Wagan Elite 700W PRO Manual de usuario

Item No. / Artículo No/ Article n° : 2602

Elite™700W PRO

DC to AC Pure Sine Inverter

Inversor de onda senoidal pura de CC a CA

Onduleur sinusoïdal CC/CA

User’s Manual / Manual de Usuario / Guide d’Utilisation

Elite™ 700W PRO by Wagan Tech®

1www.wagan.com

INTRODUCTION

Thank you for purchasing this Wagan Tech®Elite™700W PRO Pure Sine Wave

DC to AC Power Inverter.

The Elite PRO™represents numerous improvements to our standard pure sine

that meet the needs of more demanding environments—delivering clean, quality

power at an affordable price. It delivers a true AC sine wave identical to that

of commercial power. Use this inverter to power AC appliances in your

vehicle or off-grid backup power systems. Pure Sine Wave AC means that

your sensitive electronics, such as audio/video systems, computers, and

communications equipment will operate properly. Furthermore, appliances with

motors operate cooler, quieter, and more efﬁciently when they are powered by

pure sine wave AC.

This inverter is powered from 12-volt DC and it will continuously deliver 700

watts (1,400 watts momentary peak) AC power at 120 volts, 60 Hz. Superior

surge capability of 1,400 watts allows the inverter to start most difﬁcult

motorized appliances. Advanced microprocessor-controlled circuits run cooler

and are more reliable than competing units. The DC terminals have been

designed apart from each other to ease installation and minimize the risk of

accidental shortage when handling the DC cables.

The Elite 700W PRO operates at high efﬁciency (up to 90%), that results in long

run time and extended battery life compared to other inverters with this level of

power output. This inverter bonds neutral to ground, just like utility power.

A 2.1A USB power port provides a convenient way to power USB appliances

or charge smartphones, tablets and e-readers, and other mobile electronic

devices.

This inverter is supplied with a power adapter cord that connects the inverter

to a DC power supply wtih battery terminal clips. The Elite 700W PRO comes

with a separate ground terminal typically found on higher capacity units. This

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

www.wagan.com

terminal helps to reduce the noise caused by power conversion when using

radio frequency devices.

The enclosure vents have been minimized to reduce the risk of pest intrusion

in arid tropical climates. This Wagan 700W PRO Pure Sine Wave Inverter is

an indispensable addition to compliment your mobile power equipment. With

minimal care and proper treatment, it will provide years of reliable service.

Read and understand this manual before installing and operating this inverter.

Keep this manual for future use.

WARNING

INVERTER OUTPUT CAN BE LETHAL. IMPROPER USE OF THIS

INVERTER MAY RESULT IN PROPERTY DAMAGE, PERSONAL INJURY

OR LOSS OF LIFE.

• Keep the inverter away from any direct heat source or combustible

materials.

• Keep well ventilated—this device generates heat.

• Keep this inverter in a dry environment.

• Do not operate any equipment over 700 watts.

• This inverter is designed to operate from a 12 volt DC power source only.

• Do not attempt to connect the inverter to any other power source, including

any AC power source.

• Incorrect battery polarity will damage the inverter and void the warranty.

• Do not open the inverter, there are no user serviceable parts inside.

• This inverter has one supplied power adapter cord that has battery clips for

up to 700 watts.

Elite™ 700W PRO by Wagan Tech®

3www.wagan.com

FRONT PANEL

AC Outlet

Power LED Fault LED On/Off Switch

AC Outlet

USB Power Port

Ground

Terminal

• ON/OFF Switch — This switch controls AC output of the inverter.

• Operating LED (Green) — When this green LED is lit, the inverter is

operating normally.

• FAULT LED (Red) — The RED indicator turns on as the inverter shuts down

due to overheating, overload, under voltage, or over voltage.

Immediately turn off all AC appliances if the FAULT LED is lit. Allow the

inverter to cool before continuing. Make sure that the ventilation vents

are not blocked.

If an inverter shutdown was preceded by a buzzing sound, there may be

an excessive load in combination with a low voltage or cable problem.

• AC Outlets — These two outlets, combined, can supply power up to 6.0

amps at 120V AC 60 Hz.

• USB Power Port — This power port can supply 5 volts at 2.1A for charging

or powering smartphones, tablets and e-readers, MP3 players, GPS and

other small electronic devices.

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

www.wagan.com

• Audible Alarm (internal to the inverter) — The alarm makes a buzzing

sound when the inverter senses a low battery condition. The user should

reduce the AC load, charge the battery, and check the DC cable for

excessive losses.

• Ground Terminal — For attaching an insulated safety ground wire. This

safety wire is for protecting personnel if there is an unlikely failure in either

the cabling or enclosure insulation.

REAR PANEL

Cooling Fan Cooling Fan

Negative (−)

Terminal

[Black]

Postive (+)

Terminal

[Red]

• Positive Terminal — Positive (+) DC Input (Red)

• Negative Terminal — Negative (−) DC Input (Black)

• Cooling Fan — High-speed and load controlled

LOAD CONSIDERATIONS

The startup load of an appliance is a major factor of whether this inverter

can power it. This initial load is only momentary. With many appliances, it is

approximately twice the continuous load, but some appliance startup loads can

be as high as eight times the continuous load.

Elite™ 700W PRO by Wagan Tech®

5www.wagan.com

To determine if an appliance or tool will operate with this inverter, ﬁrst run a

test. The inverter will automatically shut down in the event of an output overload

so there is no danger of damaging either the inverter or the equipment. When

the red LED indicator is lit, the inverter is signaling a fault.

DETERMINING MAXIMUM APPLIANCE WATTAGE

Do not exceed the 700 watt maximum AC load or the inverter will shut down.

Most electrical tools, appliances, and audio/video equipment have labels that

list the unit’s power requirements in watts. If the tool or device is rated in amps,

multiply the amps by 120 (120V AC) to determine the watts. For example, an

appliance rated at 0.5 amps will draw 60 watts.

WATTS = VOLTS × AMPS

Remember to consider the startup surge that motorized appliances will cause.

Do not exceed the 1400 watt momentary surge rating of this inverter. This can

cause immediate overload shut down and or blow a fuse.

CONNECTING THE INVERTER

Battery Clip Adapter Cord – Up to 700 Watts Output

1. Connect an insulated copper wire to the ground terminal. The other end

of the ground wire should be connected to a proper grounding point. Use

the shortest practical length of wire. Connect this wire to the chassis of

your vehicle or to the grounding system in your boat. In a city, the ground

wire can connect to a metal cold water pipe that goes underground. In

remote locations, the ground wire can be connected to an earth ground.

In the unlikely event of a short circuit, operating the inverter without proper

grounding can result in electric shock. Do not directly connect this ground

wire to the negative DC terminal

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

www.wagan.com

2. Connect just the red terminal of the supplied DC Battery Clip Adapter Cord

to the red stud terminal (+) on the rear end of the inverter.

3. Connect the two battery clips to the battery.

Be sure to connect the clips to the correct polarity battery terminals.

Reverse polarity connection will blow the fuse in the inverter and can

permanently damage to the inverter. Damage caused by reverse polarity

will void the warranty.

4. Connect the Negative black (−) connector to the stud connector on the rear

end of the inverter. There may be a momentary spark and the low voltage

buzzer may brieﬂy sound.

5. Plug the AC appliance cord into the inverter’s AC outlet, and/or your USB

appliance into the USB power port.

6. Place the ON/OFF power switch in the “ON” position. The green LED

should turn on, indicating the inverter is powered and operating normally.

7. When the inverter is not in use, place the inverter’s ON/OFF Power Switch

to the OFF position.

Battery Clip Adapter Cord

Elite™ 700W PRO by Wagan Tech®

7www.wagan.com

OPERATING ISSUES: TELEVISION AND AUDIO EQUIPMENT

SUGGESTIONS.

Although all inverters are shielded and ﬁltered to minimize signal interference,

some interference with your television picture may be unavoidable, especially

with weak signals. However, here are some suggestions that may improve

reception.

• Make sure that the television antenna produces a clear signal under normal

operating conditions (i.e. plugged into a standard AC wall outlet). Also

ensure that the antenna cable is of good quality and properly shielded.

• Sometimes vehicle alternators produce electrical noises. There are ﬁlters

available to mount on the alternator for noise reduction.

• Change the positions of the inverter, antenna cables, and television power

cord.

• Isolate the television, its power cord, and antenna cables from the 12

volt power source by running an extension cord from the inverter to the

television.

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit

Reason Solution

Poor contact with battery or inverter

terminals.

Clean terminals thoroughly. Reinstall

and tighten.

Wagan Tech and wagan.com are trademarks used by Wagan Corporation.

User’s Manual—Read before using this equipment

www.wagan.com

PROBLEM: No Output Voltage – No LEDs Lit

Reason Solution

Blown fuse. Check fuse. If the fuse is blown,

replace with the same type and

rating fuse.

PROBLEM: Inverter Auto Shut Down – Fault LED Lit

Reason Solution

Battery voltage is below 9.5 volts. Charge or replace battery.

Inverter is too hot (thermal shut down

mode).

Allow inverter to cool.

Check for adequate ventilation.

Reduce the load on the inverter to

the speciﬁed TrueRated™power max

output.

PROBLEM: Inverter Shut Down – Fault LED Lit

Reason Solution

Equipment being operated draws too

much power.

Do not use the equipment with

this inverter; use a higher wattage

inverter.

Elite™ 700W PRO by Wagan Tech®

9www.wagan.com

PROBLEM: Continuous Buzzing Sound

Reason Solution

Input voltage is below 10.5 volts . Keep input voltage above 10.5

volts .

Poor or weak battery condition. Recharge or replace battery.

Poor or loose cable connection. Inspect terminals and tighten all

connections.

Inadequate power being delivered

to the inverter or excessive voltage

drop.

Use heavier gauge DC cables.

Keep cable length as short as

possible.

DISPOSAL/RECYCLING OF INVERTER

Electronic products are known to contain materials that are toxic if improperly

disposed. Contact local authorities for disposal and recycling information.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Inversor de Wagan

Wagan

Wagan Elite 2000W Manual de usuario

Wagan

Wagan Elite 5000W Manual de usuario

Wagan

Wagan Smart AC 150 USB Manual de usuario

Wagan

Wagan Slim Line 700 Manual de usuario

Wagan

Wagan Elite 180W Manual de usuario

Wagan

Wagan SLIM LINE 9925 Manual de usuario

Wagan

Wagan USB Inverter with FM Transmitter Manual de usuario

Wagan

Wagan 2003-5 Manual de usuario

Wagan

Wagan 9751 Manual de usuario

Wagan

Wagan ACInverter 2294 Manual de usuario

Wagan

Wagan 2221-6 Manual de usuario

Wagan

Wagan Smart AC Inverter 100 USB Manual de usuario

Wagan

Wagan Slim Line 1000 Manual de usuario

Wagan

Wagan AC Inverter Manual de usuario

Wagan

Wagan 2621 Manual de usuario

Wagan

Wagan Smart AC 100W USB Plus Manual de usuario

Wagan

Wagan Proline 3000 3742-2 Manual de usuario

Wagan

Wagan Slimline 2000 Manual de usuario

Wagan

Wagan ACINVERTER 9621 Manual de usuario

Wagan

Wagan Smart AC 150 USB Manual de usuario

Wagan

Wagan Elite 1000W PRO Manual de usuario

Wagan

Wagan ower Inverter Manual de usuario

Wagan

Wagan Smart AC 100W USB Manual de usuario

Wagan

Wagan AC Inverter 700W USB Manual de usuario

Manuales populares de Inversor de otras marcas

Fourgroup

Fourgroup Easy Manual de usuario

Velleman

Velleman PI300M Manual de usuario

Sungrow

Sungrow SG350HX-US Manual de usuario

WilTec

WilTec 61897 Manual de usuario

SMA

SMA SUNNY BOY STORAGE 2.5 Manual de usuario

Simplicity

Simplicity LANDLORD 316 Manual de usuario

Santak

Santak SMAX 3000 Manual de usuario

ATON

ATON RA.Store-3 Manual de usuario

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Manual de usuario

Tektronix

Tektronix CFG250 Manual de usuario

Champion

Champion 200989 Manual de usuario

Vanner

Vanner 20-500 Series Manual de usuario

GE GEP Manual de usuario

Astrel Group

Astrel Group Power Reducer Guía rápida

MULTIQUIP

MULTIQUIP GDP-5H Guía

GoWISE

GoWISE PS1007 Manual de usuario

Promate

Promate PM13500D ES Manual de usuario

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Manual de usuario