AERCO ProtoNode FPC-N34 & FPC-N35 User Manual
User Manual
Page 4of 108 AERCO International, Inc. •100 Oritani Dr. •Blauvelt, NY 10913 OMM-0107_0B
03/07/2017Ph.: 800-526-0288 GF-150
OMM-0107
GF-150
CHAPTER 8. CAS BACnet Explorer for Validating ProtoNode in the Field............................. 37
8.1 Downloading the CAS Explorer and Requesting an Activation Key........................................37
8.2 CAS BACnet Setup................................................................................................................38
8.2.1 CAS BACnet MS/TP Setup.................................................................................................................. 38
8.2.2 CAS BACnet BACnet/IP Setup............................................................................................................ 39
Appendix A: “A” Bank DIP Switch Settings.......................................................................................... 41
Appendix B: AERCO Equipment Monitor and Control Point Definitions...................................... 45
Appendix B-2: AERCO Electronic Control System (ECS) Point Definitions..................................48
Appendix B-3: AERCO (Modulex) BCM Point Definitions............................................................48
Appendix B-4: Water Heater Management System (WHM) and On-Board Boiler Sequencing
Technology (BST) Point Definitions..............................................................................................50
Appendix B-5: AM Series Point Definitions..................................................................................53
Appendix C: AERCO Equipment Point Mappings.............................................................................. 57
Appendix C-1: AM Mngr Modbus RTU Mappings to BACnet MS/TP, BACnet/IP, Metasys N2,
Modbus TCP/IP and LonWorks...................................................................................................57
Appendix C-2: AM Dep Modbus RTU Mappings to BACnet MS/TP, BACnet/IP, Metasys N2,
Modbus TCP/IP and LonWorks....................................................................................................61
Appendix C-3: C-More Modbus RTU Mappings to BACnet MS/TP, BACnet/IP, Metasys N2,
Modbus TCP/IP and LonWorks....................................................................................................63
Appendix C-4: Modulex Modbus RTU Mappings to BACnet MS/TP, BACnet/IP, Metasys N2,
Modbus TCP/IP and LonWorks....................................................................................................63
Appendix C-5: ECS Modbus RTU Mappings to BACnet MS/TP, BACnet/IP, Metasys N2, Modbus
TCP/IP and LonWorks .................................................................................................................64
Appendix C-6: ACS/BMSII/BMS Modbus RTU Mappings to BACnet MS/TP, BACnet/IP, Metasys
N2, Modbus TCP/IP and LonWorks .............................................................................................65
Appendix D: Eight C-More Boilers/Heaters and BST/WHM Master............................................... 67
Appendix E: Troubleshooting..................................................................................................................... 77
Appendix E-1: Viewing Diagnostic Information............................................................................77
Appendix E-2: Check Wiring and Settings...................................................................................78
Appendix E-3: Diagnostic Capture with the FieldServer Utilities..................................................79
Appendix E-4: BACnet: Setting Network_Number for more than one ProtoNode on Subnet.......82
Appendix E-5: LED Diagnostics for Modbus RTU Communications Between ProtoNode and
Devices 83
Appendix E-6: Passwords..........................................................................................................84
Appendix F: C-More Status And Fault Messages ................................................................................... 85
Appendix G: Conversion Equations For Temperature Variables.................................................... 91
Appendix H: BCM and BMM Fault Codes For Modulex E8 Controller............................................. 93
Appendix H-1: BCM and BMM Fault Code Conversion Table .....................................................93
Appendix H-2: BMM Fault Code Table........................................................................................94
Appendix H-3: BCM Fault Code Table ........................................................................................96
Appendix I: AM Error, State and Status Tables..................................................................................... 98
Appendix I-1: AM Lockout Error Codes Table ..............................................................................98
Appendix I-2: AM Blocking Error Codes Table .............................................................................99
Appendix I-3: AM State Parameters Table.................................................................................100
