Yamaha NS-E120 Manual de usuario

NS-E120 Natural Sound Bass-Reflex

Type Effect Speaker System

Thank you for selecting this Yamaha NS-E120

speaker system.

This model is designed mainly to be used as an effect

speaker system.

PRECAUTIONS

Read these precautions carefully before operating

your speakers.

• When using an amplifier with a rated output power

higher than the music input of the speakers, care

should be taken never to exceed the speakers’

music input.

• Do not attempt to clean the speakers with chemical

solvents as this might damage the finish. To clean,

wipe with a dry, soft cloth.

• To prevent the enclosure from warping or

discoloring, do not place the speakers where they

will be exposed to direct sunlight or excessive

humidity.

• Do not place the speakers where they are liable to

be knocked over or struck by falling objects. Stable

placement will also ensure better sound

performance.

• Placing the speakers on the same shelf or rack as

the turntable can result in feedback.

• As these speakers contain strong magnets, avoid

placing watches, magnetic tapes, etc. near them.

Also, placing the speakers near a TV set may

impair picture color. If this happens, move the TV

set away from the speakers.

• Secure installing is the owner’s responsibility.

YAMAHA shall not be liable to any accident caused

by a failure in installing at a proper position and by

proper installation procedure.

CONNECTION TO

YOUR AMPLIFIER

BEFORE MAKING CONNECTIONS, MAKE SURE

THAT THE AMPLIFIER IS SWITCHED OFF.

mCONNECTIONS

• Connect the push-type input terminals at the rear of

the speakers to the speaker output terminals of your

amplifier with the supplied speaker cables.

• One side of the speaker cable is marked by a white

line. Connect the (+) terminals on both the amplifier

and the speakers using this white-marked side.

Connect the (–) terminals on both components

using the unmarked side of the cable.

• Connect the left speaker to the left (marked L)

terminals of your amplifier, and the right speaker to

the right (marked R) terminals, making sure not to

reverse the polarity (+, –). If one speaker is

connected with reversed polarity, the sound will be

unnatural and lack bass.

Procedures:

1Press the tab on the terminal down, as shown in

the figure.

2Insert the bare wire end properly into the terminal.

3Remove your finger from the tab to allow it to lock

snugly on the cable’s wire end.

4Test the security of the connection by tugging

lightly on the cable at the terminal.

Press tab

White line

Speaker output

terminals of the

amplifier

White line White line

Right speaker Left speaker

SETTING UP THE SPEAKERS

mAttaching the speakers to a wall

The speakers may be attached to a wall by using

the hooks provided on the speakers’ back panels.

Fasten wood screws into a firm wall or wall support

as shown in the diagram, and hang the speaker

hooks on the protruding screws.

WARNING:

* Each speaker weighs 1.8 kg (4 lbs.). Do not attach

them to thin plywoods or soft wall surface materials,

as the screws may tear free from flimsy surfaces,

causing the speakers to fall and be damaged, or

result in personal injury.

* Do not fasten the speakers to walls with nails,

adhesives, or other unsound hardware. Long-term

use and vibrations may cause them to pull free.

* To avoid accidents resulting from tripping over loose

speaker cables, fix these to the wall along with the

speakers.

NOTE:

The speakers can be hung on a wall in one of two

different configurations: vertically or horizontally.

The speaker hooks have been arranged so that the

speakers may be mounted in either of the two

configurations shown by the following figures.

Upright configuration

Side long configuration

mSetting the speakers on a shelf or rack

As shown in the figure, the speakers may be stood

in an upright or side-long configuration on either

shelves or racks, by attaching one of the supplied

stands to the back of each speaker.

SPECIFICATIONS

Type ......................................2-Way Bass-Reflex type

Speaker Unit ........12 cm paper cone woofer (JA1280)

2.5 cm semi-dome tweeter (JA05R8)

Crossover ..........................................6 kHz (6 dB/oct)

Input Terminal .............................................Push-type

Nominal Impedance .........................................6 ohms

Frequency Response ..........................70 Hz – 20 kHz

Nominal Input Power ............................................50W

Music Input Power ..............................................100W

Sensitivity ...................................................91 dB/Wzm

Dimensions (WxHxD)

.........................................220 mm x 297 mm x 89 mm

(8-5/8”x11-11/16”x3-1/2”)

Weight ....................................................1.8 kg (4 lbs.)

Accessories ..................2 speaker cables (10m each),

2 stands

* Specifications subject to change without notice due

to product improvements.

VP15950-0 BWWR,W Printed in Japan

Tapping

screw

(Available at the

market)

Wall/

wall support

∅4–5 mm

MIN.

12 mm

4 mm

100mm

80mm

Ex.) When setting

the speaker

upright

Tabla de contenidos

Otros manuales de Sistema de altavoces de Yamaha

Yamaha

Yamaha NS-333 Manual de usuario

Yamaha

Yamaha YAS-101 Manual de usuario

Yamaha

Yamaha NS-333 Manual de usuario

Yamaha

Yamaha NS-P20 Manual de usuario

Yamaha

Yamaha SR-B20A Manual de usuario

Yamaha

Yamaha ATS-930 Manual de usuario

Yamaha

Yamaha YHT-31 Instrucciones de montaje

Yamaha

Yamaha NS-10MMTS Manual de usuario

Yamaha

Yamaha YHT-440 Instrucciones de montaje

Yamaha

Yamaha MCX-SP10 - Left / Right CH Speakers Manual de usuario

Yamaha

Yamaha NS-9900 Manual de usuario

Yamaha

Yamaha S15 Manual de usuario

Yamaha

Yamaha IF2115/64 Manual de usuario

Yamaha

Yamaha NS-4HX Manual de usuario

Yamaha

Yamaha YHT-540 Instrucciones de montaje

Yamaha

Yamaha S112V Manual de usuario

Yamaha

Yamaha NS-C8800 Manual de usuario

Yamaha

Yamaha CinemaStation NX-P150 Manual de usuario

Yamaha

Yamaha YHT-24 Instrucciones de montaje

Yamaha

Yamaha NS-C300 Manual de usuario

Yamaha

Yamaha S0112T Manual de usuario

Yamaha

Yamaha NS-P40 Manual de usuario

Yamaha

Yamaha YAS-207 Manual de usuario

Yamaha

Yamaha NS-C225 - Center CH Speaker Manual de usuario

Manuales populares de Sistema de altavoces de otras marcas

JVC

JVC CA-MXK5R Manual de usuario

LG NB4532B Manual de usuario

JVC

JVC CA-FSH100 Manual de usuario

5Core

5Core Pro Series Manual de usuario

EAW

EAW MQV1394e Manual de usuario

Lynx

Lynx GXR-LA10A Manual de usuario

iLive

iLive ITB066B Manual de usuario

RDX

RDX QuickStation 4 Manual de usuario

Electro-Voice

Electro-Voice S-122 Manual de usuario

Sven

Sven SPS-619 GOLD Manual de usuario

Pioneer

Pioneer CS-7070 Manual de usuario

EAW

EAW UB82e Manual de usuario

Sondpex

Sondpex Active Speaker System and Digital Music... Manual de usuario

JVC

JVC NX-PN7 Manual de usuario

Marshall Amplification

Marshall Amplification AR-DM61-BT Manual de usuario

SE Audiotechnik

SE Audiotechnik I-LINE Manual de usuario

Gemini

Gemini WRX-843 Series Manual de usuario

TCL

TCL 6100 Series Manual de usuario