3
3.6. Use [Arrow] key to adjust control point position with default step (8 pixels/step)
3.7. Use [Shift + Arrow] key to adjust control point position with 1 pixel/step.
3.8. Click # key under [Save to Box] to save the setting. Each channel shall save separately but can save
to the same # for convenient recall.
3.9. After finishing all channel geometry alignment and [Save to Box], click [System] to save all channel
settings into [Profile Save].
4. Switching between OSD operation and GWarp3 operation
4.1. Up to [9x5] geometry alignment:
✓In most of smooth curved application, 9x5 geometry alignment will be enough. User can
execute [9x5] geometry alignment through Remote controller, WebGui or GWarp3.
✓[9x5] settings from OSD operation switched to Gwarp3:
User can open GWarp3 and directly modify the settings under [9x5] or [17x17]. If switch to [5x3]
to do geometry alignment, only [5x3] settings will be kept.
✓[9x5] settings from GWarp3 operation switched to OSD operation:
After user finished GWarp3 [9x5] settings, user has below method to transfer to OSD operation
by remote controller:
i. Gwarp3 operation up to [9x5] will be executed into Box in real time same as OSD operation
by remote controller.
ii. Use [CTRL + P] to turn off GWarp3 grid pattern so that user can see OSD menu and
operate directly by remote controller. User needs to activate [Menu]→ [Anyplace]→ [9x5]
OSD menu for further editing. Don’t use [Warp] hotkey in remote controller because it may
not locate at [9x5] location. If select [3x3] for operation, then [9x5] data will get lost.
iii. Save GWarp3 result into Profile without executing [Save to Box]: user can LOAD the same
Profile from OSD to do further modifications. This is the safest way because even the
result mixed up by OSD operation, it still can be recovered from Load Profile Index.
iv. Save GWarp3 result into [Save to Box]: user can recall the result from [Profile Index] or
UserMap but can’t do further modifications from UserMap due to data format change. Only
4 corner alignment with +_50 Pixels in H&V is allowed.
4.2. [17x17] geometry alignment from Gwarp3
✓After finishing [17x17] geometry alignment, user needs to execute [Save to Box] to save the
data into Box, then save the settings into Profile Index under [System] menu in Gwarp3. The
setting saved in Profile Index will be kept permanently.
✓User can recall [17x17] result from Profile Index by remote controller and combine with other
functions to finish edge blending setting.
✓If user tries to change geometry settings from OSD, it will only keep the data up to [9x5]
settings. [17x17] settings will get lost.
