ACME LED-PS10 Manual de usuario

10W LED PINSPOT

LED-PS10

User Manual

Professional Entertainment Technology

TABLE OF CONTENTS

1. Safety Instruction

2. Technical Specification

3. Installation

4. Control Panel

5. Trouble Shooting

6. Fixture Cleaning

1. Safety Instruction

WARNING

Please keep this User Manual for future consultation. If you sell the unit to another user,

be sure that they also receive this instruction booklet.

Unpack and check carefully there is no transportation damage before using the unit.

Before operating, ensure that the voltage and frequency of power supply match the

power requirements of the unit.

It’s important to ground the yellow/green conductor to earth in order to avoid electric

shock.

The unit is for indoor use only and use only in a dry location.

The unit must be installed in a location with adequate ventilation, at least 50cm from

adjacent surfaces. Be sure that no ventilation slots are blocked.

Disconnect mains power before fuse replacement or servicing.

Replace fuse only with the same type.

Make sure there are not flammable materials close to the unit while operating as it is fire

hazard.

Use safety cable when fixes this unit.

Maximum ambient temperature is TA: 40℃and don’t operate it where the temperature

is higher than this.

Unit surface temperature may reach up to 60℃. Don’t touch the housing bare-hand

during its operation.

There are no user serviceable parts inside the fixture. Do not open the housing or

attempt any repairs by yourself. In the unlikely event your fixture may require service,

please contact the nearest authorized technical assistance center and always use the

same type spare parts. .

Don’t connect the device to any dimmer pack or power pack.

Do not look directly at the LED light beam while the fixture is on.

The housing must be replaced if they are visibly damaged.

Do not touch any wire during operation as high voltage might be causing electric shock.

Please read the instruction carefully which including important

information about the installation, operation and maintenance.

2. Technical Specification

Innovative design with powerful beam, it is ideal for replacing the traditional halogen pin

spot. Not heat, whiter and brighter;

Different beam angles for different applications, 9°for Mirror Ball and 13°for big mirror

ball or as a table light;

Low power consumption, no duty cycle, runs all night

Ideal for clubs, bars, discos, parties, mobile DJs, etc..

Voltage: AC 120-240V~50/60Hz

LED: 1 x 10W White LED

Power Consumption: 8.2 W

Dimension: 118 x 136 x 92 mm

Weight: 1 kg

3. Installation

The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is

firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure

to which you are attaching the unit is secure and is able to support a weight of 10 times of

the unit’s weight. Also always use a safety cable that can hold 12 times of the weight of the

unit when installing the fixture.

The equipment must be fixed by professionals. And it must be fixed at a place where is out

of the touch of people and has no one pass by or under it.

4. Control Panel

○

1Mains input: Connect to power supply.

○

2 Fuse: Protect the unit from damage of current.

○

3 Hanging bracket: Fix mounting hook.

○

4Heat sink for the LED: do not cover this part to ensure proper cooling.

○

5Optical lens: Turn the lens to change the focus and obtain sharp gobos.

5. Troubleshooting

Following are a few common problems that may occur during operation. Here are some

suggestions for easy troubleshooting:

A. The fixture does not work, no light

1. Check the connection of power and main fuse.

2. Measure the mains voltage on the main connector.

B. No response to the sound

1. Make sure the fixture does not receive DMX signal.

2. Check microphone to see if it is good by tapping the microphone.

6. Fixture Cleaning

The cleaning of internal and external optical lenses and/or mirrors must be carried out

periodically to optimize light output. Cleaning frequency depends on the environment in

which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater

accumulation of dirt on the unit’s optics.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every 20 days. Clean the internal optics at least every

30/60 days.

Innovation, Quality, Performance

Tabla de contenidos

Otros manuales de Equipo de iluminación de ACME

ACME

ACME BIG BANG Manual de usuario

ACME

ACME CHIRON Manual de usuario

ACME

ACME STAGE PAR 400 ZOOM IP Manual de usuario

ACME

ACME FLANDINA 22 IP Manual de usuario

ACME

ACME Pageant CM-200Z Manual de usuario

ACME

ACME Spider FC Manual de usuario

ACME

ACME LED-PS10 Manual de usuario

ACME

ACME Stag Par MP-200 Manual de usuario

ACME

ACME Building wash Manual de usuario

ACME

ACME Xperior 1500SZ Manual de usuario

ACME

ACME SAMURAI SCAN 50 Manual de usuario

ACME

ACME ENERGY SPOT XA-400 SPOT Manual de usuario

ACME

ACME DELUGE LED-WAV-50W Manual de usuario

ACME

ACME Libre Manual de usuario

ACME

ACME XP-5000SZ F Manual de usuario

ACME

ACME STORM Manual de usuario

ACME

ACME TRACK 10 Manual de usuario

ACME

ACME LED-212RGB Manual de usuario

ACME

ACME Theatre Spot 150 Manual de usuario

ACME

ACME ASTRO LED-256D Manual de usuario

ACME

ACME BTDG40 Manual de usuario

ACME

ACME Gemini Manual de usuario

ACME

ACME Solaris Manual de usuario

ACME

ACME LED-0408 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario