WAVESTREAM JNB-KAM050-HS00 Manual de usuario

December 2007 Page 1 90-005-0003 Rev X01

50 Watt

Ka-band

Grid Amplifier™

BUC

User Manual

50 Watt Ka Feedmount BUC User Manual

December 2007 Page 2 90-005-0003 Rev X01

About This Handbook

This document describes Wavestream’s 50 Watt Ka-band Grid Amplifier™

Block Upconverter (BUC) herein referred to as “the Unit”.

Updated documentation may be available on our website at

www.wavestream.com or from Wavestream’s sales group

[email protected].

This User Manual covers installation and configuration of the 50W Ka-band

Grid Amplifier BUC, models JNB-KAM050-HS00 and JNB-KAM050HE00.

Separate manuals cover other Wavestream products.

Notices

Wavestream document 90-005-0003

WavestreamTM, Spatial Power AdvantageTM, PowerstreamTM, Grid AmplifierTM

and the Wavestream logo are trademarks of the Wavestream Corporation. All

other trademarks are properties of their respective owners.

The information provided in this User Manual is being provided by

Wavestream Corporation as a service to our customers. Although every effort

has been made to verify the completeness and accuracy of the information

contained in this manual, due to the highly technical nature of the material,

and the dynamic nature of the satellite communications, Wavestream cannot

be responsible for any errors and omissions.

50 Watt Ka Feedmount BUC User Manual

December 2007 Page 3 90-005-0003 Rev X01

CONTENTS

INTRODUCTION .................................................................................................5

SAFETY...............................................................................................................8

SYSTEM DESCRIPTION...................................................................................12

SPATIAL POWER COMBINING................................................................................................... 12

INTERFACES.................................................................................................................................... 14

“IF /REF IN”CONNECTOR (J1) .................................................................................................. 14

“RF OUT”CONNECTOR (J2)....................................................................................................... 14

“120VAC IN”CONNECTOR (J3).................................................................................................. 14

Prime Power Interface Pinout:........................................................................................... 15

MONITOR AND CONTROL INTERFACE (J4)................................................................................. 15

Monitor and Control Interface Pinout:............................................................................. 16

GROUND STUD.............................................................................................................................. 17

MOUNTING INTERFACE ............................................................................................................... 17

OUTLINE DRAWINGS.................................................................................................................... 18

ADDITIONAL INFORMATION..................................................................................................... 20

CONNECTING AND CONFIGURING THE UNIT..............................................21

UNPACK THE UNIT:....................................................................................................................... 21

INSPECT INTERFACES ................................................................................................................. 22

PERFORM CONTINUITY CHECK ON THE CABLES.............................................................. 22

INSTALL THE UNIT........................................................................................................................ 22

TROUBLESHOOTING ......................................................................................24

TECHNICAL SPECIFICATIONS.......................................................................25

SPECIFICATIONS FOR GBE-300310-50-NW-AC....................................................................... 25

RF OUTPUT .................................................................................................................................. 25

IF INPUT ....................................................................................................................................... 26

INTERFACES ................................................................................................................................. 26

ENVIRONMENTAL SPECIFICATIONS ............................................................................................ 26

MECHANICAL SPECIFICATIONS................................................................................................... 27

POWER SPECIFICATIONS ............................................................................................................. 27

December 2007 Page 4 90-005-0003 Rev X01

50 Watt Ka Feedmount BUC User Manual

MAINTENANCE ................................................................................................28

FAN ASSEMBLY REPLACEMENT PROCEDURE.................................................................... 28

TOOLS REQUIRED ........................................................................................................................ 28

PROCEDURE ................................................................................................................................. 28

SERIAL M&C PROTOCOL...............................................................................29

50 Watt Ka Feedmount BUC User Manual

December 2007 Page 5 90-005-0003 Rev X01

INTRODUCTION

This User Manual provides

information and instructions for

installation and operation of

Wavestream equipment.

This User Manual is intended for use

by trained field technicians or

system engineers responsible for

satellite networks.

Updates to this User Manual may be

published. Access current versions

of this and other Wavestream

documentation by contacting

[email protected]

This section includes:

•Introduction

•Warranty information on the

Wavestream equipment.

•Instructions for getting

technical support for

Wavestream equipment.

This User Manual is for the Wavestream GBE-300310-50-NW-AC, a Ka-Band Grid

Amplifier Block Up Converter (BUC), herein referred to as “the Unit”. The Unit

receives an L-Band input (1000-2000MHz) and transmits a 50 Watt Ka-Band output

(30.0-31.0GHz).

The Unit comes in a single weatherized housing rated for indoor or outdoor use. It

has an N-Type input and a WR28 waveguide output, a 120VAC Power input and a

Monitor and Control connector. The Monitor and Control functions allow the user to

enable and disable the internal amplifiers without shutting off the power supplies as

well as to monitor the status of the Unit.

Warranty

The Wavestream warranty is defined in the Terms and Conditions of Sale that

accompanied the quotation and purchase order. In the event that the Unit

needs to be returned to Wavestream for repair, contact your customer service

representative at Wavestream. If you purchased this Unit from a distributor,

follow the distributor’s RMA process.

December 2007 Page 6 90-005-0003 Rev X01

50 Watt Ka Feedmount BUC User Manual

The warranty does not apply to any defect, failure or damage caused by

improper use or inadequate or improper maintenance and care.

Not withstanding the Warranty defined in the Terms and Conditions

of Sale, Wavestream is not obliged to furnish service under this

warranty:

•to repair damage resulting from attempts by personnel other than

Wavestream to repair, or service the product

•to repair any damage or malfunction caused by the use of non-

standard ancillary equipment

•to service a product that has been modified or integrated with other

products if this modification has not been approved previously in

writing by Wavestream

OPENING OR REMOVING ANY COMPONENT OR SEALED AREA (WITH THE

EXCEPTION OF THE FAN ASSEMBLY) WILL IMMEDIATELY VOID THE

WARRANTY

Technical Support

In the event you need technical information or operation support beyond the

scope of this User Manual, contact Wavestream support at

[email protected].

Equipment Service

Under all circumstances, contact Wavestream or your distributor for service.

A replacement fan assembly can be purchased from Wavestream.

With the exception of replacing the fans, do not attempt to service the

equipment yourself.

Safety Tip: Opening or removing the cover of the Unit may

expose you to dangerous voltages, high power RF energy or

other hazards as well as void your warranty.

December 2007 Page 7 90-005-0003 Rev X01

50 Watt Ka Feedmount BUC User Manual

Notice

For the proper operation of this equipment and/or all parts thereof, the

instructions in this guide must be strictly and explicitly followed. All of the

contents of this guide must be fully read and understood prior to operating

any of the equipment or parts thereof.

Failure to completely read and fully understand and follow all of the contents

of this guide prior to operating this equipment, or parts thereof, may result in

damage to the equipment or parts, and to any persons operating the same.

Wavestream does not assume any liability arising out of the application or use

of any products, component parts, circuits, software, or firmware described

herein. Wavestream further does not convey any license under its patent,

trademark, copyright or common-law rights nor the similar rights of others.

Wavestream further reserves the right to make any changes in any products,

or parts thereof, described herein without notice.

Caution: This equipment generates, uses, and radiates radio

frequency energy. This can present a safety hazard if not

handled safely per the precautions identified in Section 2.

50 Watt Ka Feedmount BUC User Manual

December 2007 Page 8 90-005-0003 Rev X01

SAFETY

This Unit contains delicate

electronics, electrical components

and high radiated RF power.

Follow all safety precautions in

this section when the Unit is in

operation.

Carefully read and follow all

safety, use, and operating

instructions before operating the

Unit. Retain these instructions for

future reference.

This section includes:

•Safety considerations for use of

the Unit.

Safety Precautions

Use safety precautions when working at or near the Unit as described in these

sections.

Warning: Shock Hazard

Do not open the equipment. High voltages are present under

the lid of the Unit. Service is only to be performed by

Wavestream.

With the exception of the fan assembly, the Unit contains no

user serviceable parts. Do not attempt to service this product

yourself. Any attempt to do so voids any and all warranties.

December 2007 Page 9 90-005-0003 Rev X01

50 Watt Ka Feedmount BUC User Manual

Warning: High Power RF Hazard

Do not operate unless the RF output waveguide flange is

properly connected to the rest of the system or to a high power

load. The unit emits high power RF energy which could

be harmful to the human body.

When operating the equipment, never place personnel or any

object in front of or near the output waveguide opening.

Caution: Electrostatic Sensitive Devices

Be aware that there are devices in the Unit that are easily

damaged by ESD. Take standard ESD precautions when

handling the Unit.

When operating the Unit, observe these precautions:

Follow the connection

procedure described in this

manual in Section 4,

entitled “Install the Unit”.

Do not apply power to the Unit until

the Unit is appropriately connected to

the feed and antenna system or a high

power load. The Unit radiates

high energy RF.

Avoid Water and Moisture

on Connectors

The IF input, Power, M&C connections

should be tightly connected and sealed

against outside moisture using good

commercial practice and UV-rated

materials. Care should be taken on

the installation of an “O” ring for the

WR28 waveguide connection to

prevent contaminants from entering

the interface and to avoid pinching of

the gasket.

December 2007 Page 10 90-005-0003 Rev X01

50 Watt Ka Feedmount BUC User Manual

Provide Adequate Ventilation Since the Unit uses forced air

convection for cooling, it relies on

proper ventilation to ensure reliable

operation. The Unit draws air in

from the front side (face with

connectors on it) and exhausts air

to the back side.

THE VENTILATION MUST NOT

BE BLOCKED

To avoid overheating and ensure

that the ventilation slots are not

blocked, place the Unit at least 2

inches from any object that could

obstruct air flow.

If the Unit is placed in a closed

area, such as a building or radome,

ensure that proper ventilation is

provided and that the air

temperature does not exceed the

maximum rated temperature.

Use the Correct Power Source

To prevent damage to the Unit,

ensure that the applied AC power is

within the range of 90-264VAC.

Route Power Cords Safely Route power cords so that they are

not walked on or pinched. Pay

particular attention to cords and

connections at the plugs,

receptacles, and the point where

they exit from the Unit and attach

to other equipment. Do not place

any items on or against power

cords.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario