Viessmann Vitocell 050-E Guía rápida

Installation and service instructions

for contractors

VIESMANN

Vitocell 050-E

Type SVPA

Heating water buffer cylinder

600, 750 and 950 l

VITOCELL 050-E

6153974 GB 7/2020 Please keep safe.

Please follow these safety instruc-

tions closely to prevent accidents

and material losses.

Safety instructions explained

Danger

This symbol warns against the risk

of injury.

!Please note

This symbol warns against the risk

of material losses and environmen-

tal pollution.

Note

Details identified by the word "Note"

contain additional information.

Target group

These instructions are exclusively inten-

ded for qualified contractors.

■Work on electrical equipment may only

be carried out by a qualified electrician.

■The system must be commissioned by

the system installer or a qualified per-

son authorised by the installer.

Regulations to be observed

■National installation regulations

■Statutory regulations for the prevention

of accidents

■Statutory regulations for environmental

protection

■Codes of practice of the relevant trade

associations

■Relevant country-specific safety regu-

lations

Working on the system

■Isolate the system from the power sup-

ply (e.g. by removing the separate fuse

or by means of a mains isolator) and

check that it is no longer live.

■Safeguard the system against recon-

nection.

!Please note

Electronic assemblies can be dam-

aged by electrostatic discharge.

Prior to commencing any work,

touch earthed objects such as heat-

ing or water pipes to discharge

static loads.

Danger

Hot surfaces can cause burns.

■Before maintenance and service

work, switch OFF the appliance

and let it cool down.

■Never touch the hot surfaces of

uninsulated pipes and fittings.

Safety instructions

6153974

Danger

Floors that are wet or damp with

water or glycol based liquids can

cause injury due to slipping and fall-

ing.

■Keep the floor clean and dry dur-

ing installation and maintenance

work.

■Wear non-slip shoes.

Danger

Broken-off fragments of insulation

material can cause death by suffo-

cation if inhaled or swallowed.

■Do not let children play in the

installation room.

■Keep the installation room clean

after installation and maintenance

work.

Repair work

!Please note

Repairing components that fulfil a

safety function can compromise the

safe operation of the system.

Replace faulty components only

with genuine Viessmann spare

parts.

Auxiliary components, spare and wearing parts

!Please note

Spare and wearing parts that have

not been tested together with the

system can compromise its func-

tion. Installing non-authorised com-

ponents and making non-approved

modifications or conversions can

compromise safety and may invalid-

ate our warranty.

For replacements, use only original

spare parts supplied or approved by

Viessmann.

Safety instructions

Safety instructions (cont.)

6153974

1. Information Disposal of packaging ............................................................................ 5

Symbols ................................................................................................. 5

Intended use .......................................................................................... 5

Product information ................................................................................ 6

System examples .................................................................................. 6

Spare parts lists ..................................................................................... 6

2. Preparing for installation Connections ........................................................................................... 7

Siting ...................................................................................................... 8

3. Installation sequence Levelling the heating water buffer cylinder ............................................ 9

Fitting the thermometer sensors and cylinder temperature sensors ...... 10

Fitting the thermal insulation .................................................................. 11

■Fitting the thermal insulation jacket sections ...................................... 11

■Fitting the cover .................................................................................. 12

Connections on the heating water side .................................................. 12

Connecting the equipotential bonding ................................................... 12

4. Commissioning/service

reports

................................................................................................................ 13

5. Specification Product characteristics .......................................................................... 14

6. Disposal Final decommissioning and disposal ..................................................... 15

Index

6153974

Please dispose of packaging waste in line with statu-

tory regulations.

Symbols

Symbol Meaning

Reference to other document containing

further information

Step in a diagram:

The numbers correspond to the order in

which the steps are carried out.

Warning of material losses and environ-

mental pollution

Live electrical area

Pay particular attention.

■Component must audibly click into place.

■Acoustic signal

■Fit new component.

■In conjunction with a tool: Clean the sur-

face.

Dispose of component correctly.

Dispose of component at a suitable collec-

tion point. Do not dispose of component in

domestic waste.

Intended use

The appliance is only intended to be installed and

operated in sealed unvented systems that comply with

EN 12828 / DIN 1988, or solar thermal systems that

comply with EN 12977, with due attention paid to the

associated installation, service and operating instruc-

tions. DHW cylinders are only designed to store and

heat water of potable water quality. Heating water buf-

fer cylinders are only designed to hold fill water of pot-

able water quality. Only operate solar collectors with

the heat transfer medium approved by the manufac-

turer.

Intended use presupposes that a fixed installation in

conjunction with permissible, system-specific compo-

nents has been carried out.

Commercial or industrial usage for a purpose other

than heating the building or DHW shall be deemed

inappropriate.

Any usage beyond this must be approved by the man-

ufacturer for the individual case.

Information

Disposal of packaging

6153974

Information

Incorrect usage or operation of the appliance (e.g. the

appliance being opened by the system user) is prohibi-

ted and results in an exclusion of liability.

Incorrect usage also occurs if the components in the

system are modified from their intended use (e.g.

through direct DHW heating in the collector).

Adhere to statutory regulations, especially concerning

the hygiene of potable water.

Product information

Steel heating water buffer cylinder for storing heating

water in combination with heat pumps, solar thermal

systems, solid fuel boilers and heat recovery.

■Suitable for systems to EN 12828 and DIN 4753.

■Capacity: 600, 750 and 950 l

System examples

Available system examples: See www.viessmann-

schemes.com.

Spare parts lists

Information about spare parts can be found at

www.viessmann.com/etapp or in the Viessmann

spare part app.

Information

Intended use (cont.)

6153974

Information

Fig. 1 Back

AHeating water flow 1

BHeating water flow 2/heating water return 1

CHeating water return 2

DHeating water return 3

EMounting for thermometer sensor (below thermal

insulation)

FClamping system for cylinder temperature sensor

1 (behind thermal insulation)

GMounting for thermometer sensor (below thermal

insulation)

HClamping system for cylinder temperature sensor

2 and thermometer sensor (behind thermal insula-

tion)

KClamping system for cylinder temperature sensor

3 and thermometer sensor (behind thermal insula-

tion)

LClamping system for cylinder temperature sensor

4 (behind thermal insulation)

MMounting for thermometer sensor (below thermal

insulation)

Preparing for installation

Connections

6153974

Installation

!Please note

To prevent material losses, install the heating

water buffer cylinder in a room free from the risk

of frost and draughts.

Otherwise the heating water buffer cylinder will

need to be drained when not in use and there is

a risk of frost.

Note

Placing the heating water buffer cylinder on a plinth will

make the room easier to clean.

Preparing for installation

Siting

6153974

Installation

Note

Seal connections that are not required with caps.

Fig. 2

AType plate

B3 adjustable feet

3. Insert the adjustable feet into the legs as far as

they will go. Use the adjustable feet to level the cyl-

inder body.

Note

Only use one or two of the adjustable feet to level the

cylinder body. At least one of the adjustable feet must

remain fully screwed in.

≤35

Fig. 3

Do not extend the adjustable feet beyond a total

length of 35 mm.

Installation sequence

Levelling the heating water buffer cylinder

6153974

Installation

Fig. 4

1. Route the leads of all available thermometer sen-

sors to the cylinder through the small apertures in

the thermal insulation mat.

2. Guide the upper thermometer sensor through the

lifting eye, insert it into the clamping bracket as far

as it will go and tighten the wing nut.

Secure the lower thermometer sensor (if available)

in the clamping bracket at the base of the cylinder.

3. Release the nuts.

4. Push the clamping system onto the threaded studs

and align.

5. Tighten the nuts.

6. Depending on where the sensor is being fitted:

Insert the thermometer sensors and cylinder

temperature sensors into clamping systems A

as far as they will go.

Note

Never wrap insulating tape around the sensors.

Installation sequence

Fitting the thermometer sensors and cylinder temperature sensors

6153974

Installation

Tabla de contenidos

Otros manuales de Caldera de Viessmann

Viessmann

Viessmann VITOFLEX 300-UF Guía de inicio rápido

Viessmann

Viessmann Vitopend 100-W Guía rápida

Viessmann

Viessmann VITOTRONIC 300 GW2 Guía

Viessmann

Viessmann Vitodens 100-W Guía de inicio rápido

Viessmann

Viessmann Vitodens 222-F Guía rápida

Viessmann

Viessmann Vitodens 222-F B2TA series Guía rápida

Viessmann

Viessmann Vitocaldens 222-F Manual de usuario

Viessmann

Viessmann VITOCROSSAL 200 Manual de usuario

Viessmann

Viessmann Vitodens 100-W Manual de usuario

Viessmann

Viessmann Vitopend 200-W Instrucciones de funcionamiento

Viessmann

Viessmann VITOCROSSAL 200 Manual de usuario

Viessmann

Viessmann CombiPLUS Kit Hoja de datos

Viessmann

Viessmann Vitocrossal 200 CM2 Series Manual de usuario

Viessmann

Viessmann Vitodens 200-W System Instrucciones de funcionamiento

Viessmann

Viessmann VITORADIAL 300-T Instrucciones de funcionamiento

Viessmann

Viessmann VITOROND 200 VD2A-125 Manual de usuario

Viessmann

Viessmann VITOCELL 100-V Manual de instrucciones

Viessmann

Viessmann VITOLADENS 300-W Instrucciones de funcionamiento

Viessmann

Viessmann Vitodens 100-W Manual de instrucciones

Viessmann

Viessmann Vitodens 100-W Manual de usuario

Viessmann

Viessmann Vitodens 222-W B2LB Manual de usuario

Viessmann

Viessmann Vitogas 100 GS1 Series Manual de usuario

Viessmann

Viessmann Vitodens 100-W Guía rápida

Viessmann

Viessmann Vitodens 100-W Manual de usuario

Manuales populares de Caldera de otras marcas

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manual de usuario

Radijator

Radijator BIO max 23.1 Manual de usuario

Brunner

Brunner BSV 20 Manual de usuario

Buderus

Buderus Logamax GB062-24 KDE H V2 Manual de usuario

Potterton

Potterton 50e Hoja de datos

UTICA BOILERS

UTICA BOILERS TriFire Manual de usuario

Joannes

Joannes LADY Series Manual

ECR International

ECR International UB90-125 Manual de instrucciones

Froling

Froling FHG Turbo 3000 Manual de usuario

Froling

Froling P4 Pellet 8 - 105 Manual de usuario

U.S. Boiler Company

U.S. Boiler Company K2 Manual de usuario

Henrad

Henrad C95 FF Manual de usuario

NeOvo

NeOvo EcoNox EF 36 Manual de usuario

Potterton

Potterton PROMAX SL 12 Manual de usuario

Eco Hometec

Eco Hometec EC 25 COMPACT Manual de usuario

Baxi

Baxi Prime 1.24 Manual de usuario

REXNOVA

REXNOVA ISA 20 BITHERMAL Manual de usuario

Radiant

Radiant R2K 55 Manual