White Rodgers 1F51N-619 Manual de usuario

1F51N-619

LowVoltage

EvaporativeCoolerThermostat

INSTALLATION INSTRUCTIONS

PART NO. 37-6960A

0822

Operator: Save these instructions for future use!

This low voltage thermostat is designed to operate with

theWhite-Rodgers8A18Z-2EvaporativeCoolerControl.

For versatility, the thermostat subbase has a System

Switch that lets you select VENT, COOL or OFF posi-

tions. The Fan Switch offers the selection of LOW or

HIGH fan speed.

WARNING

If in doubt about whether your wiring is millivolt, line, or

low voltage, have it inspected by a qualified heating and

airconditioningcontractor,electrician,orsomeonefamil-

iar with basic electricity and wiring.

Do not exceed the specification ratings.

All wiring must conform to local and national electrical

codes and ordinances.

This control is a precision instrument, and should be

handled carefully. Rough handling or distorting compo-

nents could cause the control to malfunction.

Topreventelectricalshockand/orequipmentdam-

age, disconnect electric power to system, at main

fuse or circuit breaker box, until installation is

complete.

Do not short out terminals on gas valve or primary

control to test. Short or incorrect wiring will burn

out heat anticipator and could cause personal

injury and/or property damage.

Do not use on circuits exceeding 30 volts. Higher

voltagewilldamagecontrolandcouldcauseshock

or fire hazard.

PRECAUTIONS

FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY

BEFOREINSTALLING OROPERATING THISCONTROL COULDCAUSE

PERSONAL INJURY AND/OR PROPERTY DAMAGE.

DESCRIPTION

SPECIFICATIONS

THERMAL DATA

Temperature Scale Range: 1 to 5 (Cooler to Warmer)

Differential: 1°F

ELECTRICAL DATA

Switch Rating: 24VAC (30VAC max.)

Cooling - 0 to 1.5 Amps

Switch Action: SPST - Snap Action switch

ATTENTION!

This product does not contain mercury. However, this product may replace a unit which contains mercury. Do not open mercury cells. If a

cell becomes damaged, do not touch any spilled mercury. Wearing non-absorbent gloves, take up the spilled mercury with sand or other

absorbent material and place into a container which can be sealed. If a cell becomes damaged, the unit should be discarded. Mercury must

not be discarded in household trash. When the unit this product is replacing is to be discarded, place in a suitable container and refer to

www.white-rodgers.com for location to send the product containing mercury.

CAUTION

White-Rodgers is a division

of Emerson Electric Co.

www.white-rodgers.com

ATTACH SUBBASE TO WALL

1. Route wires from the cooling equipment to the thermostat

location and pull wires through hole in wall so that 6 inches

of cable protrudes.

2. Pull wires through opening near center of subbase and

connect wires beneath terminal screws as shown under

wiring.

3. Pushexcesswiringintowallandplugholewithfire-resistant

material (such as fiberglass insulation) to prevent drafts

from affecting thermostat operation.

4. Fastensubbaselooselytowall,asshown,usingtwomount-

ing screws. Place a level against bottom of subbase, adjust

until level, and then tighten mounting screws to secure

subbase.

ATTACH THERMOSTAT TO SUBBASE

1. Removecoverfrom thermostatbasebygrippingthebasein

one hand. Use the other hand to pull gently at the top or

bottom of the cover.

2. Carefully remove the shipping protective packing from the

switch.

INSTALLATION

CAPTIVE

SCREW

CAPTIVE

SCREWS

THERMOSTAT

BASE

COVER

MOUNTING SCREWS

SUBBASE

Y G

W R

HI LO COOL

OFF

VENT

COOLING

ANTICIPATOR

THERMOSTAT

SUBBASE

FAN

HI LO

SYSTEM

OFF COOL VENT

SUBBASE SWITCH POSITIONS SYSTEM FUNCTION

FAN

TIMER

RELAY

FAN

SPEED

RELAY

PUMP

RELAY

COMPONENT OPERATION

NO FAN - NO PUMP - NO COOL

COOLING MODE - Pump relay and Fan timer relay energized by

thermostat.Water begins circulating on cooler pads, fan will start

on low speed after short time delay.*

VENT MODE - Fan timer relay energized by thermostat. Fan speed

relay is energized by fan switch in "HI" position. Fan will start on

high speed after short time delay.*

VENT MODE - Fan timer relay energized by thermostat. Fan

will start on low speed after short time delay.*

COOLING MODE - Pump relay and Fan timer relay energized by

thermostat. Fan speed relay is energized by fan switch in "HI"

position.Water begins circulating on cooler pads, fan will start on

high speed after short time delay.*

In "HI" position - No fan, but fan speed relay will

remain energized

Indicates switch position on thermostat subbase and

system function in operation.

* Fan timer relay energizes in approximately one minute.When

system shuts off, relay de-energizes in approximately 1/2 minute.

3. Attach thermostat base to subbase, being sure that all

captive screws are tightened snugly, since they serve as

electrical connections between thermostat and subbase.

4. Snapcoveron thermostatbaseandsettemperatureleverto

desiredsetting.Thethermostatscalehasnumbersfrom 1to

5.The lowernumbersrepresent coolertemperature andthe

higher numbers represent warmer temperature.

WIRING

Take care when securing and routing wires so they

do not short to adjacent terminals or rear of ther-

mostat. Personal injury and/or property damage

may occur.

All wiring should be installed according to local

and national electrical codes and ordinances.

Refer to instruction sheet for 8A18Z-2, Evaporative

Cooler Control for typical system hookup.

OPERATION

The chart below illustrates system and thermostat function during various modes of operation.

The Emerson logo is a

trademark and a service mark

of Emerson Electric Co.

Tabla de contenidos

Otros manuales de Termostato de White Rodgers

White Rodgers

White Rodgers 1F58-72 Manual de usuario

White Rodgers

White Rodgers 1F86-0244 Manual de usuario

White Rodgers

White Rodgers 1F82-0261 Manual de usuario

White Rodgers

White Rodgers SuperStat Pro SuperStat Pro Programmable... Manual de usuario

White Rodgers

White Rodgers 1F96 Series Manual de usuario

White Rodgers

White Rodgers 1F85RF-275 Manual de usuario

White Rodgers

White Rodgers 775 Manual de usuario

White Rodgers

White Rodgers 1F86-0244 Manual de usuario

White Rodgers

White Rodgers 1F87-361 Manual de usuario

White Rodgers

White Rodgers 1F70 Manual de usuario

White Rodgers

White Rodgers 1F80-240 Manual de usuario

White Rodgers

White Rodgers 1F86-344 Manual de usuario

White Rodgers

White Rodgers 1F95-1271 Manual de usuario

White Rodgers

White Rodgers UP310 Manual de usuario

White Rodgers

White Rodgers 500 Manual de usuario

White Rodgers

White Rodgers 1F82-261 Manual de usuario

White Rodgers

White Rodgers 1F90-71 Manual de usuario

White Rodgers

White Rodgers 1E56 Manual de usuario

White Rodgers

White Rodgers 1F62-21 Manual de usuario

White Rodgers

White Rodgers 1F83-51 Manual de usuario

White Rodgers

White Rodgers 1F81-71 Manual de usuario

White Rodgers

White Rodgers 1F80-241 Manual de usuario

White Rodgers

White Rodgers 1.00E+78 Manual de usuario

White Rodgers

White Rodgers 1F80-261 Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Honeywell

Honeywell CM721 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

Honeywell

Honeywell RLV4305 Manual de usuario

Honeywell

Honeywell Prestige 2.0 THX9421 Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario