Victaulic FireLock NXT 764 Series Guía

IMPORTANT INFORMATION

WARNING WARNING

Read and understand all instructions•

before attempting to perform maintenance

on any Victaulic piping products.

Wear safety glasses, hardhat, and foot•

protection.

Failure to follow these instructions could

result in serious personal injury, property

damage, and/or product failure.

Depressurize and drain the piping•

system before attempting to remove,

adjust, or perform maintenance on any

Victaulic piping products.

Failure to follow this instruction could

result in serious personal injury and/or

property damage.

REMOVING THE SYSTEM FROM SERVICE

CAUTION

Any activities that require taking the•

valve out of service may eliminate the fire

protection provided.

Before servicing or testing the system,•

notify the authority having jurisdiction.

Consideration of a fire patrol should be•

given in the affected areas.

Failure to follow these instructions could

result in serious personal injury and/or

property damage.

1. Notify the authority having jurisdiction, remote station alarm moni-

tors, and those in the affected area that the system is being taken

out of service.

2. Open the water supply main drain valve fully to flush the water

supply of any contaminants.

3. Close the water supply main drain valve.

Water Supply Main

Control Valve

4. Close the water supply main control valve to take the system out of

service.

The following instructions are a guide for removing and replacing the diaphragm in Series 764, 768,

and 769 FireLock NXT™Fire Protection Valves. It is important to replace the diaphragm with a new,

Victaulic-supplied diaphragm of the correct diameter to ensure proper valve operation.

I-NXT.DIA_1

Series 764, 768 and 769

REPLACING THE DIAPHRAGM IN SERIES 764, 768, AND 769 FIRELOCK NXT™ FIRE PROTECTION VALVES

I-NXT.DIAREPLACEMENT KIT INSTRUCTIONS

www.victaulic.com

REV_A

5. Open the water supply main drain valve.

6. Confirm that water is not flowing from the water supply main drain

valve.

7. Close the diaphragm-charge-line ball valve.

8. Open the system main drain valve to drain any water that has

accumulated and to release system air pressure.

NOTE: If the system has operated, open the remote system test valve

(inspector’s test connection) and any auxiliary drain valves.

9. Close the slow-fill ball valve on the Air Maintenance Trim Assembly

(AMTA).

10. PUSH DOWN ON THE AUTO DRAIN SCREW TO REMOVE

PRESSURE IN THE DIAPHRAGM CHARGE LINE.

I-NXT.DIA_2

Series 764, 768 and 769

REPLACING THE DIAPHRAGM IN SERIES 764, 768, AND 769 FIRELOCK NXT™ FIRE PROTECTION VALVES

I-NXT.DIA

REPLACEMENT KIT INSTRUCTIONS

www.victaulic.com

REV_A

REMOVING AND REPLACING THE DIAPHRAGM ASSEMBLY

1. Break the unions that connect the trim to the diaphragm cover.

Refer to the applicable trim drawing for details.

2. Remove the cap screws from the diaphragm cover, and pull the

diaphragm cover/trim off the valve.

3. Remove the diaphragm from the valve body.

4. Clean the back of the valve body to remove any debris that may

interfere with proper diaphragm seating.

4a. Clean the inside of the diaphragm cover to remove any foreign

material.

CAUTION

Use caution when installing a new diaphragm into the valve•

body.

Failure to follow this instruction could cause damage to the

diaphragm, resulting in improper valve operation and valve

leakage.

5. Replace the diaphragm with a new, Victaulic-supplied diaphragm.

Align the holes in the diaphragm with the holes in the valve body.

Be careful not to damage the diaphragm during installation.

6. Align the holes of the diaphragm cover with the holes in the dia-

phragm/valve body. Tighten all cap screws into the diaphragm

cover/valve body.

7. Re-attach the trim at the unions that were loosened in step 1.

Refer to the applicable trim drawing for details. MAKE SURE

ALL UNIONS THAT WERE LOOSENED TO PERMIT ACCESS

TO THE DIAPHRAGM COVER ARE RE-TIGHTENED BEFORE

ATTEMPTING TO PLACE THE SYSTEM BACK IN SERVICE.

8. Place the system back in service by following the “Placing the

System in Service” section in the applicable installation, mainte-

nance, and testing manual for the valve configuration.

I-NXT.DIA_3

Series 764, 768 and 769

REPLACING THE DIAPHRAGM IN SERIES 764, 768, AND 769 FIRELOCK NXT™ FIRE PROTECTION VALVES

I-NXT.DIAREPLACEMENT KIT INSTRUCTIONS

www.victaulic.com

REV_A

Series 764, 768 and 769

REPLACING THE DIAPHRAGM IN SERIES 764, 768, AND 769 FIRELOCK NXT™ FIRE PROTECTION VALVES

I-NXT.DIAREPLACEMENT KIT INSTRUCTIONS

I-NXT.DIA

For complete contact information, visit www.victaulic.com

I-NXT.DIA 5658 REV A UPDATED 05/2009 Z000NXTDIA

Otros manuales para FireLock NXT 764 Series

Este manual sirve para los siguientes modelos

Otros manuales de Unidad de control de Victaulic

Victaulic

Victaulic 795 Series Manual de usuario

Victaulic

Victaulic FireLock 758 Series Manual de usuario

Victaulic

Victaulic 317 Series Manual de usuario

Victaulic

Victaulic I-769N Manual de usuario

Victaulic

Victaulic 867-4UF Manual de usuario

Victaulic

Victaulic FireLock NXT 769 Series Manual de usuario

Victaulic

Victaulic 725S Series Manual de usuario

Victaulic

Victaulic 867-7UF Manual de usuario

Victaulic

Victaulic 751 FireLock Series Manual de usuario

Victaulic

Victaulic 769N FireLock NXT Series Manual de usuario

Victaulic

Victaulic FireLock 247 Series Manual de usuario

Victaulic

Victaulic 809N Manual de usuario

Victaulic

Victaulic FireLock 756 Series Manual de usuario

Victaulic

Victaulic Vic-300 MasterSeal 761 Series Manual de usuario

Victaulic

Victaulic 871 Series Manual de usuario

Victaulic

Victaulic FireLock NXT 776 Series Manual de usuario

Victaulic

Victaulic FireLock NXT 769 Series Manual de usuario

Victaulic

Victaulic FireLock 756 Series Manual de usuario

Victaulic

Victaulic 751 Series Manual de usuario

Victaulic

Victaulic 5-Year Rebuild Kit Manual de usuario

Victaulic

Victaulic 867-42T Manual de usuario

Victaulic

Victaulic FireLock Vic-Strainer 732H Series Nota de publicación

Victaulic

Victaulic KOIL-KIT 799 Series Manual de usuario

Victaulic

Victaulic FireLock NXT 769N Series Manual de usuario

Manuales populares de Unidad de control de otras marcas

Festo

Festo Compact Performance CP-FB6-E Manual de lista de piezas

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manual de usuario

JS Automation

JS Automation MPC3034A Manual de usuario

JAUDT

JAUDT SW GII 6406 Series Guía rápida

Spektrum

Spektrum Air Module System Manual de usuario

BOC Edwards

BOC Edwards Q Series Manual de usuario

KHADAS

KHADAS BT Magic Manual de usuario

Etherma

Etherma eNEXHO-IL Manual de usuario

PMFoundations

PMFoundations Attenuverter Manual de usuario

GEA

GEA VARIVENT Manual de usuario

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manual de usuario

Altronix

Altronix LINQ8PD Instrucciones de montaje

Eaton

Eaton Powerware Series Manual de usuario

WAGO

WAGO 750-407/040-000 Manual de usuario

Sony

Sony CCU-590 Manual de usuario

Graco

Graco 25D614 Manual de usuario

Task Force Tips

Task Force Tips YE-RF-900 Manual de programación

Shini

Shini SPV-U Series Manual de usuario