ABB SREA-01 Guía de solución de problemas

ABB Drives

Quick Start-up Guide

SREA-01 Ethernet Adapter Module

3AUA0000042902 Rev A

Effective: 01.10.2008

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

1. Connecting power and network

Connect 9–28 V AC/DC to Vin+ and Vin-.

Connect a cross-over Ethernet cable directly to the unit for start-

up. You can use a network after you have configured the unit.

2. Connecting to SREA-01 over Ethernet

The default Ethernet configuration is:

IP address: 10.200.1.1

Subnet mask: 255.255.255.0

Username: admin

Password: admin

Connection method 1:

Configure your PC to the same subnet (e.g. IP address 10.200.1.2

and subnet mask 255.255.255.0).

Use Internet Explorer or Mozilla Firefox and go to location

http://10.200.1.1.

Connection method 2:

Install the ABB IP Configuration Tool from the attached CD. When

you start the program, it will search for connected SREA-01

modules. You can change the network settings of the module by

double clicking it.

Use Internet Explorer or Mozilla Firefox and go to location

http://<ip of the SREA-01 module>, e.g. http://10.200.1.1.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

3. Connecting drive(s)

If you have a single ACS350, ACH550 or ACS550, it is easiest to

use the supplied RJ45 cable to connect to the panel port.

If you have multiple drives or an ACS800, use the RS-485

connection. Connect the A- channels of the SREA-01 unit and the

drives together, the B+ channels together and the COM connector

to the data ground connectors of the drives. Use 120 ohm

terminating resistors in the network.

4. Basic drive settings

Check the communication settings of the drive (either group 52 or

53 in most drives, depending on the connection type).

Station id/number has to be unique for each drive! The baud rate

selection and parity have to be same on all drives and

SREA-01. You can use for example 9600 bit/s, no parity, 1 stop bit.

5. Basic SREA-01 settings

You can change the Ethernet settings under Setup – Ethernet.

Select the correct drive connection settings under Setup –

Modbus.

• Select Physical Interface.

• Usually most other settings are suitable by default (RTU,

9600 bps, no parity, 1 stop bit).

SREA-01

X1 pin Wire

Panel port

RJ45 pin

RX (RS-232) white-orange 1

TX (RS-232) white-blue 3

COM orange and blue 2 and 6

X1 RS-232: Select EIA-232

X1 RS-485: Select EIA-485

X2: Select EIA-232 D-sub

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

To search for connected drives, go to page Configuration –

Devices and select autodetect.

6. More information

For more detailed information, please refer to the SREA-01 User’s

Manual located on the attached CD-ROM.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

Otros manuales para SREA-01

Tabla de contenidos

Otros manuales de Unidad de control de ABB

ABB

ABB ACS880-04 drive modules Manual de usuario

ABB

ABB NCSA-01 CS 31 Manual de instalación

ABB

ABB REC650 ANSI Guía de inicio rápido

ABB

ABB ACS880-04F Manual de usuario

ABB

ABB CMS-660 Manual de usuario

ABB

ABB REF 542plus Manual de usuario

ABB

ABB TruONE Ekip Manual de usuario

ABB

ABB REC650 ANSI Instrucciones de uso

ABB

ABB SafeRing Manual de usuario

ABB

ABB Relion 615 series Manual de usuario

ABB

ABB ACS880-14 Manual de usuario

ABB

ABB Relion 615 series Manual de instalación y operación

ABB

ABB Relion 615 series Manual de usuario

ABB

ABB Relion 670 series Guía de inicio rápido

ABB

ABB 615 Series ANSI Manual de usuario

ABB

ABB ACH550 series Manual de usuario

ABB

ABB TCC300 Manual de usuario

ABB

ABB LD 800HSE Manual de usuario

ABB

ABB FPTC-01 Manual de usuario

ABB

ABB SCU200 Manual de usuario

ABB

ABB NPBA-01 Manual de instalación

ABB

ABB COM600 series Manual de usuario

ABB

ABB COM600 series Manual de usuario

ABB

ABB RED615 ANSI Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario