Worx MAKERX WX747 Manual de usuario

20V Cordless Mini Blower WX747

WX747.X

Original instructions

Originalbetriebsanleitung

Notice originale

Istruzioni originali

Manual original

Oorspronkelijke gebruiksaanwijzing

Original brugsanvisning

Opprinnelige Instruksjonene

Bruksanvisning i original

Instrukcja oryginalna

Ω ΔΩ 

Eredeti használati utasítás

Instrucţiuni originale

Původní návod k používání

Pôvodný návod na použitie

Izvirna navodila

P06

P19

P34

P48

P62

P77

P91

P105

P117

P130

P142

P157

P174

P189

P203

P216

P230

NOR

5678

A3 A4

B C

A2A1

A3 A4

A2A1

ORIGINAL INSTRUCTION

PRODUCT SAFETY

GENERAL POWER TOOL SAFETY

WARNINGS

WARNING Read all safety

warnings and instructions.

Failure to follow the warnings and

instructions may result in electric

shock, fire and/or serious injury.

Save all warnings and instruc-

tions for future reference.

The appliance is only to be used

with the power supply unit pro-

vided with the appliance.

IMPORTANT

READ CAREFULLY BEFORE

USE.

KEEP FOR FUTURE

REFERENCE.

Safe operating practices

1) Training

a) Read the instructions

carefully. Be familiar with

the controls and the correct

use of the machine.

b) Never allow children,

persons with reduced

physical, sensory or mental

capabilities or lack of

experience and knowledge

or people unfamiliar with

these instructions to

use the machine, local

regulations may restrict the

age of the operator.

c) Never operate the machine

while people, especially

children, or pets are nearby.

d) Keep in mind that the

operator or user is

responsible for accidents or

hazards occurring to other

people or their property.

2)Preparation

a) While operating the

machine, always wear

substantial footwear and

long trousers. Do not

operate the machine when

barefoot or wearing open

sandals. Avoid wearing

clothing that is loose fitting

or that has hanging cords or

ties.

b) Do not wear loose clothing

or jewellery that can be

drawn into the air inlet. Keep

long hair away from the air

inlets.

Obtain ear protection and

safety glasses. Wear them at

all times while operating the

machine.

d) Operate the machine in a

recommended position and

only on a firm, level surface.

e) Do not operate the machine

on a paved or gravel surface

where ejected material

could cause injury.

f) Before using, always visually

inspect to see, that the

fasteners are secure, the

housing is undamaged and

that guards and screens

are in place. Replace worn

or damaged components

in sets to preserve balance.

Replace damaged or

unreadable labels.

3)Operation

a) Keep your face and body

away from the feed intake

opening.

b) Do not allow hands or any

other part of the body or

clothing inside the feeding

chamber, discharge chute,

or near any moving part.

c) Keep proper balance and

footing at all times. Do not

overreach.

d) Always stand clear of the

discharge zone when

operating this machine.

e) If the machine should start

making any unusual noise or

vibration, immediately shut

off the power source and

allow the machine to stop.

Remove the battery pack

from the machine and take

the following steps before

restarting and operating the

machine:

i) inspect for damage;

ii) replace or repair any

damaged parts;

iii) check for and tighten any

loose parts.

f) If the machine becomes

clogged, shut-off the

power source and remove

the battery pack from the

machine before cleaning

debris.

g) Never operate the machine

with defective guards or

shields, or without safety

devices.

h) Keep the power source

clean of debris and other

accumulations to prevent

damage to the power

source or possible fire.

i) Do not transport this

machine while the power

source is running.

j) Always disconnect the

machine from the power

supply (e.g. remove the

battery pack from the

machine)

- whenever you leave the

machine,

- before clearing blockages

or unclogging chute,

- before checking, cleaning

or working on the machine.

k) Avoid using the machine

in bad weather conditions

especially when there is a

risk of lightning.

4)Maintenance and storage

a) keep all nuts, bolts and

screws tight to be sure the

appliance is in safe working

condition.

b) Replace worn or damaged

parts.

c) Use only genuine

replacement parts and

accessories.

d) Store the machine in a dry

place out of the reach of

children.

e) When the machine is

stopped for servicing,

inspection, or storage, or

to change an accessory,

shut off the power source,

disconnect the machine

from the supply and make

sure that all moving parts

are come to a complete

stop. Allow the machine

to cool before making any

inspections, adjustments,

etc. Maintain the machine

with care and keep it clean.

f) Store the machine in a dry

place out of the reach of

children.

g) Always allow the machine to

cool before storing.

Otros manuales para MAKERX WX747

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Soplador de Worx

Manuales populares de Soplador de otras marcas

Weed Eater

Weed Eater VS2000BV Manual de usuario

KRAUSMANN

KRAUSMANN U37020-00 Manual de usuario

Bosch

Bosch ALB 36 LI Manual de usuario

Cub Cadet

Cub Cadet HB425 Manual de usuario

GreenWorks Pro

GreenWorks Pro BLB482 Manual de usuario

ARIETE

ARIETE 2768 Manual de usuario

NuTone

NuTone 331H Manual de usuario

GÜDE

GÜDE GLB 200 18 Li-Ion Manual de usuario

I.VA.CO.

I.VA.CO. SC Series Instrucciones de funcionamiento

DeWalt

DeWalt DCE100 Manual de usuario

Becker

Becker SV 7.330 Manual de usuario

Metabo

Metabo AG 18 Pro Manual de usuario

Desa

Desa GA3650TB Manual de usuario

Echo

Echo Power Blower PB-230LN Manual de usuario

Echo

Echo PB-413H Manual de usuario

Black & Decker

Black & Decker BV3100 Manual de usuario

Ryobi

Ryobi RY08570 Manual de usuario

Haaga

Haaga 355 Manual de usuario