7
INSTRUCTIONS FOR USE
1. Place the 8 in 1 Grill onto a flat, stable and heat resistant surface and insert
the required accessory or combination of accessories.
2. Connect the 8 in 1 Grill to the mains power supply. The display and control
panel will light up momentarily and then go dark to show that power has been
connected.
3. Press the On/Off ( ) Button to turn on the 8 in 1 Grill. The control panel will
light up.
Programming the 8 in 1 Grill
3. The 8 in 1 Grill can be programmed with one of the following modes:
Air crisp: For crisp and fry with little to no oil required
Roast: Roast meat, vegetables, etc. with circulating hot air
Dehydrate: Dehydrate meat, fruit, or vegetables for homemade snacks
Bake: Bake cakes and snacks with lower temperature circulating hot air
Pizza: Cook pizza up to 8 inches diameter
Broil: Cook meat, vegetables etc. with high temperature top-down heat
Grill: Fast, high temperature cook and colour of meat & vegetables
Manual: Select cooking time and temperature for user preference
Press the text on the control panel to select the desired mode.
4. The cooking time and temperature can be adjusted from the default values
according to user preference.
To adjust the cooking time or temperature , press either the arrow to
decrease or arrow to increase in the following increments:
Time
single press: 1 minute increments (Dehydrate Mode: 30 min increments)
press and hold: 5 minute increments
Temperature
single press: 5°c increments
press and hold: 10°c increments
Grill mode single press: cycle through Low, Medium, High, Maximum
Note: When using Grill mode, the temperature settings are not adjustable from
the Low, Medium, High, Maximum presets.
8
Preheating the 8 in 1 Grill
Broil and Dehydrate modes do not automatically preheat the 8 in 1 grill. Proceed to
Step 6 if using these modes.
5. Press the “Start/Stop” button to automatically begin pre-heating the 8 in 1
Grill. Once preheating has begun the preheat light will remain lit on the control
panel as well as the “Start/Stop” button.
If preheating of the 8 in 1 Grill is not desired, once the “Start/Stop” Button has
been pressed, press the selected mode button and move to step 6.
Once the 8 in 1 Grill has pre-heated the “add food” indicator light will show on
the control panel, the mode light will flash and the 8 in 1 Grill will beep 5 times.
Note: If the lid is not opened following the preheating cycle the 8 in 1 Grill will
maintain the desired cooking temperature with the “add food” indicator light
showing for 30 minutes before sounding 5 beeps and shutting down.
This will also happen if the lid is not opened and closed when trying to bypass/
cancel the preheating cycle.
Starting the Cooking Process
6. Open the lid, place the food into the 8 in 1 Grill and shut the lid again. The
cooking process will automatically begin.
If using Broil or Dehydrate mode, press the “Start/Stop” button to begin the
cooking process.
Once the cooking process has begin, the Time/Temperature Display will
alternately show the set temperature and a countdown timer of the cooking
time with flashing Hour/Minute Separator.
Interrupting, and pausing the cooking process
7. To interrupt the cooking process, for example: to check on progress, open the
lid. The 8 in 1 Grill will automatically pause the cooking process and resume
once the lid is replaced.
Note: If the lid is opened during the cooking process and not replaced, after 4
minutes the 8 in 1 Grill will emit two reminder beeps every 10 seconds for a
further minute before shutting down.
8. To pause the cooking process press the “Start/Stop” button. The process will
resume when the “Start/Stop” button is pressed again.
Making adjustments during the cooking process
9. To adjust the cooking time or temperature during the cooking process, press
the appropriate decrease/increase ( / ) arrow to adjust. The display
will flash for a few moments after the desired setting has been selected before
the change will be made.
