Wolf CSO3050CMB Manual de usuario

Convection Steam Oven

Installation Guide

SPECIFICATIONS, INSTALLATION,

AND MORE

2 | Wolf Customer Care 800.222.7820

Convection Steam Oven

Contents

3Convection Steam Oven

4Speciﬁcations

8Installation

11 Troubleshooting

Features and speciﬁcations are subject to change at any

time without notice. Visit wolfappliance.com/specs for the

most up-to-date information.

Important Note

To ensure this product is installed and operated as safely

and eciently as possible, take note of the following types

of highlighted information throughout this guide:

IMPORTANT NOTE highlights information that is especially

important.

CAUTION

Indicates a situation where minor injury or product

damage may occur if instructions are not followed.

WARNING

States a hazard that may cause serious injury or

death if precautions are not followed.

IMPORTANT NOTE: Throughout this guide, dimensions in

parentheses are millimeters unless otherwise speciﬁed.

IMPORTANT NOTE: Save these instructions for the local

electrical inspector.

wolfappliance.com | 3

Product Information

Important product information, including the model and

serial number, are listed on the product rating plate. The

rating plate is located on the left side of the front face

frame. The oven door must be open to view the rating

plate. Refer to the illustration below.

If service is necessary, contact Wolf Factory Certiﬁed

Service with the model and serial number. For the name of

the nearest Wolf Factory Certiﬁed Service or for questions

regarding the installation, visit the Product Support section

of our website, wolfappliance.com, or call Wolf Customer

Care at 800-222-7820.

Convection Steam Oven

RATING PLATE

Rating plate location

4 | Wolf Customer Care 800.222.7820

Electrical Requirements

Installation must comply with all applicable electrical codes.

For ease of installation, the electrical supply for the oven

should be placed in an adjacent cabinet within reach of the

conduit.

Performance may be compromised if the electrical supply

is less than 240 volts.

The oven is supplied with a conduit consisting of two hot

lead conductors and a ground conductor. The wiring dia-

gram covering the control circuit is provided with the oven.

ELECTRICAL REQUIREMENTS

Electrical Supply grounded, 240/208 VAC, 60 Hz

Service 20 amp dedicated circuit

Conduit 4' (1.2 m)

Total Amps 18

Max Connected Load 4.2 kW

Specifications

Installation Requirements

The Convection Steam Oven can be installed in a standard

or ﬂush inset application. The back of the base support

must be open for water and drain line accessibility and

routing. Refer to the illustration below.

Finish the edges of the opening. They may be visible when

the door is open.

For standard installations, the face trim overlaps stiles and

rails. Refer to the chart below.

For ﬂush inset installations, a minimum ⁄" (3) reveal is

required on all sides. To ensure consistent reveals, each

corner of the opening must be exactly 90°.

INSTALLATION REQUIREMENTS

Minimum Base Support 150 lb (68 kg)

TRIM OVERLAP 24" MODEL 30" MODEL

Top ⁄" (5) ⁄" (5)

Bottom 0" (0) 0" (0)

Sides ⁄" (16) ⁄" (18)

BACK OF

CABINET

4" (102)

18"

(457)

Base support

RATING PLATE

Rating plate location

wolfappliance.com | 5

Specifications

Plumbing Requirements

PLUMBED MODELS ONLY

IMPORTANT NOTE: The unit needs minerals in the water

to operate. Do not connect to a ﬁltered water supply.

Installation must comply with all applicable plumbing

codes.

IMPORTANT NOTE: The drain connection must be able to

withstand temperatures up to 130°F (55°C).

The drain tube connection must be a minimum 2" (51)

below the unit and a minimum 4" (102) from the ﬂoor.

Locate the drain and water connections below the unit

or in an adjacent cabinet. Any opening into the adjacent

cabinet must meet the following: the longest dimension of

the opening shall not be more than 1⁄" (38). The edges of

the opening must be smooth and round.

IMPORTANT NOTE: The drain location can vary, but must

be within reach of the corrugated tubing. Do not extend or

reduce the drain tubing. A drain line high loop is required.

Refer to the illustrations below.

PLUMBING REQUIREMENTS

Water Connection 6.5' (2 m) braided tubing with

⁄" female compression ﬁtting

Drain Connection 10' (3 m) corrugated tubing

Pressure 15–145 psi (1–10 bar)

DRAIN

CONNECTION

2" (51)

MIN

23/4" (70)

TO 5" (127)

2" (51)

271/2"

(699)

23/4" (70)

TO 5" (127)

2" (51)

271/2"

(699)

2"(51)

MIN

DRAIN

CONNECTION

Drain connection A

Drain connection B

Connect the water supply to a cold water house supply

with an easily accessible shut-o valve between the supply

and the unit.

Purge the water supply prior to ﬁnal connection to the

unit. This will remove any debris that may be present in the

tubing from installing the new water supply. Connect the

braided tubing from the unit to the house water supply with

the ﬁtting provided. Check all water supply ﬁttings for leaks.

6 | Wolf Customer Care 800.222.7820

Specifications

Convection Steam Oven

STANDARD INSTALLATION

FRONT VIEW

SIDE VIE

1711/16"

(449)

OPENING

HEIGHT

23" (584)

OPENING

DEPTH

TOP VIEW

NOTE: Location of electrical supply within opening may require additional cabinet depth.

OPENING WIDTH

OPENING WIDTH W

24" Model 22⁄" (562)

30" Model 28⁄" (724)

wolfappliance.com | 7

Specifications

Convection Steam Oven

FLUSH INSET INSTALLATION

FLUSH INSET WIDTH**

FRONT VIEW

SIDE VIE

24" (610)

FLUSH INSET

DEPTH

7/8" (22)

ill be visible and should be finished to match cabinetry.

Dimension provides minimum reveals.

NOTE: Location of electrical supply within opening may require additional cabinet depth.

181/8"

(460)

FLUSH INSET

HEIGHT**

5/16"(8)

1/8" (3)

TOP VIEW

FINISHED

CLEATS*

OPENING WIDTH W A

24" Model 23⁄" (603) ⁄" (21)

30" Model 30⁄" (765) ⁄" (21)

8 | Wolf Customer Care 800.222.7820

Preparation

Before moving the oven, protect any ﬁnished ﬂooring and

secure the oven door closed to prevent damage.

Use an appliance dolly to move the unit near the opening.

Remove and recycle packing materials. Do not lift or carry

the oven by the door handle.

OVEN DOOR REMOVAL

To remove, open the oven door completely. Rotate both

hinge latches forward to the open position. Partially close

the door to the at-rest position (press and hold for

handleless models), then lift up and out. Refer to the

illustrations below.

To reinstall, insert door hinges into the frame openings.

Open the oven door completely and rotate both hinge

latches back to the closed position.

Installation

Electrical Connection

WARNING

Verify power is disconnected from the electrical box

before proceeding.

If the electrical supply is located in the opening, the elec-

trical connection must be made prior to placing the oven

in the opening. If the electrical supply is in an adjacent

cabinet, the electrical connection can be made after

placing the oven in the opening.

1 Connect the black appliance wire to the black (L1)

power supply.

2 Connect the red appliance wire to the red (L2) power

supply.

3 Connect the green appliance wire to the green/ground

wire.

CLOSED

POSITION

Oven door hinge latch

Door at-rest position

wolfappliance.com | 9

Installation

PLUMBED MODELS

1 Place the unit near the opening.

2 Remove the red cap from the water line.

3 Connect the drain tube with the provided clamp, then

secure the drain tube with the adhesive hose clamp

provided.

4 Hand tighten the water supply to the unit.

5 Cut or shift the water/drain line tape and adjust, if

necessary, then rotate the water connection in the

desired direction. Refer to the illustration below.

6 Connect the water connection to the water supply with

the ﬁtting provided, then check for leaks.

7 Connect the drain tube following local code. The

drain connection will accommodate 1" (25), ⁄" (19), and

⁄" (16) drain connections. The connection must be cut

to ﬁt ⁄" (19) and ⁄" (16) connections. If connecting to

a food waste disposer, remove the knockout prior to

making the drain connection.

8 Place the oven in the opening and slide back partially.

Verify the conduit, drain line, and water supply are not

kinked or trapped, then slide the oven back completely.

1 Locate the mounting holes on the oven side trim, two

on each side. Drill ⁄" pilot holes. Use the provided

mounting screws to secure the oven to cabinetry. Refer

to the illustration below.

2 Remove all contents from the unit.

3 Remove the tape from the bottom of the oven cavity.

4 Insert the ﬁlter over the water outlet. Refer to the

illustration below.

5 Run a Steam cycle and check for leaks.

CAUTION

Failure to install the mounting screws may cause the

oven to tip forward during use.

DRAIN TUBE

CONNECTION

HOSE

CLAMP WATER

SUPPLY

BACK OF UNIT

Water connection

Installation

MOUNTING

HOLES

FILTER

Oven installation

Filter location

10 | Wolf Customer Care 800.222.7820

Installation

NON-PLUMBED MODELS

1 Place the unit near the opening.

2 Place the oven in the opening and slide back partially.

Verify the conduit is not kinked or trapped, then slide

the oven back completely.

3 Locate the mounting holes on the oven side trim, two

on each side. Drill ⁄" pilot holes. Use the provided

mounting screws to secure the oven to cabinetry. Refer

to the illustration below.

CAUTION

Failure to install the mounting screws may cause the

oven to tip forward during use.

MOUNTING

HOLES

Oven installation

Tabla de contenidos

Idiomas:

Otros manuales de Horno de Wolf

Wolf

Wolf L Series Manual de usuario

Wolf

Wolf 24 E Series Manual de usuario

Wolf

Wolf DF48650G/S/P Manual de usuario

Wolf

Wolf E Series Manual de usuario

Wolf

Wolf M Series Guía

Wolf

Wolf E Series Manual de usuario

Wolf

Wolf E Series SO30-2F/S Manual del propietario

Wolf

Wolf e Series Manual de usuario

Wolf

Wolf WGCO100S Manual de usuario

Wolf

Wolf ICBSO30-2U/S Manual del propietario

Wolf

Wolf DO30F/S L Series Manual de usuario

Wolf

Wolf M Series Manual de usuario

Wolf

Wolf L Series Manual de usuario

Wolf

Wolf M Series Manual de usuario

Wolf

Wolf SO30F/S Manual de usuario

Wolf

Wolf SO30CM/S Manual de usuario

Wolf

Wolf e Series Manual de usuario

Wolf

Wolf M Series Instrucciones de funcionamiento

Wolf

Wolf L Series SO30F Manual de usuario

Wolf

Wolf L Series SO30F Manual de usuario

Wolf

Wolf E Series Guía

Wolf

Wolf DO30U/B Manual de usuario

Wolf

Wolf CSO Series Manual de usuario

Wolf

Wolf e Series Manual de usuario

Manuales populares de Horno de otras marcas

Bosch

Bosch HVA531NS0 Manual de usuario

Electrolux

Electrolux EOF6P46X Manual de usuario

NEFF

NEFF B44S32 5GB Series Manual de usuario

Combi

Combi BLODGETT BC142GDS Manual de usuario

AEG

AEG COMPETENCE 311704300 Manual de usuario

Falcon

Falcon DOMINATOR PLUS G3106 Series Guía del usuario

Rational

Rational SCC WE 61G Manual de usuario

Smeg

Smeg DOSPA38X Manual de instalación y operación

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manual de usuario

Miele

Miele HR 1954-2 Manual de usuario

KHIND

KHIND OT50 Manual de usuario

Henny Penny

Henny Penny Smoker Box Manual de usuario

Lang

Lang ECOD-AP Manual de usuario

AEG

AEG BEK455310M Manual de usuario

Frigidaire

Frigidaire FNGE90JGR Manual de usuario

Hotpoint

Hotpoint FE9 S831 JSH IX Manual de usuario

GE Advantium SCB2000 Manual de usuario

AEG

AEG DE401301DM Manual de usuario