Yealink VCM34 Manual de usuario
Connecting to Audio Input Devices
Introduction
You can take Yealink microphone devices (VCM34/VCM38/CPW90) as the audio input devices for
MeetingBar AX0.
Before You Begin
Yealink microphone devicesneed to be purchased separately.
CTP18 is paired with MeetingBarAX0.
MeetingBarAX0 does not support the use of different microphonedevices at a time.
When your audio input device is selected as an external microphone, the built-in microphone will
be automatically disabled.
Supported Microphones & Maximum Number of Cascades
Microphone A20 maximum number
of cascades
A30 maximum
number
of cascades
VCM34 2 3
VCM38 2 3
CPW90 2 2
Connecting and Pairing
VCM34:
1.Do one of the following to connect the VCM34 to MeetingBarAX0.
lConnect the VCM34 to the VC Hub/Phone port on theMeetingBarAX0 using a network cable:
Connecting to Audio Input Devices
lIf AX0 needs to connect multiple VCM34 and VCH51 at the same time, it needs to use a PoE
switch, as shown in the following figure:
Connecting to Audio Input Devices
Note: VCM34 can support cascading. Please refer to the table above for the maximum number
of cascades when connected to MeetingBarAX0.
VCM38:
1.Do one of the following to connect the VCM38 to MeetingBarAX0.
lConnect the VCM38 to the VC Hub/Phone port on the MeetingBarAX0 using a network cable:
Connecting to Audio Input Devices
lIf AX0 needs to connect multiple VCM38 or VCH51 at the same time, it needs to use a PoE
switch, as shown in the following figure:
Connecting to Audio Input Devices
CPW90:
1. Insert the DD10 into the USB port on the left side of the MeetingBarAX0. The MeetingBarAX0
display interface or CTP18 prompts "Wireless microphone is connected".
2. On the CTP18, tapSettings > General > System Settings > User Settings > Wireless
Microphone > New Mic-Wireless.
Connecting to Audio Input Devices
3. Place the CPW90 on the charging base, press and hold the Mute button for 5 seconds, the Mute
button LED flashes orange quickly, and it enters the pairing state.
The pairing is successful when the CTP18 interface displays the wireless microphone information.
Setting Audio Input Device
1.On the CTP18, tapSettings > General > System Settings > Audio Settings > Audio Input
Device, and choose the appropriate audio device.
Connecting to Audio Input Devices
Connecting to Audio Input Devices
Este manual sirve para los siguientes modelos
2
Otros manuales de Micrófono de Yealink
Yealink
Yealink CPW90 Manual de usuario
Yealink
Yealink CPW90 Manual de usuario
Yealink
Yealink CPW90-BT Manual de usuario
Yealink
Yealink VCM35 Manual de usuario
Yealink
Yealink CPW65-DECT Manual de usuario
Yealink
Yealink CPW90 Manual de usuario
Yealink
Yealink CPW65 Manual de usuario
Yealink
Yealink CPW90 Manual de usuario
Yealink
Yealink CPW90-BT Manual de usuario
Yealink
Yealink VCM60 Manual de usuario
