Adaptec ASR-2045 Manual de funcionamiento
--------------------------------------------------------------------
README.TXT
Adaptec ASR-2045/ASR-2405 Unified Serial Controllers
as of March 31, 2008
--------------------------------------------------------------------
Please review this file for important information about issues
and errata that were discovered after completion of the standard
product documentation. In the case of conflict between various
parts of the documentation set, this file contains the most
current information.
NOTE: The latest firmware, BIOS, drivers and documentation can be
downloaded from www.adaptec.com when they become available.
The following information is available in this file:
1. Software and Documentation
1.1 Controller & Utility Software
1.2 Documentation on this CD
2. Installation Instructions
3. General Cautions
4. Known Limitations
4.1 ACU Utility
4.2 FreeBSD
4.3 OpenServer 6.0
4.4 Creating an Array from the Adaptec Storage Manager CD
4.5 Using the Controller with an Adaptec S50 JBOD Enclosure
4.6 UnixWare and OpenServer
4.7 Hot-adding Disk Drives
4.8 SuperMicro Disk Drive Enclosures
4.9 Using the Controller with the SuperMicro X7DBE Motherboard
4.10 Using the Controller with a Seagate Barracuda 1TB SATA Drive
4.11 Tape Drive Support (Non DASD-Devices)
--------------------------------------------------------------------
1. Software and Documentation
1.1. Controller & Utility Software
Note: The latest versions of firmware, BIOS and driver software
can be downloaded from www.adaptec.com when they become
available.
- BIOS
- ACU
- Windows Drivers
o Windows 2003 Server, Enterprise, Standard, and Web Edition
o Windows 2008 Server, Enterprise, and Standard
o Windows XP All versions
o Windows Vista - All versions
- Linux Drivers
o Red Hat Enterprise 4.0, IA-32 and x64
o Red Hat Enterprise 5.0, IA-32 and x64
o SuSE Linux Enterprise Server 9.0, IA-32 and x64
o SuSE Linux Enterprise Server 10.0, IA-32 and x64
- FreeBSD Drivers
o FreeBSD 6.1/6.2 (ARCCONF 32/64-bit)
- SCO Drivers
o OpenServer 6.0
o UnixWare 7.1.4
- VMware Drivers
o VMware ESX Server 3.0.1 and 3.0.2
- Sun Solaris Drivers
o Solaris 10 Update 1
1.2. Documentation on this CD
- Adaptec SAS RAID Controllers Installation and User's Guide
- Adaptec SAS RAID Controllers README.TXT file
--------------------------------------------------------------------
2. Installation Instructions
- The Adaptec SAS RAID Controllers Installation and User's Guide
contains complete installation information for the controllers
and drivers, as well as complete instructions for all
utilities. The Adaptec Storage Manager User's Guide
contains complete installation information for the Adaptec
Storage Manager software.
--------------------------------------------------------------------
3. General Cautions
- While an array is being built or cleared, DO NOT remove and
reinsert any drive from that array. Doing so may cause
unpredictable results for any of the controller's arrays.
- While a drive is being cleared, DO NOT try to include it in a
new array. Doing so may cause unpredictable results.
- DO NOT move drives containing an array or volume from one
controller to another while the power is on. Doing so could
cause the loss of the array configuration or data, or both.
Instead, power off both affected controllers, move the drives,
and then restart.
--------------------------------------------------------------------
4. Known Limitations
4.1 ACU Utility
o On some Intel and IBM systems, when you try to run the ACU
utility, this message appears:
"Not enough free memory to load the utility!
Press any key to attempt loading the utility forcibly
OR Wait for the system initialization to be completed
[Default]"
This is normal. On Intel systems, wait for the system
initialization to be completed. Then the ACU will run. On IBM
systems, press any key when prompted to load the utility
forcibly.
o The ACU erroneously displays deleted logical drives in the
JBOD list. The logical drive(s) continue to appear in the
JBOD list until you delete all of the JBODs.
o With some enclosures, the ACU displays incorrect box/slot
information for managed disk drives; for example,
Exp/Phy instead of Box/Slot.
4.2 FreeBSD
Storage management for FreeBSD must be done through the Adaptec
Configuration Utility (ACU) and ARCCONF command line utility. Refer
to the User Guides on the two CDs provided with your controller.
4.3 OpenServer 6.0
Arrays may not be displayed correctly, even after you restart
your computer.
To resolve the problem:
As root, run 'resmgr -r -m vtoc' until it fails. Then, as
root, run '/etc/conf/bin/idconfupdate -f'. Then, reboot.
4.4 Creating an Array from the Adaptec Storage Manager CD
When you create an array with the Adaptec Storage Manager
bootable CD, the maximum size of the array is 2 TB.
4.5 Using the Controller with an Adaptec S50 JBOD Enclosure
Temperature warnings from Adaptec S50 JBOD Enclosure (firmware
version T016) are not shown in Adaptec Storage Manager (or on
the enclosure).
4.6 UnixWare and OpenServer
Adding or moving controllers in an existing UnixWare or OpenServer
system may cause some device resources to change, which may lead
to the operating system being unable to boot. Currently, there
is no workaround available in the operating system. Before
installing the operating system, make sure all PCI devices are
either enabled or installed.
4.7 Hot-adding Disk Drives
If you hot-add multiple disks simultaneously to a large
configuration (100 disk drives or more), it may take an extended
amount of time before those disk drives appear in Adaptec Storage
Manager.
With Intel Backplanes AXX4DRV3GEXP and AXX6DRV3GEXP, if a drive bay
is empty at enclosure power on and then a SATA disk drive is
hot-added into the empty bay, the controller does not detect
the new disk drive. To work around this issue, remove and reinsert
the SATA disk.
4.8 SuperMicro Disk Drive Enclosures
If the controller does not detect disk drives installed in a
SuperMicro M28E2 Mobile Rack, use backplane SAS connectors
marked with "SAS In" only.
4.9 Using the Controller with a SuperMicro X7DBE Motherboard
The ASR-2405 and ASR-2045 do not support the SuperMicro X7DBE
motherboard. Adaptec recommends using the SuperMicro X7DBE+.
4.10 Using the Controller with a Seagate Barracuda 1TB SATA Drive
To ensure reliability when using the ASR-2405 or ASR-2045 with
a Seagate Barracuda ES.2 1TB SATA Drive (ST31000340NS), Adaptec
recommends using Seagate firmware version SN05 or higher.
4.11 Tape Drive Support (Non-DASD Devices)
o Tape drives are supported on the ASR-2405 and ASR-2045
controllers, except as noted below.
o The Sony SDX-570V tape drive is not supported under Red Hat
Enterprise Linux 5.
--------------------------------------------------------------------
(c) 2008 Adaptec, Inc. All Rights Reserved.
This software contains the valuable trade secrets of Adaptec or its
licensors. The software is protected under international copyright
laws and treaties. This software may only be used in accordance with
the terms of its accompanying license agreement.
No part of this publication may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without prior
written consent of Adaptec, Inc., 691 South Milpitas Blvd.,
Milpitas, CA 95035.
Otros manuales para ASR-2045
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Controladores de Adaptec
Adaptec
Adaptec ICP 5045BL Manual de instrucciones
Adaptec
Adaptec 1420SA - Serial ATA II RAID Controller Manual de usuario
Adaptec
Adaptec ACB-2071 Manual de usuario
Adaptec
Adaptec 1405 Manual de usuario
Adaptec
Adaptec ACB-2072A Manual de usuario
Adaptec
Adaptec 2074700-R - ICP Vortex GDT8514RZ RAID... Manual de usuario
Adaptec
Adaptec ASR-3085 Manual de funcionamiento
Adaptec
Adaptec GDT8546RZ - ICP Vortex RAID Controller Manual de usuario
Adaptec
Adaptec 3405 Manual de usuario
Adaptec
Adaptec AEC-4412B Manual de usuario
Adaptec
Adaptec AAR-2420SA Hoja de instrucciones
Adaptec
Adaptec 44300 Manual de usuario
Adaptec
Adaptec ACB-2320B Manual de usuario
Adaptec
Adaptec 9803 Guía del usuario
Adaptec
Adaptec 5805 Manual de usuario
Adaptec
Adaptec RAID 5805Z Manual de usuario
Adaptec
Adaptec ASR-2045 Manual de funcionamiento
Adaptec
Adaptec ASR-5085 Manual
Adaptec
Adaptec ICP 5045BL Cómo utilizar
Adaptec
Adaptec ACB-2322B Manual de usuario
