ABB C13 Manual de usuario

C13

INSTALLATION MANUAL

Contents

Disclaimer ......................................................................................... 2

Trademark......................................................................................... 2

Introduction ....................................................................................... 3

Product Overview.............................................................................. 3

Installation ......................................................................................... 6

Installation Requirements.................................................................. 7

Troubleshooting ................................................................................ 7

Service and Maintenance.................................................................. 8

C13_install.book Page 1 Thursday, May 30, 2013 4:36 PM

Disclaimer

The information in this document is subject to change without notice

and should not be construed as a commitment by ABB AB. ABB AB as-

sumes no responsibility for any errors that may appear in this docu-

ment.

In no event shall ABB AB be liable for direct, indirect, special, incidental

or consequential damages of any nature or kind arising from the use of

this document, nor shall ABB AB be liable for incidental or consequen-

tial damages arising from use of any software or hardware described in

this document.

This document and parts thereof must not be reproduced or copied

without written permission from ABB AB, and the contents thereof must

not be imparted to a third party nor used for any unauthorized purpose.

The software or hardware described in this document is furnished un-

der a license and may be used, copied, or disclosed only in accordance

with the terms of such license.

Trademark

ABB AB is a registered trademark of the ABB Group. All other brand or

product names mentioned in this document may be trademarks or reg-

istered trademarks of their respective holders.

C13_install.book Page 2 Thursday, May 30, 2013 4:36 PM

EN EN

Introduction

The C13 meter is a direct connected electricity meter for DIN-rail

mounting in distribution boards or small enclosures.

Read the information in this manual carefully before you install the

equipment.

Product Overview

Part Description

1 Terminal for output connections

C13_install.book Page 3 Thursday, May 30, 2013 4:36 PM

2 Sealing points

3 Push button for programing and reading the meter. For

detailed information, refer to the C11 User Manual.

4 LED, flashes in proportion to the energy measured

5 Display

6 Sealing label

7 Sealable terminal cover

8 Terminal block

Technical Data

Voltage

Voltage range 3 x 220-240/380-415 V (-20% to +15%)

Terminal wire area

Tightening torque

0.5 - 10 mm²

0.8 Nm

Current

- base Ib

- reference Iref

- maximum Imax

- minimum Imin

5 A

40 A

0.25 A

Part Description

C13_install.book Page 4 Thursday, May 30, 2013 4:36 PM

EN EN

Frequency 50 or 60 Hz ± 5%

Accuracy 1% (Cl.1, Cl. B)

Material Polycarbonate in transparent front glass.

Glass reinforced polycarbonate in bottom

case and upper case. Polycarbonate in ter-

minal cover.

Operating temp. -25 °C to +70 °C

Storage temp. -25 °C to +85 °C

Humidity 75% yearly average, 95% on 30 days/year

Resistance to heat Terminal 960°C, cover 650°C (IEC 60695-

2-1)

Outputs

Current 2 - 100 mA

Voltage 5 - 40 VDC

Pulse frequency 100 imp/kWh

Pulse length 200 ms

Terminal wire area 0.5-6 mm²

Tightening torque 0.8 Nm

Pulse indicator(LED)

Technical Data

C13_install.book Page 5 Thursday, May 30, 2013 4:36 PM

Installation

For information about how to mount and install the equipment, follow

the instructions in the Installation Guide at the end of this manual.

E Warning – Working with high voltage is potentially lethal. Per-

sons subjected to high voltage may suffer cardiac arrest, burn

Pulse frequency 1000 imp/kWh

Pulse length 40 ms

EMC compatibility

Impulse voltage test 6 kV 1.2/50μs (IEC 60060-1)

Surge voltage test 4 kV 1.2/50μs (IEC 61000-4-5)

Fast trans. burst test 4 kV ( IEC 61000-4-4 )

Immunity HF-fields 80 MHz - 2 GHz at 10 V/m (IEC61000-4-3)

Immunity conducted 150kHz – 80MHz ( IEC 61000-4-6 )

RF Emission EN 55022, class B (CISPR22)

ESD 15 kV ( IEC 61000-4-2 )

Standards IEC 62052-11, IEC 62053-21 class 1, GB/T

17215.211-2006, GB/T 17215.321-2008

class 1 & 2, GB 4208-2008, EN 50470-1,

EN 50470-3 category B

Technical Data

C13_install.book Page 6 Thursday, May 30, 2013 4:36 PM

EN EN

injuries, or other severe injuries. To avoid such injuries, make

sure to disconnect the power supply before you start the instal-

lation.

Electrical equipment should only be installed, accessed, ser-

viced and maintained by qualified electrical personnel.

E Warning – For safety reasons it is recommended that the

equipment is installed in a way that makes it impossible to

reach or touch the terminal blocks by accident.

The best way to make a safe installation is to install the unit in

an enclosure. Further, access to the equipment should be lim-

ited through use of lock and key, controlled by qualified electri-

cal personnel.

W Warning – The meters must always be protected by fuses on

the incoming side.

Do not operate the equipment outside the specified technical

data.

Installation Requirements

To comply with the protection requirements the meter must be

mounted in protection class IP 51 enclosures, or better, according to

IEC 60259.

Meters with wireless communication should not be installed closer

than 20 cm from people.

Troubleshooting

If the Wicon appear in the display after the installation has been com-

pleted and power has been connected to the meter, refer to the C13

User Manual for detailed information.

C13_install.book Page 7 Thursday, May 30, 2013 4:36 PM

Service and Maintenance

The meter contains no parts that can be repaired or exchanged. A bro-

ken meter must be replaced.

If the meter needs to be cleaned, use a lightly moistened cloth and a

mild detergent to wipe it.

C Caution – Be careful that no liquid gets into the meter since it

may damage the equipment.

C13_install.book Page 8 Thursday, May 30, 2013 4:36 PM

C13

INSTALLATIONSMANUAL

Contents

Friskrivning........................................................................................ 2

Varumärke......................................................................................... 2

Introduktion ....................................................................................... 3

Produktöversikt ................................................................................. 3

Installation ......................................................................................... 7

Installationskrav ................................................................................ 7

Felsökning......................................................................................... 8

Service och underhåll........................................................................ 8

C13_install.book Page 1 Thursday, May 30, 2013 4:36 PM

Friskrivning

Informationen i detta dokument är föremål för ändringar utan föregå-

ende meddelande och ska inte betraktas som ett åtagande från ABB

AB. ABB AB tar inte något ansvar för fel som kan uppträda i detta doku-

ment.

I inget fall ska ABB AB vara ansvarig för direkta, indirekta, speciella,

oförutsedda eller följdskador av något slag eller typ som uppkommer

vid användning av detta dokument, ej heller ska ABB AB vara ansvarig

för oförutsedda eller följdskador som uppkommer vid användning av

mjukvara eller hårdvara som beskrivs i detta dokument.

Detta dokument och delar därav får inte reproduceras eller kopieras

utan skriftligt tillstånd från ABB AB, och innehållet däri får inte vidare-

befordras till tredje part eller användas för något icke godkänt syfte.

Den mjukvara eller hårdvara som beskrivs i detta dokument tillhanda-

hålls under licens och får endast användas, kopieras eller röjas i enlig-

het med villkoren i licensen.

Varumärke

ABB AB är ett registrerat varumärke tillhörande ABB-koncernen. Alla

övriga märkes- eller produktnamn som nämns i detta dokument kan

vara varumärken eller registrerade varumärken som tillhör respektive

innehavare.

C13_install.book Page 2 Thursday, May 30, 2013 4:36 PM

Otros manuales para C13

Tabla de contenidos

Idiomas:

Otros manuales de Instrumento de medición de ABB

ABB

ABB 4630 Manual de usuario

ABB

ABB NGC8206 Manual de usuario

ABB

ABB PFEA 113 Manual de usuario

ABB

ABB aquamaster Manual de usuario

ABB

ABB ReliaGear ASPMETER A 42 Manual de instalación y operación

ABB

ABB AnalyzeIT AX460 Manual de usuario

ABB

ABB LGR-ICOS GLA531 Series Manual de usuario

ABB

ABB COPA-XM 3000 Series Manual de usuario

ABB

ABB EL6010 Manual de usuario

ABB

ABB Relion 670 series Guía de inicio rápido

ABB

ABB Sensyflow iG Manual de usuario

ABB

ABB ADS420 Manual de usuario

ABB

ABB B23 Manual de usuario

ABB

ABB MagMaster Manual de usuario

ABB

ABB MACHsense-R Manual de usuario

ABB

ABB NGC Series Manual de usuario

ABB

ABB CoreSense M10 Manual de usuario

ABB

ABB 8002 Manual de usuario

ABB

ABB Sensyflow FMT200-D Manual de usuario

ABB

ABB ISL-C 600 Manual de usuario

ABB

ABB FieldIT AquaMaster Manual de usuario

ABB

ABB AquaProbe 2 Manual de usuario

ABB

ABB SCC-U Manual de usuario

ABB

ABB AX416 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario