WIKA IL-10 Manual de usuario
Operating instructions
Betriebsanleitung
Mode d‘emploi
Manual de instrucciones
EN
DE
FR
ES
Intrinsically safe submersible pressure transmitter model IL-10
Eigensichere Pegelsonde Typ IL-10
Only for instruments with the following marking:
BVS 10 ATEX E 126 X
IECEx BVS 10.0077X
Transmetteur de pression immergeable à sécurité intrinsèque type IL-10
Sonda de pozo con seguridad intrínseca modelo IL-10
2WIKA operating instructions submersible pressure transmitter model IL-10
EN
DE
14161955.02 09/2018 EN/DE/FR/ES
ES
FR
© 06/2016 WIKA Alexander Wiegand SE & Co. KG
All rights reserved. / Alle Rechte vorbehalten.
WIKA®is a registered trademark in various countries.
WIKA®ist eine geschützte Marke in verschiedenen Ländern.
Prior to starting any work, read the operating instructions!
Keep for later use!
Vor Beginn aller Arbeiten Betriebsanleitung lesen!
Zum späteren Gebrauch aufbewahren!
Lire le mode d‘emploi avant de commencer toute opération !
A conserver pour une utilisation ultérieure !
¡Leer el manual de instrucciones antes de comenzar cualquier trabajo!
¡Guardar el manual para una eventual consulta!
Operating instructions model IL-10 Page 3 - 26
Betriebsanleitung Typ IL-10 Seite 27 - 50
Mode d‘emploi type IL-10 Página 51 - 74
Manual de instrucciones modelo IL-10 Page 75 - 99
3WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
Declarations of conformity can be found online at www.wika.com.
Contents
Contents
1. General information 4
2. Design and function 6
3. Safety 7
4. Transport, packaging and storage 15
5. Commissioning, operation 16
6. Faults 19
7. Maintenance and cleaning 21
8. Dismounting, return and disposal 22
9. Specications 23
Appendix: EU declaration of conformity 26
4WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
1. General information
■
The submersibel pressure transmitter described in the operating instructions has been designed and manufactured
using state-of-the-art technology. All components are subject to stringent quality and environmental criteria during
production. Our management systems are certied to ISO 9001 and ISO 14001.
■
These operating instructions contain important information on handling the instrument.Working safely requires that
all safety instructions and work instructions are observed.
■
Observe the relevant local accident prevention regulations and general safety regulations for the instrument's range
of use.
■
The operating instructions are part of the product and must be kept in the immediate vicinity of the instrument and
readily accessible to skilled personnel at any time.
■
Skilled personnel must have carefully read and understood the operating instructions prior to beginning any work.
■
The manufacturer's liability is void in the case of any damage caused by using the product contrary to its intended
use, non-compliance with these operating instructions, assignment of insuciently qualied skilled personnel or
unauthorised modications to the instrument.
■
The general terms and conditions contained in the sales documentation shall apply.
■
Subject to technical modications.
■
Further information:
- Internet address: www.wika.de / www.wika.com
- Relevant data sheet: PE 81.23
- Application consultant: Tel.: +49 9372 132-0
Fax: +49 9372 132-406
E-mail: info@wika.de
1. General information
5WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
Explanation of symbols
WARNING!
... indicates a potentially dangerous situation in the hazardous area that can result in serious injury or
death, if not avoided.
WARNING!
... indicates a potentially dangerous situation that can result in serious injury or death, if not avoided.
CAUTION!
... indicates a potentially dangerous situation that can result in light injuries or damage to equipment or
the environment, if not avoided.
Information
... points out useful tips, recommendations and information for ecient and trouble-free operation.
CAUTION!
... indicates a potentially dangerous situation that can result in burns, caused by hot surfaces or liquids,
if not avoided.
Abbreviations
2-wire Two connection lines are used for the voltage supply.
The measurement signal also provides the supply current.
U+/ S+Positive supply and output terminal
U- / 0V Negative power supply terminal
1. General information
6WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
2. Design and function
2.1 Overview
2.2 Description
The model IL-10 submersible pressure transmitter has been designed as an intrinsically safe pressure measuring
instrument and is used for the determination of the prevailing hydrostatic pressure.The analogue output signal is trans-
mitted via an intrinsically safe power and signal circuit (4 ... 20 mA current loop).
The stainless steel case protects the potted intrinsically safe electronics from environmental inuences. A process
connection with a protection cap at the bottom, along with the cable entry above are further components of the
submersible pressure transmitter.
2.3 Scope of delivery
Cross-check scope of delivery with delivery note.
2. Design and function
Cable
Product label (for details, see chapter 3.5)
Process connection with protection cap
7WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
3. Safety
3. Safety
WARNING!
Before installation, commissioning and operation, ensure that the appropriate submersible pressure
transmitter has been selected in terms of measuring range, design, media compatibility and specic
measuring conditions.
Non-observance can result in serious injury and/or damage to the equipment.
Further important safety instructions can be found in the individual chapters of these operating
instructions.
3.1 Intended use
The intrinsically safe submersible pressure transmitter is used in hazardous areas to convert hydrostatic pressure into
an electrical signal.
■
ATEX approval: Submersible pressure transmitter approved for use in hazardous areas (EU-type examination
certicate BVS 10 ATEX E 126 X downloadable from www.wika.com).
- Gases and mist: Mounting to zone 0 (EPL Ga/Gb); installation in zone 0 (EPL Ga), zone 1 (GPL Gb)
- Dusts: Mounting to zone 20 (EPL Da/Db); installation in zone 20 (EPL Da), zone 21 (EPL Db)
- Mining: Category M1 (EPL Ma)
■
IECEx approval: Submersible pressure transmitter approved for use in hazardous areas (certicate
IECEx BVS 10.0077X downloadable from www.wika.com).
- Gases and mist: Mounting to zone 0 (EPL Ga/Gb); installation in zone 0 (EPL Ga), zone 1 (GPL Gb)
- Dusts: Mounting to zone 20 (EPL Da/Db); installation in zone 20 (EPL Da), zone 21 (EPL Db)
- Mining: Category M1 (EPL Ma)
■
FM/CSA approval: Submersible pressure transmitter approved for use in hazardous areas (see control drawing
no. 2323880)
8WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
The submersible pressure transmitter has been designed and built solely for the intended use described here, and may
only be used accordingly.
The technical specications contained in these operating instructions must be observed. Improper handling or operati-
on of the instrument outside of its technical specications requires the instrument to be taken out of service immediate-
ly and inspected by an authorised WIKA service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended use.
3.2 Personnelqualication
WARNING!
Riskofinjuryshouldqualicationbeinsucient!
Improper handling can result in considerable injury and damage to equipment.
■
The activities described in these operating instructions may only be carried out by skilled personnel
who have the qualications described below.
■
Keep unqualied personnel away from hazardous areas.
Skilled personnel
Skilled personnel are understood to be personnel who, based on their technical training, knowledge of measurement
and control technology and on their experience and knowledge of country-specic regulations, current standards and
directives, are capable of carrying out the work described and independently recognising potential hazards.
Special operating conditions require further appropriate knowledge, e.g. of aggressive media.
3. Safety
9WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
3. Safety
3.3 Special conditions for safe use (ATEX and IECEx)
WARNING!
Non-observance of these instructions and their contents may result in the loss of explosion protection.
Gas application
■
The installation of the submersible pressure transmitter into the wall between areas that require EPL Ga equipment
must be made in such a way that ingress protection IP67 in accordance with EN 60529 is ensured.
■
When using the submersible pressure transmitter in areas that require EPL Ga, the shield of the connection lead
and the metallic part of the strain relief clamp must be included within the equipotential bonding of the vessel.
■
The tting of the cable entry of the instrument into the wall that separates areas with EPL Ga requirements from
less-hazardous areas must be made in such a way that ingress protection IP67 in accordance with EN 60529 is
ensured.
■
Observe the manufacturer's technical information for the use of the submersible pressure transmitter in combination
with aggressive and corrosive media and for avoiding mechanical hazards.
Dust applications
■
The submersible pressure transmitter must be mounted into the wall between areas that require EPL Da in such a
way that ingress protection IP6X in accordance with IEC 60529 is ensured.
■
When using the submersible pressure transmitter in areas that require EPL Da, the shield of the connection lead
and the metallic part of the strain relief clamp must be included within the equipotential bonding of the vessel.
■
The tting of the cable entry of the submersible pressure transmitter into the wall that separates areas with EPL Da
requirements from less-hazardous areas must be made in such a way that ingress protection IP6X in accordance
with EN 60529 is ensured.
■
Observe the manufacturer‘s technical information for the use of the submersible pressure transmitter in combination
with aggressive and corrosive media and for avoiding mechanical hazards.
10 WIKA operating instructions submersible pressure transmitter model IL-10
14161955.02 09/2018 EN/DE/FR/ES
EN
Safety-related maximum values (ATEX and IECEx)
Intrinsically safe supply and signal circuit (current loop 4 ... 20 mA)
Equipment protection level 2) Ma Ga, Ga/Gb, Gb Da, Da/Db, Db
Voltage Ui DC 30 V DC 30 V DC 30 V
Current Ii 100 mA 100 mA 100 mA
Power Pi 1 W 1 W 750/650/550 mW
Eective internal capacitance Ci 1) 16.5 nF + 0.1 nF/m 16.5 nF + 0.1 nF/m 16.5 nF + 0.1 nF/m
Eective internal inductance Li 1) 0 µH + 1 µH/m 0 µH + 1 µH/m 0 µH + 1 µH/m
1) For value see product label
2) Equipment Protection Level (EPL): The protection level that is dened for an instrument, where the degree of the probability of an ignition forms the basis.
Ambient temperature range, correlation to the instrument category, temperature class (ATEX and IECEx)
Model EPL Ambient and medium
temperature 1) Temperature class, surface
temperature
Model IL-10, with PUR cable Ma -30 ... +80 °C not applicable
Ga, Ga/Gb, Gb -30 ... +60 °C T6
-30 ... +80 °C T5
-30 ... +80 °C T4
Da, Da/Db, Db -30 ... +40 °C (750 mW) 120 °C
-30 ... +70 °C (650 mW) 120 °C
-30 ... +80 °C (550 mW) 120 °C
3. Safety
Otros manuales para IL-10
1
Tabla de contenidos
Idiomas:
Otros manuales de Transmisor de WIKA
WIKA
WIKA S-10 Manual de usuario
WIKA
WIKA AF-ADF Series Manual de usuario
WIKA
WIKA SL-1 Manual de usuario
WIKA
WIKA T19.10 Manual de usuario
WIKA
WIKA OT-1 Manual de usuario
WIKA
WIKA LH-20 Manual de usuario
WIKA
WIKA LH-20 Instrucciones de instalación
WIKA
WIKA S-10 Manual de usuario
WIKA
WIKA DPT-10 Manual de usuario
WIKA
WIKA HP-1 Manual de usuario
WIKA
WIKA ls-10 Manual de usuario
WIKA
WIKA R-1 Manual de usuario
WIKA
WIKA S-20 Manual de usuario
WIKA
WIKA UPT-20 Manual de usuario
WIKA
WIKA T24.10 Manual de usuario
WIKA
WIKA IS-3 Manual de usuario
WIKA
WIKA MH-2 Manual de usuario
WIKA
WIKA T32.1S.000-S Guía del usuario
WIKA
WIKA F-20 Manual de usuario
WIKA
WIKA OC-1 Manual de usuario
Manuales populares de Transmisor de otras marcas
Dejero
Dejero EnGo 3x Manual de usuario
Rosemount
Rosemount 4600 Manual de usuario
Speaka Professional
Speaka Professional 2342740 Manual de usuario
trubomat
trubomat GAB 1000 Manual de usuario
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Manual de usuario
Rondish
Rondish UT-11 Manual de usuario
