Wildcat LYNX Manual de usuario

www.wildcatmini.com
1
2022 OWNER’S MANUAL

www.wildcatmini.com
2
All of the original equipment axed to the bicycle at the
time of the original sale were selected as being compatible
with your frame and with all other OEM components on the
bicycle. Certain aftermarket products and/or components
may not be compatible for use with this bicycle or frame.
Consult with your authorized dealer before you attach any
non-factory specified product to your bicycle.
Use of any component that is not factory specified could
result in damage to the bicycle which would not be covered
by the warranty and could further cause you to lose control
of the bicycle and fall, all of which could cause serious injury
to the rider.
This bike may only be assembled by an authorized dealer.
It may only be sold new by an authorized dealer. If you
purchased the bike from any source other than an authorized
dealer, the bike may have been obtained under suspect
circumstances and may be dangerous for you or your child.
WARNING: Assembly of your bicycle by any party other
than an authorized dealer voids your warranty. It is strongly
recommended to have all post-sale assembly and service
work on your bicycle performed by a properly trained and
equipped dealer.
When inspecting your bicycle, be certain to tighten all
nuts and bolts properly. Under-tightening can result in
loosening, parts loss, and component damage. Over-
tightened nuts and bolts can break.
Most bicycle parts have metric hardware--always use the
correct tools.

www.wildcatmini.com
3
ABOUT THIS MANUAL
It is important for you to understand your new bicycle. By
reading this manual before you go out on your first ride,
you’ll know how to get better performance, comfort, and
enjoyment from your new bicycle. It is also important that
your first ride on your new bicycle is taken in a controlled
environment, away from cars, obstacles, and other cyclists.
GENERAL WARNING
Bicycling can be a hazardous activity even under the best
of circumstances. Proper maintenance of your bicycle is your
responsibility as it helps reduce the risk of injury. This manual
contains many “Warnings” and “Cautions” concerning the
consequences of failure to maintain or inspect your bicycle.
Many of the warnings and cautions say “you may lose control
and fall.” Because any fall can result in serious injury or even
death, we do not repeat the warning of possible injury or
death whenever the risk of falling is mentioned.
SPECIAL NOTE FOR PARENTS
It is a tragic fact that most bicycle accidents involve children.
As a parent or guardian, you bear the responsibility for
the activities and safety of your minor child. Among these
responsibilities are to make sure that the bicycle which your
child is riding is properly fitted to the child; that it is in good
repair and safe operating condition; that you and your child
have learned, understand and obey not only the applicable
local motor vehicle, bicycle, and trac laws, but also the
common sense rules of safe and responsible bicycling. As a
parent, you should read this manual before letting your child
ride the bicycle. Please make sure that your child always
wears an approved bicycle helmet when riding.
WARNING/IMPORTANT
Take notice of this symbol throughout this manual. Pay
particular attention to the instructions that are blocked
o and show this symbol.

www.wildcatmini.com
4

www.wildcatmini.com
5
TABLE OF CONTENTS
PARTS IDENTIFICATION
BEFORE YOU RIDE
SERVICING
DETAILED MAINTENANCE
WARRANTY

www.wildcatmini.com
6
PARTS
IDENTIFICATION

www.wildcatmini.com
7

www.wildcatmini.com
8
BEFORE
YOU RIDE

www.wildcatmini.com
9
BEFORE YOU RIDE
RIDING POSITION
SEAT HEIGHT
In order to obtain the most comfortable riding position and
oer the best possible pedaling eciency, the seat height
should be set correctly in relation to the rider’s leg length.
The correct seat height should not allow leg strain from
over-extension, and the hips should not rock from side to
side when pedaling. While sitting on the bicycle with one
pedal at its lowest point, place the ball of your foot on that
pedal. The correct seat height will allow the knee to be
slightly bent in this position. If the rider then places the heel
of that foot on the pedal, the leg should be almost straight.
Under no circumstances should the seat post project from the frame beyond its “Minimum Insertion” / “Maximum
Extension” mark. If your seat post projects from the frame beyond these markings, the seat post or frame may break,
which could cause you to lose control and fall. Prior to your first ride, be sure to tighten the saddle adjusting mechanism
properly. A loose seat or seat post clamp can cause damage to the bicycle or can cause you to lose control and fall.
Periodically check to make sure that the seat adjusting mechanism is properly tightened.

www.wildcatmini.com
10
BEFORE YOU RIDE
1. BRAKES
• Ensure front and rear brakes work properly.
• Ensure brake shoe pads are not over worn and are correctly
positioned in relation to the rims.
• Ensure brake control cables are lubricated, correctly
adjusted and display no obvious wear.
• Ensure brake control levers are lubricated and tightly
secured to the handlebars.
2. WHEELS AND TIRES
• Ensure tires are inflated to within the recommended limit as
displayed on the tire sidewall.
• Ensure tires have tread and have no bulges or excessive
wear.
• Ensure rims run true and have no obvious wobbles or kinks.
• Ensure all wheel spokes are tight and not broken.
• Check to ensure that wheels are properly seated in the
forks.
• Check that axle nuts are tight.
3. STEERING
• Ensure handlebar and stem are correctly adjusted and
tightened to allow proper steering.
• Ensure that the handlebars are set correctly in relation to
the forks and the direction of travel.
• Check that the headset locking mechanism is properly
adjusted and tightened.
4. CHAIN
• Ensure chain is oiled, clean and runs smoothly.
• More frequent service is required in wet or dusty conditions.
5. BEARINGS
• Ensure all bearings are lubricated, run freely and display no
excess movement, grinding or rattling.
• Check headset, wheel bearings, pedal bearings, and
bottom bracket bearings.
Tabla de contenidos
Otros manuales de Bicicleta de Wildcat


















