Whirlpool VS2511 Manual de usuario
產品安全指引及使用說明指南
VS2511
2
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
WARNING : To reduce the risk of fire, electric shock,
or injury:
1. Do not pick up detergent, kerosene, blizzard, nee-
dle, ash, wet dust, dirty water and match, etc. with
the vacuum cleaner.
2. To avoid filter blockage and motor damage, do not
pick up granule such as cement, land plaster, and
spitball.
3. Keep the vacuum cleaner away from fire and the
place of high temperature.
4. Caution: Always use the vacuum cleaner should be
assembled with HEPA and roller brush before op-
eration.
5. To avoid short circuit, keep the vacuum cleaner
away from water.
6. Recharge the battery when use it first time or the
battery is used up. Keep recharge and discharge
once three months when do not use it in long pe-
riod.
7. Unplug the plug when the vacuum cleaner recharge
finished, or during cleaning and maintenance.
8. When cleaning the vacuum cleaner, please use dry
cloth; do not use petrol and lacquer thinner which
will damage the surface.
3
9. Do not use if the plug or cord is damaged.
10. Switch the appliance off after use.
11. The charging base requires a 100-240V~, 50/60 Hz
supply. Do not use any other power source.
12. Only the supplied charging base should be used
with the appliance.
13. Never suck up water or any other liquid. Never suck
up flammable substances and do not suck up ash-
es until they are cold.
14. Do not immerse the body of the cleaner or the elec-
trical cord or plug in water or liquids.
15. Do not use attachments or accessories not recom-
mended by the manufacturer.
16. Close supervision is necessary when an appliance
is used near children. Children should not operate
this appliance.
17. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety.
18. Children should be supervised to ensure that they
do not play with the appliance.
19. This appliance is for household use. Do not use for
any purpose not expressly specified in this manual.
20. There are no user serviceable parts in this appli-
ance. Unauthorised dismantling or servicing will
void the warranty.
21. Store the appliance away from direct sunlight, with all
accessories detached and out of the reach of children.
4
22. Caution: Only charge the vacuum cleaner with the
Charging bracket supplied. During charging, the
plug feels warm to the touch. This is normal.
23. Caution: Never block the exhaust air openings dur-
ing vacuuming.
24. Caution: Switch off the appliance when you re-
charged it.
SAVE THIS INSTRUCTIONS
THIS CLEANER WORKS BY SUCKING AIR AT HIGH
PRESSURE THROUGH A POWERFUL MOTOR. FOR EF-
FICIENT AND SAFE OPERATION IT IS ESSENTIAL
THAT ALL THE AIRWAYS AND FILTERS ARE CLEANED
AT REGULAR INTERVALS AND THAT THE DUST IS
EMPTIED BEFORE THE DUST CONTAINER IS FULL
AND AFTER EVERY USE OF THE APPLIANCE.
FAILURE TO CLEAN THE FILTERS AND EMPTY THE
DUST CONTAINER WILL RESTRICT THE AIRFLOW. THIS
WILL RESULT IN POOR CLEANER PERFORMANCE.
LONG TERM NEGLECT WILL BLOCK THE AIRFLOW
AND MAY DAMAGE THE CLEANER BEYOND REPAIR.
ANY DAMAGE CAUSED BY FAILURE TO CLEAN THE
FILTERS, AIRWAYS AND DUST CONTAINER AS SPECI-
FIED IN THESE INSTRUCTIONS WILL NOT BE COV-
ERED BY THE WARRANTY.
IMPORTANT NOTICE - PLEASE READ BEFORE USING
THIS PRODUCT!
5
1. Check the rating label of Bed Cleaner matches the
dedicated Handheld unit.
2. This Bed Cleaner is intended for normal household
use only. Do not use the appliance outdoors. Do not
use the appliance for other uses than its intended
use.
3. To protect against electrical shock, do not immerse
the Bed Cleaner in water or other liquids.
4. Do not store the Bed cleaner in areas with high
temperature, keep it away from heat sources such as
radiators or gas/electric fires.
5. If a blockage is found in the rotating brush, it should
be removed before use.
6. Do not continue to operate the appliance if you are in
any doubt about it working normally (e.g. abnormal
noise, smell, smoke), or if it is damaged in any way -
switch off, withdraw the mains plug and consult your
dealer.
7. The use of accessories not recommended by the
appliance manufacturer may cause injuries.
8. Never touch the appliance itself with wet hands.
9. Do not point the appliance at the eyes, ears or mouth
during operation.
10. Do not watch the power-on UV lamp directly, it may
cause damage to vision.
IMPORTANT SAFETY INSTRUCTIONS
(for Bed Cleaner)
6
1. ON/OFF switch
2. ECO speed switch
3. Foldable handle release
button
4. Handheld release button
5. Motorized brush
release button
UPRIGHT UNIT:
PRODUCT OVERVIEW
6. LED light
7. Motorized brush
8. Folding handle
9. Handheld handle
10. Handheld unit
11. Charging bracket
1
2
3
4
5
6
7
8
9
10
11
7
HANDHELD UNIT:
PRODUCT OVERVIEW
12. ON/OFF switch
13. Battery/ Charging indicator
14. Dust container release button
15. Seal ring
16. HEPA filter
17. Outer filter
18. Dust container
19. Adaptor
12
13
14
16
15
17
18
19
20
21
22
23
24
or
20. Extended crevice tool
21. Wide brush / Upholstery
adaptor
22. Wide brush
23. Upholstery
24. Flexible hose
8
APPLICATION OF ACCESSORIES
Adaptor:
Insert the Adaptor [19] into the inhale handheld nozzle of dust
container. It acts as an adaptor for the connection of accessories
for different purposes. To remove the Adaptor from dust container
just pull firmly outward.
Extended Crevice Tool:
Connect [20] Extended Crevice Tool is for cleaning small areas
which are difficult to reach, such as corners, gaps, holes, etc.
Wide Brush:
Insert and slide [22] Wide Brush into [21] Wide brush / Upholstery
adaptor. The Wide Brush is applicable for cleaning uneven surfaces,
such as hair, fibers, carpets, etc.
Upholstery:
Insert and slide [23] Upholstery into [21] Wide brush / Upholstery
adaptor. The Upholstery is applicable for cleaning textile surface,
such as shirts, curtain, bedding, etc.
Flexible hose:
Connect the Flexible hose [24] to accessories and Adaptor [19] at
both ends. The extension hose allows the vacuuming flexiblity to
reach some narrow and hidden areas.
9
Foldable Handle
PRODUCT ASSEMBLING
To lower the handle, press the
folding handle release button.
• Charging bracket assembly must be placed on a flat ground, mounting
screws and plastic wall anchors can fix the charging bracket on the wall.
• Mounting screws and plastic wall anchors are placed at the bottom
of the charging bracket. Drill the holes on the wall and put the plastic
wall anchors into holes, and then fixed the charging bracket with
mounting screws.
Off
Lift the handle to an upright
position, the handle will lock
automatically.
Assembling the Charging bracket
Wall Mount Hole
Mounting Screws
Plastic Wall Anchors
Detachable Motorized Brush Motorized Brush
LED Light
Motorized Brush
Release Button
Press
10
1. Insert the handheld unit to the upright unit
Make sure the upright unit is switched OFF. Avoid
any obstacles in between the hand-held unit and
the upright unit.
2. Attach the upright unit onto the charging bracket
˙Make sure the charging bracket is placed on a flat stable floor.
˙Attached the upright unit onto the charging bracket.
˙If the upright unit is not attached to the charging
bracket properly, charging will not start.
˙Avoid any dust in between the charging bracket
and the unit, clean the contacts if necessary.
˙Be careful of the unit will be tripped
over by the power cable during charging.
˙The charging indicator will illuminate red to
indicate that the vacuum cleaner is being charged.
NOTE: The charging indicator will turns to blue
when the battery is fully charged.
HINT: It is recommended to charge the vacuum
cleaner for at least 6 hours for before use.
˙It is normal that the charging bracket and the unit
will get warm while charging.
˙Even if the switch button is turned on, put the
vacuum cleaner back into the charging bracket,
the vacuum cleaner will be automatically stop working.
˙During the battery recharge process on charging bracket, the vacuum
cleaner has the circuitry protect feature. Even press on the switch
button, the product will be still in power-o mode.
3. Connect the power cable to the main socket
Socket for
Adaptor
Charge the battery when:
˙using the product for the first time
˙after not using the product for a long period of time
˙
when the unit is at low power and the battery/ charging indicator flashes red.
Light
on
Charging the Vacuum Cleaner
PRODUCT CHARGING
Tabla de contenidos
Otros manuales de Aspiradora de Whirlpool
