Winmate R10L100-SPT2 Manual de usuario
Please read these instructions carefully before using this product, and save this manual for future use
Full IP65
Flat Stainless P-CAP
Display
Quick Start Guide
V1.0
For more information on this and other
Winmate products, please visit our
website at: www.winmate.com
Model No.:
R10L100-SPT2
R15L100-SPC3
R17L100-SPA1
R19L100-SPM1
W22L100-SPA3
Document Part Number: 91521110100N
i
FCC Statement
This device complies with part 15 FCC rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
class "B" digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at him own expense.
European Union
Electromagnetic Compatibility Directive (2014/30/EU)
EN55024: 2010/ A1: 2015
oIEC61000-4-2: 2009
oIEC61000-4-3: 2006+A1: 2007+A2: 2010
oIEC61000-4-4: 2012
oIEC61000-4-5: 2014
oIEC61000-4-6: 2014
oIEC61000-4-8: 2010
oIEC61000-4-11: 2004
EN55032: 2012/AC:2013
EN61000-3-2:2014
EN61000-3-3:2013
Low Voltage Directive (2014/35/EU)
EN 60950-1:2006/A11:2009/A1:2010/A12:2011/ A2:2013
This equipment is in conformity with the requirement of the following EU
legislations and harmonized standards. Product also complies with the
Council directions.
ii
Copyright Notice
No part of this document may be reproduced, copied, translated, or transmitted in
any form or by any means, electronic or mechanical, for any purpose, without the
prior written permission of the original manufacturer.
Trademark Acknowledgement
Brand and product names are trademarks or registered trademarks of their
respective owners.
Disclaimer
Winmate Inc. reserve the right to make changes, without notice, to any product,
including circuits and/or software described or contained in this manual in order
to improve design and/or performance. We assume no responsibility or liability
for the use of the described product(s) conveys no license or title under any
patent, copyright, or masks work rights to these products, and make no
representations or warranties that these products are free from patent, copyright,
or mask work right infringement, unless otherwise specified. Applications that are
described in this manual are for illustration purposes only. We make no
representation or guarantee that such application will be suitable for the specified
use without further testing or modification.
Warranty
Winmate Inc. warranty guarantees that each of its products will be free from
material and workmanship defects for a period of one year from the invoice date.
If the customer discovers a defect, we will, at his/her option, repair or replace the
defective product at no charge to the customer, provide it is returned during the
warranty period of one year, with transportation charges prepaid. The returned
product must be properly packaged in its original packaging to obtain warranty
service. If the serial number and the product shipping data differ by over 30 days,
the in-warranty service will be made according to the shipping date. In the serial
numbers the third and fourth two digits give the year of manufacture, and the fifth
digit means the month (e. g., with A for October, B for November and C for
December).
For example, the serial number 1W17Axxxxxxxx means October of year 2017.
iii
Customer Service
We provide a service guide for any problem by the following steps: First, visit the
website of our distributor to find the update information about the product.
Second, contact with your distributor, sales representative, or our customer
service center for technical support if you need additional assistance.
You may need the following information ready before you call:
Product serial number
Software (OS, version, application software, etc.)
Description of complete problem
The exact wording of any error messages
In addition, free technical support is available from our engineers every business
day. We are always ready to give advice on application requirements or specific
information on the installation and operation of any of our products.
Safety Information
WARNING! / AVERTISSEMENT!
Always completely disconnect the power cord from your chassis
whenever you work with the hardware. Do not make connections
while the power is on. Sensitive electronic components can be
damaged by sudden power surges. Only experienced electronics
personnel should open the PC chassis.
Toujours débrancher le cordon d’alimentation du chassis lorsque
vous travaillez sur celui-ci. Ne pas brancher de connections lorsque
l’alimentation est présente. Des composantes électroniques
sensibles peuvent être endommagées par des sauts d’alimentation.
Seulement du personnel expérimenté devrait ouvrir ces chassis.
CAUTION/ATTENTION
Always ground yourself to remove any static charge before
touching the CPU card. Modern electronic devices are very
sensitive to static electric charges. As a safety precaution, use a
grounding wrist strap at all times. Place all electronic components
in a static-dissipative surface or static-shielded bag when they are
not in the chassis.
Toujours verifier votre mise à la terre afin d’éliminer toute charge
statique avant de toucher la carte CPU. Les équipements
électroniques moderns sont très sensibles aux décharges
d’électricité statique. Toujours utiliser un bracelet de mise à la
terre comme précaution. Placer toutes les composantes
électroniques sur une surface conçue pour dissiper les charge, ou
dans un sac anti-statique lorsqu’elles ne sont pas dans le chassis.
iv
Contents
INTRODUCTION 1
Features 1
Package Contents 2
Product Overview 3
Dimensions 10.4" 3
Dimensions 15" 3
Dimensions 17” 3
Dimensions 19” 4
Dimensions 21.5” 5
Physical Buttons and LED Indicators 6
Connectors 8
GETTING STARTED 9
Turning On Your Device 9
Turning Off Your Device 10
INSTALLATION 11
Wiring Requirements 11
Connector Pin Assignments 12
Power Cable 12
USB Cable (For Touch) 13
VGA Cable 14
DVI Cable (Optional) 15
Mounting 16
VESA Mounting 16
Yoke Mounting 17
SPECIFICATIONS 18
APPENDIX A: CLEANING THE MONITOR 20
APPENDIX B: AVAILABLE INPUT SIGNALS 21
1
INTRODUCTION
Congratulations on purchasing Winmate® IP65 Flat Stainless P-CAP Series
Display. Winmate® IP65 Flat Stainless P-CAP Series Display is rugged,
industrial-grade display series built to withstand challenging environments,
undergoing rigorous testing to ensure safety and top performance. All of the
models in the series are sealed to IP65 standard. Stainless housing features anti-
corrosion properties making it suitable for food, chemical and pharmaceutical
industries. Projected Capacitive Multi-Touch (P-CAP) screen supports glove
mode and provides even more convenience for the operator.
Winmate® IP65 Flat Stainless P-CAP Display goes beyond that of the standard
industrial panel computers with elegant, edge-to-edge design, rugged
construction, powerful performance, and flexible mounting options.
Features
Winmate® IP65 Flat Stainless Display features:
SUS304 Brushed Stainless Steel housing
Sealed to IP65 for protection against water and dust (it's suggested to use
LAN/USB/COM only)
A true flat, easy-to-clean front surface with edge-to-edge design
Flat multi-touch display with superior readability and P-CAP technology
Various mounting solutions, Yoke mounting and VESA mounting
Waterproof ports with adapter cables for external connectivity
Rain/ Glove Mode
Widely used in chemical industry, food industry, medical devices,
appliances etc. with good corrosion resistance
2
Package Contents
Carefully remove the box and unpack your device. Please check if all the items
listed below are inside your package. If any of these items are missing or damaged
contact us immediately.
Standard factory shipment list may include the following items:
Display
Quick Start Guide
(Hardcopy)
R-series AD Board
Manual (Hardcopy)
Varies by product
specifications
91521110100N
91521112100C
AC Adapter
Power Cable*
VGA Cable
50W: 90PO12050002
80W: 90PO12080003
Varies by country
944115010000
USB Cable
(For Touch)
DVI Cable
(Optional)
VESA Screws
948704010000
9455255250Q1
913511101101
3
Product Overview
This section contains mechanical drawing of the Display. Notice that this is a
simplified drawing and some components are not marked in detail.
Dimensions 10.4" Unit: mm
Dimensions 15" Unit: mm
Dimensions 17”
4
Unit: mm
Dimensions 19”
Unit: mm
5
Dimensions 21.5”
Unit: mm
Este manual sirve para los siguientes modelos
4
Tabla de contenidos
Otros manuales de Monitor de Winmate
Winmate
Winmate R15L600-MLA3FP Manual de usuario
Winmate
Winmate W27L100-CHC1 Manual de usuario
Winmate
Winmate PT Series Manual de usuario
Winmate
Winmate Open Frame Display Manual de usuario
Winmate
Winmate W32L100-PTA1 Manual de usuario
Winmate
Winmate W24L100-SPA2 Manual de usuario
Winmate
Winmate W15L100-PTA3-ME Manual de usuario
Winmate
Winmate P Series Manual de usuario
Winmate
Winmate R10L OF TR Series Manual de usuario
Winmate
Winmate Front IP65 Display Series Manual de usuario
Winmate
Winmate M270TF-SDI Manual de usuario
Winmate
Winmate R10L CH Series Manual de usuario
Winmate
Winmate W07FA3S-PCM1AC-PoE Manual de usuario
Winmate
Winmate W24L100-SPA269 Manual de usuario
Winmate
Winmate R19L100-MLM1 Manual de usuario
Winmate
Winmate B Series Manual de usuario
Winmate
Winmate R15L100-VMC3HB Manual de usuario
Winmate
Winmate R15L100-POC3-C Manual de usuario
Winmate
Winmate W07L100-GSO1 Manual de usuario
Winmate
Winmate R19L100-MLA3 Manual de usuario
