Yamaha NS-C55 Manual de usuario
PRECAUTIONS
This model is designed to be used as a center speak-
er system.
Read these precautions carefully before using your speak-
er.
●Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speaker may be damaged.
●When using an amplifier with a rated output power high-
er than the nominal input power of the speaker, care
should be taken never to exceed the speaker’s maximum
input.
●Do not attempt to clean the speaker with chemical sol-
vents as this might damage the finish.To clean, wipe
with a dry, soft cloth.
●To prevent the enclosure from warping or discoloring, do
not place the speaker where it will be exposed to direct
sunlight or excessive humidity.
●Do not place the speaker where it is liable to be knocked
over or struck by falling objects. Stable placement will
also ensure better sound performance.
●Placing the speaker on the same shelf or rack as the
turntable can result in feedback.
●Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of the speaker.
Place the speaker on top of the TV or on the floor under
the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided velcro strips at
two points on both bottom of the speaker and top of the
TV.
Notes
●Do not place the speaker on top of the TV whose
area is smaller than the bottom area of the speaker.
If placed, the speaker may drop out causing an
injury to you.
●Though this speaker is a magnetic shielding type,
there may be some influence on aTV picture
depending on the type of TV or the placement of the
speaker. In such a case, place the speaker apart
from theTV so that there is no influence on TV pic-
ture.
NS-P60
“NS-P60” is the package number which includes the YAMAHA speaker system NS-C55 and NS-E55.
Thank you for selecting this Yamaha NS-P60 speaker system.
NS-C55 Natural Sound Center Speaker System
PLACING THE SPEAKER
12
Velcro
strip
TV set
Screen
HOME CINEMA CENTER
& EFFECT SPEAKERS
G R
BEFORE MAKING CONNECTIONS, MAKE SURE THAT
THE AMPLIFIER IS SWITCHED OFF.
■CONNECTIONS
●Connect the screw-type input terminals at the rear of the
speaker to the speaker output terminals of your amplifier
with the provided speaker cords.
●One side of the speaker cord is red and the other side is
black. Connect the (+) terminals on both the amplifier
and the speaker using this red side. Connect the (–) ter-
minals on both components using the black side of the
cord.
●Be careful not to reverse the polarity (+, –). If connected
with reversed polarity, the sound will be unnatural and
lack bass.
Procedures:
➀Loosen the terminal knob.
➁Insert the bare speaker wire end properly into the ter-
minal hole. [Remove approx. 10 mm (3/8”) insulation
from the speaker cord.]
➂Tighten the knob.
➃Test the security of the connection by pulling lightly the
cord at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or
the amplifier, or both of them.
SPECIFICATIONS
Type..........................2-way 3-speaker acoustic-suspension
speaker system
Magnetic-shielding type
Speaker Unit....................................10 cm cone woofer x 2
2.2 cm dome tweeter
Input Terminal.....................................................Screw-type
Impedance .................................................................6 ohm
Frequency Response..................................70 Hz – 30 kHz
Nominal Input Power.....................................................60W
Maximum Input Power................................................180W
Sensitivity (2.83V, 1m)................................................91 dB
Crossover Frequency..................................................5 kHz
Dimensions (WxHxD).......................465 x 135 x 173.5 mm
(18-5/16” x 5-5/16” x 6-7/8”)
Weight .................................................3.5 kg (7 lbs. 12 oz.)
Accessories......................................Speaker cord (4m) x 1
Velcro strip x 2
* Specifications subject to change without notice due to
product improvements.
* Care should be taken not to exceed the input power val-
ues noted above.
CONNECTION TO YOUR AMPLIFIER
Center speaker
output terminals
of the amplifier
NS-C55
Tighten
Red (+)
Black (–)
Red
Loosen
Amplifier
V415010
PRECAUTIONS
This model is designed to be used as an effect speak-
er system.
Read these precautions carefully before using your speak-
ers.
●Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speakers may be damaged.
●When using an amplifier with a rated output power high-
er than the nominal input power of the speakers, care
should be taken never to exceed the speakers’ maximum
input.
●Do not attempt to clean the speakers with chemical sol-
vents as this might damage the finish.To clean, wipe
with a dry, soft cloth.
●To prevent the enclosure from warping or discoloring, do
not place the speakers where they will be exposed to
direct sunlight or excessive humidity.
●Do not place the speakers where they are liable to be
knocked over or struck by falling objects. Stable place-
ment will also ensure better sound performance.
●Placing the speakers on the same shelf or rack as the
turntable can result in feedback.
●As these speakers contain strong magnets, avoid plac-
ing watches, magnetic tapes, etc. near them. Also, plac-
ing the speakers near a TV set may impair picture color.
If this happens, move the TV set away from the speak-
ers.
●Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of the speak-
ers.
■Mounting the speakers on a wall
The speakers can be mounted on a wall by using the
holes provided on the speakers’ back panels.
Make sure that the screws are caught by a narrow part of
the holes securely.
Put the screws into a wall according to the figure shown
below.
Fasten screws into a firm wall or wall support as shown in
the figure below, and hang the holes on the protruding
screws.
WARNING
●Each speaker weights 2.2 kg (4 lbs. 13 oz.). Do not
mount them on thin plywood or soft wall surface materi-
al, as the screws may come out of the flimsy surface,
causing the speakers to fall down and be damaged, or
result in personal injury.
●Do not fasten the speakers to wall with nails, adhesives,
or other unsound hardware. Long term use and vibra-
tions may cause them to fall down.
●To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
NS-E55 Natural Sound Effect Speaker System
SETTING UP THE SPEAKERS
Pads
Holes
Diam. 4 – 5 mm
40 mm
Min.
12mm
2mm
Tapping screw
(Available at a
hardware store)
Wall or
wall support
BEFORE MAKING CONNECTIONS, MAKE SURE THAT
THE AMPLIFIER IS SWITCHED OFF.
■CONNECTIONS
●Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of your amplifi-
er with the provided speaker cords.
●One side of the speaker cord has a gray line. Connect
the (+) terminals on both the amplifier and the speakers
using the side of the cord with the gray line. Connect the
(–) terminals on both components using the side without
a gray line.
●Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity (+,
–). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
Procedures:
➀Loosen the terminal knob.
➁Insert the bare speaker wire end properly into the ter-
minal hole. [Remove approx. 10 mm (3/8”) insulation
from the speaker cord.]
➂Tighten the knob.
➃Test the security of the connection by pulling lightly the
cord at the terminal.
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or
the amplifier, or both of them.
SPECIFICATIONS
Type..........................2-way 2-speaker acoustic-suspension
speaker system
Speaker Unit..........................................10 cm cone woofer
2.2 cm dome tweeter
Input Terminal.....................................................Screw-type
Impedance .................................................................6 ohm
Frequency Response..................................80 Hz – 30 kHz
Nominal Input Power.....................................................50W
Maximum Input Power................................................150W
Sensitivity (2.83V, 1m)................................................90 dB
Crossover Frequency..................................................5 kHz
Dimensions (WxHxD).......................150 x 265 x 156.3 mm
(5-7/8” x 10-7/16” x 6-3/16”)
Weight .................................................2.2 kg (4 lbs. 13 oz.)
Accessories ..................................Speaker cords (10m) x 2
* Specifications subject to change without notice due to
product improvements.
* Care should be taken not to exceed the input power val-
ues noted above.
CONNECTION TO YOUR AMPLIFIER
Red (+)
Black (–)
Speaker output
terminals of the
amplifier
Loosen Tighten
Gray line
Amplifier
Gray line Gray line
Speaker (R) Speaker (L)
Otros manuales para NS-C55
1
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Sistema de altavoces de Yamaha
Yamaha
Yamaha NX-E400 Manual de usuario
Yamaha
Yamaha NS-P125 Manual de usuario
Yamaha
Yamaha VXC5F Manual de usuario
Yamaha
Yamaha YAS-306 Manual de usuario
Yamaha
Yamaha CBR Series Manual de usuario
Yamaha
Yamaha YSP 800 - Digital Sound Projector Five CH... Manual de usuario
Yamaha
Yamaha SR-B20A Manual de usuario
Yamaha
Yamaha S3115H Manual de usuario
Yamaha
Yamaha Digital Sound Projector YSP-3000 Manual de usuario
Yamaha
Yamaha NS-B20 Manual de usuario
Yamaha
Yamaha YSP-1600 Manual de usuario
Yamaha
Yamaha YAS-105 Manual de usuario
Yamaha
Yamaha NS-AW350 Manual de usuario
Yamaha
Yamaha NS-C200 Manual de usuario
Yamaha
Yamaha YSP-1600 Manual de usuario
Yamaha
Yamaha AX-10 Manual de usuario
Yamaha
Yamaha IF2112-64 Manual de usuario
Yamaha
Yamaha YAS-408 Manual de usuario
Yamaha
Yamaha IF2115/64 Manual de usuario
Yamaha
Yamaha YHT-5960U Guía de inicio rápido
Manuales populares de Sistema de altavoces de otras marcas
Sondpex
Sondpex Active Speaker System and Digital Music... Manual de usuario
JVC
JVC NX-PN7 Manual de usuario
Marshall Amplification
Marshall Amplification AR-DM61-BT Manual de usuario
SE Audiotechnik
SE Audiotechnik I-LINE Manual de usuario
Gemini
Gemini WRX-843 Series Manual de usuario
TCL
TCL 6100 Series Manual de usuario