10
CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056
Selecting the Temperature:
• Once the desired heat setting has been
activated, the actual heating temperature
within the selected range can be adjusted
using the unit’s thermostat dial.
• Rotate the thermostat dial clockwise (to
the right) to increase the temperature, or
counter-clockwise (to the left) to decrease
it.
NOTE: The thermostat dial must be rotated
clockwise before heat begins emitting from the
unit. There will be a clicking sound to indicate
the heating function has been activated. The
same clicking sound will indicate the heating
function has been turned o when the dial is
rotated counter-clockwise.
NOTE: Once the desired ambient temperature
is reached, the heater will automatically stop
heating. Whenever the ambient temperature
drops more than 2°C below the desired
temperature, the heater will resume operation.
Safety Cut-Out:
• This appliance is tted with a safety cut-
o device, which will operate if the re
overheats (e.g. due to blocked air vents).
For safety reasons, the re will NOT
automatically reset.
• To reset the appliance, disconnect the
appliance from the mains supply for at
least 15 minutes. Reconnect to the mains
supply and switch on the appliance.
• If the re fails to operate, check the fuse in
the plug. If the fuse in the plug is OK and
the re is still not functioning, contact a
qualied service person.
CAUTION! Do not touch the re as it will be
hot. Set the heater switches to OFF and leave
the re to cool down fully. Once completely
cool, reconnect the heater and switch it on.
Do not open this product. There are no user-
serviceable parts inside.
CHECK THAT YOU HAVE NOTED ALL THE
FOLLOWING INSTRUCTIONS:
Do:
• Always install the re in accordance with
this guide. If in doubt obtain expert advice.
• Always make sure the electrical socket is
accessible and located adjacent to, but
not above or behind the re.
• Always disconnect the re from the
electrical supply before carrying out
cleaning or maintenance.
• Always make sure the re is rmly
secured.
• Always assemble the re in accordance
with this guide. If in doubt, obtain expert
advice.
• Always ensure the product is assembled
in an area that is free from dust, grease or
liquids.
• Always ensure that the correct tools are
used to assemble/install this product.
• Always make sure the re is rmly secured
in place when complete.
Don’t:
• Never leave children unsupervised in a
room where the re is ON and unguarded.
• Never obstruct or cover the fan outlet or
force items into the re openings.
• Never install or use the re anywhere
where water is in use, i.e. bathrooms,
kitchens, shower rooms, swimming pools
etc.
• Never use aerosols or steam cleaners on
or around the re.
• Never route the mains supply cable under
carpet etc.
• Never install the re close to curtains or
combustible materials.
• Never use the re to dry clothes etc.
• Never sit or stand on the re.
• Never cut the o the plug and hard wire
into a xed fused spur.
