Vinten Vision Ped Plus Manual

Vinten

Camera Control Solutions

Operators Guide

Vision Ped Plus

Studio Pedestal

Vision Ped Plus

Studio Pedestal

Publication Part No. 3951-8 Issue 1

or reproduced in any way including, but not limited to, photocopy, photograph, magnetic or other record without the prior

agreement and permission in writing of

Vinten Broadcast Limited.

Vinten and Vision are registered trademarks of Vinten Broadcast Limited.

Safety - read this first

Warning Symbols in this Operators Guide

Where there is a risk of personal injury, injury to others, or damage to the ped-

estal or associated equipment, comments appear, highlighted by the word

WARNING! and supported by the warning triangle symbol.

Warning symbols on the pedestal

On encountering the warning triangle and open book symbols it is imperative

that you consult this operators guide before using this pedestal or attempting

any adjustment or repair.

Critical data

Mass

Column 8 kg (17.6 lb)

Skid 5.5 kg (12.1 lb)

Load

Maximum load 30 kg (66 lb)

Pressure

Maximum pressure 9.6 bar (139 psi)

Further information

For further information or advice regarding this pedestal, please contact Vinten Broadcast Limited,

your local Vinten distributor (see back cover) or visit our website.

For details on maintenance and spare parts, please refer to the Vision Ped Plus Maintenance

Manual and Illustrated Parts List (Publication Part No. V3951-4990) This is obtainable from Vinten

Broadcast Limited or your local Vinten distributor. For information on-line, visit our website at

www.vinten.com.

<9.6 bar

8 kg

<30 kg

5.5

Technical data

Payload 30 kg (66 lb)

Column weight 8 kg (17.6 lb)

Skid weight 5.5 kg (12.1 lb)

Total pedestal weight 13.5 kg (29.7 lb)

Minimum height to 100 mm bowl adaptor mounting face 75.1 cm (29.6 in.)

Maximum height 1to 100 mm bowl adaptor mounting face 159.5 cm (62.8 in.)

Minimum height to flat mounting face 63.7 cm (25.1 in.)

Maximum height to flat mounting face 148.1 cm (58.3 in.)

On-shot stroke 41.0 cm (16.1 in.)

Wheel diameter 10.0 cm (4 in.)

Skid leg radius 55.85 cm (22.0 in.)

Doorway tracking width 95.6 cm (37.6 in.)

Transit doorway width 73.3 cm (28.9 in.)

Steering ring diameter 35.0 cm (13.8 in.)

Max working pressure 9.6 bar (139 psi)

Relief valve pressure 11.0 bar (160 psi)

Contents

Page

Safety - read this first . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Critical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Further information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Introduction and Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

Operation

Assembling the pedestal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Pressurizing the pedestal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Fitting and balancing the load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Using the pedestal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

Servicing

General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Cleaning. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Routine checks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Adjustments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17

Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21

Associated Publication

Vision Ped Plus Pedestal

Maintenance Manual and illustrated Parts List

Publication Part no. V3951-4990

Vision Ped Plus studio pedestal

(1)

(2)

(3)

(4)

(6)

(7)

(8)

(9)

(13)

(20)

(13)

(5)

(21)

(10)

(11)

(18)

(19)

(14)

(15)

(12)

(17)

(16)

(22)

(1) 100 mm levelling bowl adaptor

(2) Control valve

(3) Safety catch

(4) Ta n k a s s e m b ly

(5) Elevation tube

(6) Velcro strap

(7) Foot support and strap

(8) Track locking pin

(9) Brake

(10) Fixed leg

(11) Skid clamp

(12) Skid centre casting

(13) Folding leg

(14) Cable guard

(15) Cable guard adjustment knob

(16) Outer tube

(17) Strut

(18) Bottom clamp

(19) On-shot clamp

(20) Steering ring

(21) Schrader valve and cap

(22) Pressure gauge

Introduction and Description

The Vision Ped Plus studio pedestal is a fully-portable pneumatic camera mount, designed to sup-

port a payload of up to 30 kg (66 lb). It comprises a central telescopic column and a skid assembly

with castoring wheels. To facilitate transport, the telescopic column and skid may be separated

and the skid folded.

The telescopic column consists of an outer tube, which locates in the skid and has three struts to

provide the pedestal strength and stability; an elevation tube, which is positioned relative to the

outer tube and defines the working height of the pedestal; and a tank assembly, which forms the

upper, moving part of the pedestal, provides the balancing force for the payload and acts as a

pump for pressurization.

The skid comprises a centre casting with carrying handle, a fixed leg and two folding legs. Each

leg carries a braked castoring wheel and a foot support with strap to support the column. The skid

has 100 mm (4 in.) wheels with cable guards and track locks which provide castor, track or steer

movement of the pedestal.

Operation

Assembling the pedestal

Skid

Turn the skid upside-down, depress the leg locking plungers (13.1) and swing each folding leg

(13) out until the plungers lock the legs in the fully open position.

Set the skid on the ground on its wheels and apply the wheel brakes (9).

Skid

(9)

(13) (13.1)

Column

Instal the column on the skid as follows:

Fully slacken the skid clamp (11).

Ensure the control valve (2) is set to the WORK position.

Release the Velcro retaining strap (6).

Hold the telescopic column upright with the steering ring (20) uppermost and swing the

three struts (17) up almost to horizontal.

Lift the column assembly by the steering ring and lower it vertically into the skid centre cast-

ing, ensuring bottom clamp knob (18) is aligned with skid handle. Engage the struts (17) on

the foot supports (7).

Secure each strut to the foot support with the rubber strap. Tighten the skid clamp (11), us-

ing moderate hand pressure only.

Secure the Velcro retaining strap (6) clear of the skid wheels.

Pressurizing the pedestal

The Vision Ped Plus pedestal may be pressurized using the built-in pump, by using the Vinten

Portable Pump or from an external pressure source.

Ascertain the payload to be fitted to the pedestal (payload = pan and tilt head, camera, lens and

all ancillary equipment). Referring to the graph, mark the payload on the horizontal axis then strike

a vertical line from the load figure to the balance line. At the intersecting point strike a horizontal

line to the vertical axis and read off the required gas pressure.

Pressurization graph

0 5 10 15 20 25 30

706050403020100lb

bar

100

120

140

psi

≤9.6 bar

(139 psi)

Otros manuales para Vision Ped Plus

Tabla de contenidos

Otros manuales de Accesorios para cámaras de Vinten

Vinten

Vinten Vision Pozi-Loc 3880-3 Manual

Vinten

Vinten V4109-0001 Manual de usuario

Vinten

Vinten Vision 250E Manual

Vinten

Vinten Vision 30 Manual de usuario

Vinten

Vinten vector 750 Manual de usuario

Vinten

Vinten Vision 250E Manual de usuario

Vinten

Vinten Vector 700H Manual

Vinten

Vinten Vision Blue Manual

Vinten

Vinten FHR-35 Manual de usuario

Vinten

Vinten Vision 8 Manual

Vinten

Vinten Vision 10LF Manual de usuario

Vinten

Vinten Vision 3AS Manual

Vinten

Vinten Vector 750i Manual de usuario

Vinten

Vinten PRO-5Plus Manual

Vinten

Vinten 3320 Manual de usuario

Vinten

Vinten vector 750 Manual

Vinten

Vinten FE-55 Manual de usuario

Vinten

Vinten vector 430 Manual

Vinten

Vinten FH155 Manual StarTracker Manual de usuario

Vinten

Vinten Vision Ped Plus Manual de usuario

Vinten

Vinten OB Quattro Manual

Vinten

Vinten Vector 75 V4095-0001 Manual

Vinten

Vinten V4160-0001 Manual de usuario

Vinten

Vinten vector 430 Manual

Manuales populares de Accesorios para cámaras de otras marcas

Viltrox

Viltrox EF-NEX Instrucciones de instalación

Calumet

Calumet 7100 Series CK7114 Manual de usuario

Ropox

Ropox 4Single Series Manual de usuario

Cambo

Cambo Wide DS Digital Series Instrucciones de funcionamiento

Samsung

Samsung SHG-120 Manual de usuario

Ryobi

Ryobi BPL-1820 Manual de operación

Aegis

Aegis ABL-36020P Manual de usuario

Pentax

Pentax Data Back Fc Manual de usuario

Fantasea

Fantasea EyeGrabber F Series Manual de usuario

Honeywell

Honeywell HDZ20HD Manual de usuario

EGO

EGO BA1400T Manual de usuario

Sima

Sima SRW-62 Manual de usuario

Shape

Shape A7SSMKIT Manual de usuario

Slide Kamera

Slide Kamera HST-2 Manual de usuario

Power works

Power works 2902613 Manual de usuario

SES

SES SE-2047-2 Manual de usuario

Olympus

Olympus PT-EP05L Manual de usuario

Starlite

Starlite OctoDome nxt Manual de usuario