X10 IN62A Manual
GUIDE:
IN62A
Copyright 2001 X10 Wireless Technology, Inc. All rights reserved.
Connect the power supply to the VCR
Commander and plug it into a wall outlet.
Have someone walk in front of your FloodCam
within 30 seconds of your pressing PLAY.
The LED on the VCR Commander will go
out.
Press and hold PLAY until the LED stays on.
Press and hold REC until the LED stays on.
Place your remote control 1 inch away from
the VCR Commander.
Press REC on the VCR Commander and
release it. The LED will blink quickly and then
stay on. Press the Record button on your
remote and keep pressing it until the LED on
the VCR Commander briefly goes out and
comes back on solid. This means that Record
has been learned.
Repeat these steps again for the STOP
function.
Plug the IR emitter cable into the back of the
VCR Commander.
Press the emitter onto the VCR you are going
to control, after removing the plastic from the
adhesive backing.
Get more help at: http://www.x10.com/support
VCR Commander & FloodCam
(Install your FloodCam before getting started.)
Otros manuales de Sistema de seguridad de X10
X10
X10 Motion Monitor PR511 Manual de usuario
X10
X10 XCamPro Manual de usuario
X10
X10 SC12A Manual de usuario
X10
X10 Ninja VK75A Manual de usuario
X10
X10 PH7208 Manual de usuario
X10
X10 PK9000 Manual de instalación
X10
X10 Monitor Plus DC8700P Manual de usuario
X10
X10 Orca2000 Manual de usuario
X10
X10 Ninja VK74A Manual de usuario
X10
X10 PROTECTOR+ Manual de usuario
Manuales populares de Sistema de seguridad de otras marcas
EDM
EDM Solution 6+6 Wireless-AE Manual de usuario
Highway Safety Group
Highway Safety Group EA401 Manual de usuario
Siren
Siren LED GSM Manual de usuario
Detection Systems
Detection Systems 7090i Instrucciones de montaje
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manual de usuario
Siemens
Siemens FDM273 Manual de usuario