Vista VVRD28V12DN-650 Manual de usuario

VVRD28V12DN-650

Installation manual

Ultra Hi-resolution (650TVL), vandal

resistant, day/night, vari-focal dome.

Including scene analytics and alarm

output functions

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the m

anufacturer‟s instructions.

8. Do not install near any heat sources such as radiators, heat registers,

stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plu

g. A polarized plug has two blades with one wider than the other. A gro

unding type plug has two blades and a third grounding prong. The wid

e blade or the third prong are provided for your safety. If the provided p

lug does not fit into your outlet, consult an electrician for replacement o

f the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at

plugs, convenience receptacles, and the point where they exit from th

e apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified by the

manufacturer, or sold with the apparatus. When a cart is used, use

aution when moving the cart/apparatus combination to avoid injury

from tipping over.

13. Unplug this apparatus during lightning storms or when unused for long

periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required

when the apparatus has been damaged in any way, such as power-su

pply cord or plug is damaged, liquid has been moisture, does not oper

ate normally, or has been dropped.

15. CAUTION –THESE SERVICING INSTRUCTIONS ARE FOR USE

BY QUALIFIED SERVICE PERSONNEL ONLY. TO REDUCE THE

RISK OF ELECTRIC SHOCK DO NOT PERFORM ANY SERVICING

OTHER THAN THAT CONTAINED IN THE OPERATING

INSTRUCTIONS UNLESS YOU ARE QUALIFIED TO DO SO.

16. Use Certified/Listed Class 2 power source only.

CONTENTS OF PACKAGE

The package contains the following

Camera in Housing -----------------------------1no

Instruction Manual (This Document)--------1no

Accessory Kit for Installing -------------------1no

Drilling guide label ------------------------------1no

TABLE OF CONTENTS

INTRODUCTION ---------------------------------------------------------------------------------------4

CAMERA CONNECTIONS --------------------------------------------------------------------------6

INSTALLATION-----------------------------------------------------------------------------------------8

LENS ADJUSTMENT ---------------------------------------------------------------------------------9

DC AUTO IRIS LENS ---------------------------------------------------------------------------------9

OPERATING CAMERA-------------------------------------------------------------------------------9

CAMERA ADJUSTMENT ----------------------------------------------------------------------------9

EXTERNAL DIMENSION-----------------------------------------------------------------------------20

SPECIFICATIONS -------------------------------------------------------------------------------------21

INTRODUCTION

The camera provides high-quality image using a Sony Wide Dynamic 1/3”Super-HADII

PS 960H (Effio) CCD and digital signal processing LSIs.

Features:

1/3”Super-HADII PS 960H CCD (Sony Effio)

Super high-resolution of 650TV lines

0.4 lux(Colour), 0.04 lux(B/W), 0.001 lux(Low-Shutter) @ F1.4 Sensitivity

Auto Electronic Shutter [1/50 ~ 1/100,000] and manual electronic shutter

modes [1/50 ~ 1/10,000]

On Screen Display (OSD)

Auto and Manual white balance modes

Supports Line-Lock external synchronization

Digital PTZ

Digital Effect (H/V reverse, 180 degree rotate, inverse, freeze)

2D-NR, 3D-NR (DNR Demo)

Back Light Compensation

Back Light Masking (MAX. 15 area)

Excessive High-Light Compensation

Wide Dynamic Range (~x512)

Various Detection Methods (zone detection, motion trace, face trace, mine

area, absent detection, cross object counting, entrance counting)

Day & Night(Auto, Manual, External, Filter delay)

Various Alarm Methods (Period, Snooze, Polarity Select)

Privacy Mask or Mosaic (MAX. 15 area/4-point polygonal/transparency)

Scene Change Detection

Sens-Up (~x32)

White Pixel Removal

Frame Control (Auto, 1~7 sec)

System Lock (4-Digit password)

RS-485 Remote camera control

F1.4 D&N DC iris vari-focal lens

Operates in 12VDC or 24VAC

Use Certified / Listed Class 2 power source only

CAMERA CONNECTIONS

Connection Cable Description

COLOR

Description

RED

AC24V/DC12V

WHITE

AC24V/DC12V

ORANGE

ADKEY

BROWN

GND

BLUE

RS485(-)

GREEN

RS485(+)

YELLOW

ALARM OUT

GREY

DN EXT-IN

BLACK&WHITE

DN EXT-OUT

BLACK

GND

SKY BLUE

Not used

PINK

Not used

1) External Day/Night Control: To select Day/Night mode using external equipment,

connect control lines to the appropriate terminals.

DAY & NIGHT OUTPUT (Black / White)

This function allows the switching on of an external device such as lights, when

the camera switches to its night time mode. The Day/Night mode in the OSD

menus must be set to “AUTO”

DAY & NIGHT EXTERNAL INPUT (Grey)

This function allows the cameras Day/Night Switching to be controlled by an

external switch such as a Photo Cell. The Day/Night mode in the OSD menu

must be set to “External”

2) Alarm out (5vTTL)

Event detection signals are output through this port. (YELLOW AND GND)

Active state is configurable.

Low going high in alarm (approx 3.5v > 5v)

Gray

Black

GND

Black

DAY&NIG

Black/ White

5V/10mA : IR LED ON (NIGHT)

0V : IR LED OFF (DAY)

2) Power Input Terminal

RED: +

WHITE -

If using a 12vDC PSU then it is recommended it is not less than 0.75A.

4) Camera Control

GREEN: RS485+

BLUE: RS485-

5) AD Control via optional hand held set up controller (VZM22/REM)

GND Terminal/Brown

AD Key

INSTALLATION

1. Loosen the four torx screws located midway up the front of the housing leave the

screws loose in the front portion. (Fig. 1)

2. Drill the mounting location, using the bottom of the housing as a Drilling guide label.

(Fig. 3)

3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping screws are

supplied only use if they are suitable. (Fig. 3)

4. Close the housing using the loosen torx screws. (Fig. 2)

Torx screws

M5x10 (4x)

Torx screws

M5x10 (4x)

Seal around

the housing

base tightly

using

the silicon

rubberTorx

screws

M5x10 (4x)

Figure 1

Figure 2

LENS ADJUSTMENT

DC AUTO IRIS LENS

2.8~12mm

Image Size

1/3" CCD

Focal Length

2.8-12mm 5%

Aperture

Ratio

1 : 1.4 5%

Angular

Field of View

(Degree)

Horizontal

2.8mm : 770

12mm : 210

OPERATING CAMERA (OSD menus)

Field of view: Adjust setting

from Telephoto (T) to wide (W)

field of View.

Focus: Adjust lens focus from

near (N) to infinity.

Key to button operation

1 –Service lead point

2 –Enter

3 –Up (U)

4 –Down (D)

5 –Left (L)

6 –Right (R)

Local setup of the camera can be achieved by connecting a portable monitor to the set up video

out put (No.6 in the image above).

The OSD menu can be accessed by pressing button No. 1. Navigation of the menus is achieved by

using the other buttons as detailed above.

Menu tree

Tabla de contenidos

Otros manuales de Cámara de seguridad de Vista

Vista

Vista VK2-108VFDIR37e Manual de usuario

Vista

Vista VVRD28V12MHDA Manual de usuario

Vista

Vista VFDA28V12HDA Series Manual de usuario

Vista

Vista VLI-4ED28IRQ Manual de usuario

Vista

Vista VK2-HD30IR-PM Manual de usuario

Vista

Vista VK2-1080XVRDPTZ Manual de usuario

Vista

Vista PowerDome Series Manual de usuario

Vista

Vista Onvif VK2-1080XPTZ Manual de usuario

Vista

Vista VK2L-4MPTIR28 Manual de usuario

Vista

Vista VLI-4BL28V12IRQ Manual de usuario

Vista

Vista VPC5-704CME Manual de usuario

Vista

Vista VK2-108VRDIR35V16e Manual de usuario

Vista

Vista ONVIF VK2-1080XPTZF Manual de usuario

Vista

Vista VIP Series Manual de usuario

Vista

Vista VBC400-600 Manual de usuario

Vista

Vista Onvif VK2 Manual de usuario

Vista

Vista ONVIF VK2-4KX30IR-PM Manual de usuario

Vista

Vista VPM8030 Manual de usuario

Vista

Vista VVRD28V12MHDAW Manual de usuario

Vista

Vista VP-HDA20IR-SMW Manual de usuario

Vista

Vista VP-HDA30-PM Manual de usuario

Vista

Vista VBC502-960H Manual de usuario

Vista

Vista Onvif VK2-1080XPTZ Manual de usuario

Vista

Vista VP960H Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario