VOGELS PFW 6850 Manual de usuario

Max: 45kg/100lbs

MOUIN_PFW6850_V01

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFW 6850

www.vogels.com

M6 x 16mm M6 x 25mm M8 x 16mm M8 x 25mm 5/16” Washer 5/16” x 3”

Lag Bolt Universal

Spacer Universal

Washer Finned Anchor

2.5mm Allen Key Depth Measuring

Straw

Level4mm Allen Key

Phillips

Screwdriver

Protective Eyewear Hammer

Leveler

Electronic Stud

Finder

Pencil Drill Gun

2.5mm Allen Key

10mm Socket

Template

x4 x4 x4 x4 x4 x4 x8 x4 x4

1/4” / 6mm

Drill Bit

3/8” Concrete

Drill Bit

Socket Wrench 13mm or 1/2”

Socket

x1 x1 x1 x1 x1 4

A2A1 Remove the plastic hole covers from the upper and lower

plates. Loosen the (2) set screws on the plate using the

2.5mm allen key supplied. Reposition the upper and lower

pivot rods to mate to either the center or right side pivot

receiver holes, push the upper and lower plate fully on to the

rods, and re-tighten the set screws. Reinstall the side plate

with the eight flat head screws and confirm they are secure.

Reinstall the round plastic hole covers.

Prior to initial step 1 of the installation, your PFW 6850 can

easily have the main “swing left” pivot point of the main swing

out arm moved to either the center, left or right of the mount

by simply placing the mount on a flat surface and removing

the eight flat head screws, then separating the upper and

lower wall plates.

Included components

Required for installation

Pivot

Set Screw

Locations

Set Screw

Locations

www.vogels.com

443

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFW 6850

To ease the installation process you have the option to

remove the wide front plate and mounting brackets by simply

removing the three M5 x 10mm flat head screws, holding

the plate assembly to the swing out arm assembly and set-

ting them aside.

Take the thick cardboard mounting template supplied and

place the it over the mounting studs with the screen center

facing up. Confirm that the template is level horizontally and

that the wall place outline is to the center of your desired

height.

Using a suitable stud-finder device for frame walls, mark the

position of the stud centers.

Measure the desired height of the center of the screen and

mark it.

Using a 1/4” or 6mm drill bit, drill pilot holes minimum 2”

(50mm) deep into the four marked mounting points on the

wall surface. For solid concrete wall construction, the sup-

plied plastic wedge anchors are recommend to be used with

the 5/16” x 3” (76mm) lag bolt and washers supplied.

1/4” / 6mm

www.vogels.com

487

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFW 6850

Take the plastic depth straw supplied and confirm the overall

“safe” screw depth that can be used.

Re-install the front wall arm plate to the arm with the three

M5 flat head screws you set aside earlier. Confirm screws

are fully seated and tight.

Wood Stud

Leveler

1/2”

Raise the PFW 6850 assembly so the mounting slots

are over the four drilled mounting holes. Confirm mount

level with spirit level and secure the mount to the wall

surface with the four each 5/16” x 3” (76mm) lag bolt

and 5/16” flat washer supplied.

Level the wall mount in the following order on figure 5

and below

Re-confirm secured assembly is level horizontally and

vertically or level again if necessary before proceeding.

NOTE: Do not over tighten lag bolts

Concrete Wall

Leveler

1/2”

x4x4

1. Level the wall mount in following order on figure 6

and below.

2. Mark the pointing points.

3. Drill the concrete wall using a 3/8” concrete drill bit.

4. Lighty hammer the four (4) Finned Anchors into the wall.

5. Tighten the (4) 5/16” washers and (4) 5/16” x 3” (76mm) lag

bolts into the wall.

www.vogels.com

10A

10B

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFW 6850

Once the correct pitch and depth screws are pulled from

the hardware pack supplied, secure the two brackets to the

rear of the display with the proper screws and plate washer

holes. Plastic spacers are also supplied in case you need

additional clearance between the bracket and the rear of the

display. NOTE: Do not over tighten the screws.

With the upper and lower security screws loosened on each

bracket (two people recommended) raise the display and

place the top hook of the bracket over the receiver plate on

the wall mount. Allow the lower end of the bracket to lay flat

against the mating plate on the mount.

Center the display horizontally on the plate and check the

display is level on the mount. To adjust level, adjust the left

or right top screw to achieve desired level of the display.

Once level, secure the lower left and right security screws

on the bracket to “fix” the mount to the wall mount.

x4x4

Place the display face down on a smooth flat surface. Place

the left and right mounting brackets over the four mounting

points on the rear of the display arrow pointing up to the top

of the display, making sure the brackets are lined up with the

center top to bottom on the display.

www.vogels.com

1514

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFW 6850

We recommend where possible that the power and signal

cables be run separately through the mount until mating at

the display plug in points to minimize possible “cross talk”

interference. With the covers removed, cable can be run

inside the upper and lower main arm and through the slots

behind the plastic beauty covers.

Install the upper and lower “push on” plastic “beauty covers”

to the upper and lower wall plates. Reinstall the upper and

lower plastic cable covers to the mounts main swing arm.

Installation complete

10mm Deep Socket

2.5mm Allen key

Tilting of the display on the mount is easily accomplished by

placing one hand on top of the display edge center and one

hand on the bottom of the display edge center and gently

pulling out on the top edge to the desired tilt angle. No lock-

ing of the set tilt angle is required as the mount has built-in

friction control. If additional tension is required, use the

socket and M4 allen key to adjust the desired tension.

Extra tension can be applied to the pivot of the arms by

tightening the nuts on the arm with supplied 10mm deep

socket, and the set screws on the base with the supplied

2.5mm allen key. NOTE: Do not over tighten.

www.vogels.com

24.80

630

20.73

526

21.38

543

1.00

15.86

403

29.49

749

15°

MAX TILT

32.20

818

12.56

319

1.60

26.33

669

23.06

586

16.00

406

18.00

457

23.66

(D2)

601

10.50

(D1)

267

(MULTI POSITION ARM 3 PLS)

NOTE: IF THE NEXT ARM OPTIONAL

POSITION IS USED ADD 7" TO (D1) & (D2)

12.12

308

1.85

1.50

21.00

(D1)

533

34.16

(D2)

868

(MULTI POSITION ARM 3 PLS)

NOTE: IF THE NEXT ARM OPTIONAL

POSITION IS USED ADD 7" TO (D1) & (D2)

Installation Guide

Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids

PFW 6850

95V0-000-015-0X_2

Tabla de contenidos

Otros manuales de Rack y soporte de VOGELS

VOGELS

VOGELS SFS 4133 Series Manual de usuario

VOGELS

VOGELS COMPOSE CFAE 140 RC Guía de referencia

VOGELS

VOGELS PFW 185 Manual de usuario

VOGELS

VOGELS NEXT 7346 Manual de usuario

VOGELS

VOGELS EFW 8145 Manual de usuario

VOGELS

VOGELS PFW 6854 Manual de usuario

VOGELS

VOGELS THIN 415 Manual de usuario

VOGELS

VOGELS EFW 6105 Manual de usuario

VOGELS

VOGELS EFW 8206 Manual de usuario

VOGELS

VOGELS WALL 1325 Manual de usuario

VOGELS

VOGELS PLW 1002 Manual de usuario

VOGELS

VOGELS W50050 Manual de usuario

VOGELS

VOGELS PFW6852 Manual de usuario

VOGELS

VOGELS PFW 6851 Manual de usuario

VOGELS

VOGELS PFF7810 Manual de usuario

VOGELS

VOGELS MA 3010 Series Manual de usuario

VOGELS

VOGELS SoundMount NEXT 8365 Guía de instalación

VOGELS

VOGELS PPC 1030 Manual de usuario

VOGELS

VOGELS PPA 370 Manual de usuario

VOGELS

VOGELS WALL 1025 Manual de usuario

VOGELS

VOGELS PFW 6875 Manual de usuario

VOGELS

VOGELS THIN 245 Manual de usuario

VOGELS

VOGELS W50060 Manual de usuario

VOGELS

VOGELS EFW 8125 Manual de usuario

Manuales populares de Rack y soporte de otras marcas

Salamander

Salamander Acadia AC/W/L400/WH Manual de usuario

Fohhn

Fohhn VAT-09 Guía del usuario

ricoo

ricoo FS0522 Manual de usuario

AMSOIL

AMSOIL BMK-22 Guía rápida

Kargo Master

Kargo Master 48220 Manual de usuario

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manual de usuario

ricoo

ricoo S1222 Manual de usuario

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manual de usuario

VidaBox

VidaBox VB MNT FFS2 Manual de usuario

Welch Allyn

Welch Allyn 48960 Manual de usuario

Arkon

Arkon CM035-ST-2 Manual de usuario

PROEL

PROEL PLWIN60C Manual de usuario

Agilent Technologies

Agilent Technologies E2609B Manual de usuario

Mustang

Mustang MV-ARM4 Manual de usuario

Mounting Solutions

Mounting Solutions WRM-320 Manual de usuario

Pyle

Pyle PMKSPAD1 Manual de usuario

ShelterIt

ShelterIt 21208 Manual de usuario

SPL

SPL RackPack?4 1040 Manual de usuario