wtw TetraCon 325 Manual de usuario
TetraCon 325
TetraCon 325/C
ba55301e04 01/2009 9
Operating manual
Standard conductivity measuring cell
Copyright © 2016 Xylem Analytics Germany GmbH
Printed in Germany.
TetraCon 325 / TetraCon 325/C Contents
11
Contents
ba55301e04 01/2009
1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
1.1 Structure and function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
1.2 Recommended fields of application . . . . . . . . . . . . . . . . . . . . . 12
2 Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
3 What to do if... . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
4 Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Overview TetraCon 325 / TetraCon 325/C
12 ba55301e04 01/2009
1Overview
1.1 Structure and function
Structure
1.2 Recommended fields of application
zOn site measurements in rivers, lakes and wastewater
zFish farming
zGround water measurements
zApplications in water laboratories
The TetraCon 325/C is especially suitable for higher chemical loads,
particularly acidic media.
1Voltage electrode (inside, 2x)
2Current electrode (ring, 2x)
3Temperature sensor in graphite enclosure
4Shaft
5Closing head
41, 2 3 5
TetraCon 325 / TetraCon 325/C Cleaning
13
ba55301e04 01/2009
2 Cleaning
CAUTION
To clean the sensor, disconnect it from the instrument.
Outside cleaning We recommend to clean the sensor thoroughly, especially before measuring
low conductivity values.
After cleaning, thoroughly rinse with deionized water and recalibrate if
necessary.
Aging of the
conductivity
measuring cell
Normally, the conductivity measuring cell does not age. Special measuring
mediums (e.g. strong acids and bases, organic solvents) or temperatures
that are too high may considerably reduce its lifetime or lead to damage. The
warranty does not cover cases where such conditions cause failure or
mechanical damage.
Disposal We recommend to dispose of the measuring cell as electronic waste.
3 What to do if...
Contamination Cleaning procedure
Lime sediments Immerse in acetic acid for 5 minutes (volume
share = 10 %)
Fat/oil Clean with warm water containing washing-
up liquid
Error symptom Cause Remedy
No temperature or
conductivity display
– No connection between
measuring instrument and
conductivity measuring cell
– Cable defective
– Connection between measuring
instrument and conductivity
measuring cell
Measurement delivers
implausible conductivity
values
– Incorrect cell constant adjusted at
the measuring instrument
– Measuring range exceeded
– Contamination in the area of the
electrodes
– Electrodes damaged
– Check / correct the cell constant
– Make sure the correct sensor is
being used for the application
– Clean the conductivity measuring
cell (see chapter 2).
– Return the sensor
Incorrect temperature
display
– The temperature sensor was not
immersed deep enough in the
measuring solution
– Temperature sensor defective
– Observe the minimum immersion
depth
– Return the conductivity measuring
cell
Technical data TetraCon 325 / TetraCon 325/C
14 ba55301e04 01/2009
4 Technical data
General features Measuring principle Four-electrodes measurement
Cell constant 0.475 cm-1 ±1.5 %
Temperature sensor integrated NTC 30 (30 k:at 25 °C / 77 °F)
Dimensions
(in mm)
Weight approx. 135 g
Materials Shaft Epoxy
Connection head TetraCon 325: POM
TetraCon 325/C: PEEK
Conductivity electrodes Graphite
Thermistor enclosure Graphite
Connection cable Lengths TetraCon 325: 1.5 / 3 / 6 / 10 / 15 / 20 m
TetraCon 325/C: 1.5 m
Diameter 6 mm
Smallest allowed
bend radius
fixed installation: 50 mm
flexible use: 80 mm
Plug type Socket, 8 pins
Pressure
resistance Sensor with connection
cable
IP 68 (2 x 105Pa or 2 bar)
Cable plug IP 67 (when plugged in)
The TetraCon 325 / TetraCon 325/C meets the requirements according to
article 3(3) of the directive, 97/23/EC ("pressure equipment directive").
162.5
15.3 21.7 17.5
120.0
TetraCon 325 / TetraCon 325/C Technical data
15
ba55301e04 01/2009
Pin assignment
Measurement
conditions Conductivity measuring
range
1 PS/cm ... 2 S/cm
Temperature range -5 ... 80 °C (100 °C)
23 ... 176 °F (212 °F)
Max. allowed overpressure 2 x 105Pa (2 bar)
Minimum depth of
immersion
36 mm
Maximum depth of
immersion
(at temperature)
Whole sensor + cable up to 80 °C (176 °F)
Sensor shaft only (=120 mm) up to 100 °C
(212 °F)
Operating position Any
Storage
conditions Recommended storing
method
In air
Storage temperature 0 ... 50 °C (32 ... 122 °F)
Characteristic data
on delivery Temperature responding
behavior
t99 (99 % of the final value display after)
<20s
Precision of the temperature
sensor
± 0.2 K
4
2
5
3
8
6
1
7
NTC
30 kW
Voltage electrode 2
Current electrode 1
Voltage electrode 1
NTC
NTC
Current electrode 2
Shield
not used
Plug from the front: 4
5
7
38
2
6
1
Technical data TetraCon 325 / TetraCon 325/C
16 ba55301e04 01/2009
What can Xylem do for you?
We're a global team unified in a common purpose: creating innovative solutions to
meet our world's water needs. Developing new technologies that will improve the way
water is used, conserved, and re-used in the future is central to our work. We move,
treat, analyze, and return water to the environment, and we help people use water
efficiently, in their homes, buildings, factories and farms. In more than 150 countries, we
have strong, long-standing relationships with customers who know us for our powerful
combination of leading product brands and applications expertise, backed by a legacy
of innovation.
Xylem Analytics Germany GmbH
Dr.-Karl-Slevogt-Str. 1
82362 Weilheim
Germany
Xylem Analytics Germany
Sales GmbH & Co. KG
WTW
Dr.-Karl-Slevogt-Str. 1
82362 Weilheim
Germany
Tel.:
Fax:
E-Mail
Internet:
+49 881 183-325
+49 881 183-414
www.WTW.com
Service address:
®
For more information on how Xylem can help you, go to xyleminc.com.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Instrumento de medición de wtw
wtw
wtw Oxi 7310 Manual de usuario
wtw
wtw Turb 355 IR/T Manual de usuario
wtw
wtw LF 170 Manual de usuario
wtw
wtw pH 3110 Manual de usuario
wtw
wtw Oxi 330i Manual de usuario
wtw
wtw pH 315i Manual de usuario
wtw
wtw pH 3110 Manual de usuario
wtw
wtw Cond 330i Manual de usuario
wtw
wtw SensoLyt MPP-A Pt Series Manual de usuario
wtw
wtw IQ SENSOR NET Manual de usuario
wtw
wtw Multi 3430 Manual de usuario
wtw
wtw P 700 IQ Instrucciones de funcionamiento
wtw
wtw KLE 325 Manual de usuario
wtw
wtw DIQ/S 182-PR Manual de usuario
wtw
wtw PhotoLab Spektral Manual de usuario
wtw
wtw VWR MU 6100 H Manual de usuario
wtw
wtw Turb 555 Manual de usuario
wtw
wtw TetraCon 700 Manual de usuario
wtw
wtw Turb 430 IR/T Manual de usuario
wtw
wtw Turb 550 Manual de usuario
Manuales populares de Instrumento de medición de otras marcas
Endress+Hauser
Endress+Hauser Proline Promag 50 Especificaciones técnicas
Siemens
Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas
KLINGER
KLINGER CMF V Series Manual de usuario
EXFO
EXFO FTB-2 Manual de operación y mantenimiento
Keysight
Keysight M8290A Manual de usuario
ADTEK
ADTEK MW-5 Manual de usuario