N1 Installation Guide
7
Via the configuration interface, the admin can make all the system configurations,
including network settings (LAN, WAN, Firewall, VPN, DDNS, VLAN, etc.); system
parameters configuration (time zone, password, etc.); internal settings (Web access
port, etc.); expansion units; call logs (search, download); firmware update and reset,
etc.
Note: after saving the changes, remember to click the “Apply changes” button to
make the changes take effect.
4.3 Network Settings
After logging in the admin configuration interface, generally the first step is to
configure the IP address. If the LAN ports are connected to the network, their IP
addresses need to be configured. If not, just configuring the IP address of the LAN
port which is connected to the local area network of the company is OK.
To change N1’s IP address:
Click “Network Preferences”→“LAN Settings” on the left menu bar of the web
configuration interface. If the LAN port is connected to the company’s LAN, please
configure the correct IP address and corresponding subnet mask.
Note: please note that after changing the IP address of LAN port, N1 should be
rebooted to make the new changes to take effect.
4.4 Make and Receive Calls
To make and receive internal and external calls, please refer to Yeastar N1
Administrator Guide for details.
[END]
