improvements to the products described in this manual at any
time without notice.
No part of this manual may be reproduced, copied, translated or transmitted in any form or by any
means without the prior written permission of Advantech Co., Ltd. Information provided in this manual
is intended to be accurate and reliable. However, Advantech Co., Ltd. assumes no responsibility for its
use, nor for any infringements of the rights of third parties which may result from its use.
Acknowledgments
IPC-622MS, PCA-6119P17 is a trademark of Advantech Co., Ltd.
NOTE:
The information in this document is provided for reference only. Advantech does not assume any liability arising
out of the application or use of the information or products described herein. This manual is subject to change
without notice.
Part No. 2002062200 1st Edition
Printed in Taiwan 1 February 1999
Contents
Chapter 1 General Information .................................................... 1
1.1 Introduction................................................................................................................. 1
1.2 Specifications ............................................................................................................ 1
1.3 Dimensions................................................................................................................ 2
Chapter 2 System Setup ............................................................................3
2.1 Remove thecover ...................................................................................................... 3
2.2 Removing thehandles ................................................................................................ 4
2.3 Replacing thefilter...................................................................................................... 4
2.4 Installing thediskdrives.............................................................................................. 5
2.5 Cable wiring schematic .............................................................................................. 6
2.6 Cable wiring schematic .............................................................................................. 7
2.7 Therubber forcard vibrationdamped......................................................................... 8
Chapter 3 Fault Resilient Function ...........................................................9
3.1 Introduction................................................................................................................. 9
3.2 Faultdetection andalarmnotification ......................................................................... 9
3.3 Visible alarm and audible alarm ............................................................................... 10
3.4 Overheating sensor .................................................................................................. 10
Appendix A. Passive Backplane .................................................................................... 11
Appendix B. Exploded Diagram..................................................................................... 12
AppendixC. Safety Instructions...................................................................................... 14
AppendixC. Safety Instructions...................................................................................... 15
IPC-622MS User's Manual 1
Chapter 1 General Information
1.1 Introduction
The IPC-622MS is a 20-slot, 19" rackmount industrial PC chassis with 400-watt AC-DC power supply.
IPC-622MS features an advanced fault detection and alarm notification system to monitor its own
hardware status, including overheating and fan-failure problems. It is dangerous and will cause a lot of
loss if your PC system shuts down without any warning in advance. IPC-622MS , the fault resilient IPC,
is designed to prevent from this situation to be more relibile.
The IPC-622MS will withstand shock, vibration, dust and a wide range of operating temperatures in
harsh environments. The chassis is positively pressurized by six filtered push-pull cooling fans to exclude
dust and dirt. A lockable door protects drives and switches from tampering and particles.
1.2 Specifications
General
Construction: Heavy-duty steel
Disk drive capacity: Six 3.5" disk drives
Cooling system: Four 49 CFM cooling fan (flow in) in front and two 49CFM coolomg fans (flow
out) in rear panel with an air filter
Controls: Power On/Off switch, CPU reset and alarm reset button are protected by a lockable door
Indicators: LEDs for power On/Off and HDD activity. Bi-color LEDs(green and red) for fan failure
failure and overheating
Speaker: One 8 ohm / 0.2Watt speaker, volumn control on board
Dimensions: 19" (W) x 10.5" (H) x 18" (D)
482mm(W) x 267mm(H) x 457 mm(D)
Weight: 66 lb (30 Kg)
Paint color: Pantone 414U
Passive Backplane (PCA-6119P17)
Slots: 17PCI / 1PICMG -slot
PC board: 4-layer PCB with ground and power planes for reduced noise and lower power
supply impedance
Indicators: LEDs for +5 V, -5 V, +12 V and -12 V
2IPC-622MS User's Manual
1.3 Dimensions Unit = mm
400-watt AC-DC Power Supply
Output rating: 400 watts (Max.)
Input voltage: 100 to 130 VAC or 200 to 260 VAC @ 47~63 Hz, switchable
Output voltages: +5 V @ 40 A, +12 V @ 20 A, -5 V @ 0.5 A, -12 V @ 1 A
Maximun power output of all outputs combined must not exceed 400watts
Minimum load: +5 V @ 3 A, +12 V @ 0.5 A
MTBF: 150,000 hours
Safety: UL/CSA Approved
Environmental Specifications
Operating temperature: 41 to 95oF (5 to 35oC), Relative humidity : 10 to 85% @ 35oC
Storage Temperature : -13 to 140oF (-25 to 60oC), 0 to 95% relative humidity
Safety: UL / C-UL Listed
EMI: FCC Class A
Fault Detection and Alarm Notification
Fan failure: If either of the four cooling fans fails, the FAN LED changes color from green to red
also audio alarm. The dedicated LED remains red for failed fan set until it fixed.
High Temperature: If the chassis interior temperature exceeds 55oC(131oF)(standard setting), the
LED changes color from green to red also audio alarm.
IPC-622MS User's Manual 3
2.1 Remove the cover
Chapter 2 System Setup
Setting up your IPC-622MS requires only a screwdriver and a small amount of time. Before you begin,
you should also gather together all of the cards you plan to install, as well as the disk drives you plan
to use.
The lockable door is located on the lower chassis front cover providing access to the control panel. This
offers protection and for disk drive and air filter against damage and easily access. The control panel
functions include Power on/off switch , CPU reset switch and alarm reset switch and five LED
indicators to assist in monitoring system status. On the rear panel there is a Ground point (earthing point)
located on the bottom right hand corner. This provides an earth for the whole system and is attached via
a screw.
WARNING:Disconnect all power from the chassis before you install
the CPU cards. Unplug the power cord from the wall,
don't just turn off the power switch. If you are not sure
what to do, take the job to an experienced professional.
CAUTION:When pull-out the disk drive, it will cause the IDE / SCSI drives'
cable wiring disconnected. Be sure all the cables are well-con-
nected before slide back the disk drive bay.
2.1 Remove the cover
There are screws near the top along the sides secure the cover to the chassis. Remove them, and then
slide the cover toward the rear chassis. See figure 2.1 below:
4IPC-622MS User's Manual
2.2 Remove the handles
The handles and mounting ears for the front panel can be removed as follows. Please see figures 2.2
below
2.2 Removing the handles
2.3 Replacing the filter
The filter is located on the front upper chassis. Under continuous use, the filter should be replaced
about once a month. To replace the filter, refer to figure 2.4 below and do as the following steps :
1. Unscrewing the four thumb screws.
2. Take out the old filter and replace it with a new filter.
3. Fix it by thumb screw.
2.3 Replacing the filter
IPC-622MS User's Manual 5
2.4 Removing the disk drive bay
2.4 Installing the disk drives
1. Open the lockable door on the front panel of lower chassis. There are two independent disk drive
bays on the both sides. Remove the four outer screws which mount the shock-resistant drive-bay to
the chassis. See figure 2.4 below
2. Slide the drive-bay toward the front chassis and lift it free of the chassis. Remove the cover of the
drive bay front and insert the drives into their proper locations in the drive bay. See figure 2.5
2.5 Inserting the drives into the drive bay
6IPC-622MS User's Manual
2.5 HDDs layout & ID setting
POWER SSPPLY
IDE HDD
SCSI HDD 2
SCSI HDD 1
SCSI HDD 4
SCSI HDD 3
FANTEMPPWR IDE HDDSCSI HDD
Rackmount PC
IPC-622MS
Layout and ID setting of SCSI HDD
Item Wide SCSI HDD Remark
No.1 No.2 No.3 No.4
Arrangement to
Expansion bay
Left
Upper
Left
Center
Right
Upper
Right
Center
Refer to above fi
g
ure
ID 1 2 3 4
Termination On Off Off Off
The details of the setting
Position #1 (ID BIT 3) OPEN OPEN OPEN OPEN
Position #2 (ID BIT 2) OPEN OPEN OPEN CLOSE
Position #3 (ID BIT 1) OPEN CLOSE CLOSE OPEN
Position #4 (ID BIT 0) CLOSE OPEN CLOSE OPEN
Position #5 (AUTO SPIN) CLOSE CLOSE CLOSE CLOSE
Position #6
(
SCSI TER ON
)
CLOSE OPEN OPEN OPEN
Position #7 OPEN OPEN OPEN OPEN
Position #8 OPEN OPEN OPEN OPEN
Position #9 OPEN OPEN OPEN OPEN
Position #10 OPEN OPEN OPEN OPEN
Position #11 OPEN OPEN OPEN OPEN
Position #12 OPEN OPEN OPEN OPEN
OPEN : Shunt jumper is not installed
CLOSE : Shunt
j
um
p
er is installed
2.6 HDD layout
IPC-622MS User's Manual 7
2.6 Cable wiring schematic
The following picture is the cable schematic for IPC-622MS.
2.7 Cable schematic
Otros manuales para IPC-622MS
1
Tabla de contenidos
Otros manuales de Chasis de Advantech
Advantech
Advantech IPC-644 Series Manual de usuario
Advantech
Advantech ACK-A001E Manual de usuario
Advantech
Advantech EPD-B101 Manual de usuario
Advantech
Advantech IPC-602 Manual de usuario
Advantech
Advantech IPC-623 Series Manual de usuario
Advantech
Advantech ACP-4340 Manual de usuario
Advantech
Advantech ACP-2010MB Manual de usuario
Advantech
Advantech AIMB-C200 Manual de usuario
Advantech
Advantech IPC-616 Manual de usuario
Advantech
Advantech IPC-7220 Manual de usuario
Advantech
Advantech HPC-7484 Manual de usuario
Advantech
Advantech HPC-7120S Manual de usuario
Advantech
Advantech HPC-7483 Manual de usuario
Advantech
Advantech IPC-603MB Manual de usuario
Advantech
Advantech IPC-613 Manual de usuario
Advantech
Advantech HPC-7400 Manual de usuario
Advantech
Advantech ACP-4010 Manual de usuario
Advantech
Advantech PCA-6108P6 Manual de instalación y operación
Advantech
Advantech RMD-1150 Manual de usuario
Advantech
Advantech HPC-7000 Manual de usuario
