VOXTRACK GPS-500 Manual de instrucciones
GPS-500
Quick User Guide
All manuals and user guides at all-guides.com
all-guides.com
Front Components
1 Loudspeaker Plays back voice prompts and warnings.
2 SD/MMC Slot Accepts an optional SD (Secure Digital) or MMC
(MultiMedia Card) card for map data storage.
3 On/Off Button Turns the device on or off.
4 Battery Charge
Indicator
The loading display will shine red during the
charging process. It will shine green when the
accumulator is completely charged.
5 Volume key Turns the volume down.
6 Volume key Turns the volume up.
7 Touch Screen Displays the output of your device. Tap on the
screen with your finger, a stylus or a "blunt" tipped
pen to select menu commands or enter data.
All manuals and user guides at all-guides.com
Back Components
1 External antenna
connection
Connection for an optional external GPS
antennal.
2 Car adaptor port Connection to Power cable for output 5V
cigarette lighter.
3 Main switch/
Battery button
Disconnects the internal battery (also Hard
Reset).
4 Reset button Restarts your appliance. (Reset).
5 Mini-USB-
Connector
Connection for connecting to a PC by means
of the USB cable.
The internal GPS antenna is located in the center of the upper side of the
device.
All manuals and user guides at all-guides.com
Initial Set-up
The following steps will guide you through the initial basic set up of the
navigation system.
1. Charging the battery
Attention: It may be necessary to charge the battery before
initially switching on the device.
Please pay attention to the following notes when handling the battery:
The charge indicator is red until the navigation system is fully charged.
When the navigation system is fully charged the charge indicator turns
green.
Note: You can use the navigation system during the charging process.
It is advised to leave the car adapter connected when in use to ensure that
the internal battery remains charged and navigation is not interrupted.
All manuals and user guides at all-guides.com
2. Switching on the navigation system
Remove the protective plastic from the screen and ensure the main
power switch on the back of the unit is in the ON position.
Attention: Always leave the main switch in the ON Position. The
switch should only be set in the OFF position to preserve battery
charge if the unit is to be stored for an extended period of time.
Press the power button to switch the unit on. When switched on the
unit will display the main screen. Tap the “Navigation” button on the
screen to start the navigation software. To change the setup of the device,
tap the “Settings” button (see software user guide).
All manuals and user guides at all-guides.com
3. Attaching the car mount
Attention: Only fix the holder for the navigation system to the
windscreen in a position that does not impede driver’s view of the
road.
Note: Clean the suction cup and the windscreen thoroughly
with a glass cleaner. Warm the suction cup slightly at temperatures
below 15° C.
1. Place the holder with the suction cup onto the windscreen in the
desired location.
2. Press the lever on the suction cup downwards as shown. The
mount will attach itself to the windscreen firmly.
3. Align the mounting holes in the device with the tabs on the mount.
Push device firmly downwards to lock into place.
All manuals and user guides at all-guides.com
all-guides.com
4. Connecting the car adapter
1. Plug the jack (1) of the car adapter cable into the corresponding
receptor on the back of your navigation system.
2. Insert the power adapter (2) now into the cigarette lighter socket
and ensure that it will not lose contact while driving. This could
cause a malfunction.
Note: Remove the power adapter from the cigarette lighter
socket when ending a trip or when parking the car for an extended
period of time. Otherwise the car battery could be drained. In this
case use the power switch to switch off the navigation system.
All manuals and user guides at all-guides.com
Tabla de contenidos
