Vestfrost WFG 185 Manual de usuario
GB Instructions for use
DE Bedienungsanleitung
DK Brugsanvisning
WFG 185 / 155
FR Mode d’emploi
IT I Istruzioni per l’uso
2
GB
As the appliance contains a
ammable refrigerant, it is es-
sential to ensure that the refrig-
erant pipes are not damaged.
The quantity and type of the
refrigerant used in your appli-
ance is indicated on the rating
plate.
Standard EN378 species that
the room in which you install
your appliance must have a
volume of 1m³ per 8 g of hydro-
carbon refrigerant used in the
appliances. This is to avoid the
formation of ammable gas/air
mixtures in the room where the
appliance is located in the event
of a leak in the refrigerant circuit.
WARNING:
Keep ventilation openings in
the appliance’s cabinet or in the
built-in structure clear of obstruc-
tion
WARNING:
Do not use other mechanical
devices or other means to ac-
celerate the defrosting process
than those recommended by the
manufacturer
WARNING:
Do not damage the refrigerant
system
WARNING:
Do not use electrical appli-
ances inside the refrigerated
storage compartment, unless
they are of a type recommended
by the manufacturer
WARNING:
Do not expose the appliance to
rain
WARNING:
This appliance is not intended
for use by children and above
and persons with reduced phy-
sical, sensory or mental capabi-
lities or lack of experience and
knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved
WARNING:
Do not store explosives, such
as aerosol cans with ammable
propellants in the unit.
Warning
3
GB
WARNING:
Cleaning and user maintenance
shall not be made by children
without supervision
●Always keep the keys in a sep-
arate place and out of reach of
children
●Before servicing or clean-
ing the appliance, unplug the
appliance from the mains or
disconnect the electrical power
supply
●If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent,
or similarly qualied persons in
order to avoid a hazard
●Relevant for Australia: Sup-
ply cord tted with a plug com-
plies with AS/NZS 3112.
●Frost formation on the interior
evaporator wall and upper
parts is a natural phenom-
enon. Therefore, the appliance
should be defrosted during
normal cleaning or mainte-
nance.
●Please note that changes to
the appliance construction will
cancel all warranty and product
liability
●This appliance is intended to
be used exclusively for the
storage of wine
4
GB
The energy consumption reduces ..
1)..the lower the ambient temperature is.
2)..the warmer thermostat set point is.
3)..the lower the number and the shorter
the length of the door openings is.
Savings in energy consumption in the use
Contents
Warning ......................................................2
Savings in energy consumption in
the use ........................................................4
Before use ..................................................5
Get to know your wine cooler .....................6
Electrical connection ...................................7
Installation and start-up ..............................7
Installation ..................................................8
Operation and function .............................10
Defrosting, cleaning and maintenance .....12
Fault nding ..............................................13
Warranty, spare parts and service ............14
Disposal ....................................................15
5
GB
On receipt, check to ensure that the ap-
pliance has not been damaged during
transport. Transport damage should be
reported to the local distributor before the
wine cooler is put to use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than + 5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Before use
6
GB
Lighting
Charcoal lter
Wooden shelf
Sealing strip
Name plate
Control panel
Kick plate
Lock
Adjustable feet
Get to know your wine cooler
g.1
7
GB
Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance clo se to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
Ambient temperature
The climate class is stated on the name
plate. This species the optimum ambient
temperature. Wine coolers with winter posi-
tion, however, function at ambient tempera-
tures as low as 5ºC.
Installation and start-up
Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet
installation.
This device complies with relevant EU
directives including Low Voltage Directive
2014/35/EU and Electromagnetic Compatibil-
ity Directive 2014/30/EU
The socket should be freely accessible.
Connect the appliance only to 220/240 V
/ 50Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
type correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a tech-
nician only.
The rating plate provides various techni-
cal information as well as type and serial
number.
Electrical connection
g.2
Climate class Optimum room
temperature
SN +10 ºC to +32 ºC
N +16 ºC to +32 ºC
ST +18 ºC to +38 ºC
T +18 ºC to +43 ºC
8
GB
The surface on which the appliance is to be
placed must be level. Do not use a frame or
similar.
The appliance can be installed as a free-
standing unit against a wall, built into a
closet or lined up with other appliances.
It is important that the appliance be well
ventilated and that air can circulate unhin-
dered above, below and around it.
The gures below illustrate how the neces-
sary air circulation around the appliance
can be ensured (gs 3).
g. 3 g. 5
g. 4
(g 4) A “Side by Side” kit can be ordered
Installation
9
GB
The distance pieces on the rear of the ap-
pliance ensure sucient air circulation. Fit
the two caps supplied with the appliance as
shown in g.6.
g. 6
g. 7
It is important that the appliance be abso-
lutely level. It can be levelled by screwing
the adjustable feet at the front of the appli-
ance up or down (g 7).
Use a spirit level to check that the appliance
is absolutely level sideways.
Setting up
Max. 85 kg.
85
g. 8
g. 9
10
GB
Operation and function
g. 10
Electronic control
The electronic control ensures that the
temperatures set at the top and at the bot-
tom of the appliance are maintained. This is
achieved by means of an advanced control
of the refrigeration system, the heating ele-
ment, and the fan. The set temperature will
be stored in the event of power failure.
The electronic control has the following
functions:
● On/o switch
● Light switch*
● Temperature setting
● Temperature indication
● Alarm for too high and too low tempera-
tures
● Door alarm
* The light may either be turned on
constantly or only when the door is open.
Temperature indication
The display shows the actual temperature.
The upper digits of the display indicate the
temperature at the top of the appliance, and
the lower digits of the display indicate the
temperature at the bottom of the appliance.
The temperature indicator is equipped with
a built-in lter which simulates the actual
temperature in the bottles. Consequently,
the indicator does not react on short-term
uctuations of the air temperature
Temperature setting
The thermostat is equipped with a child lock
device. This device is activated by pushing
the “up and down” buttons simultaneously.
After approx. 3 seconds “Pof” ashes in
the display. Then the actual temperatures
are shown as usual. In addition, the set
temperatures can be shown by pushing
SET1 and SET2, respectively.
The child lock device is cancelled by
pushing the “up and down” buttons simul-
taneously. After approx. 3 seconds “Pon”
ashes in the display, and the temperature
can be set.
Temperature setting at the top
of the appliance
Push SET1. Then the temperature at the
top of the appliance can be adjusted up and
down by means of the “up and down” but-
tons. The temperature can be adjusted from
8 to 22°C, however so that the temperature
cannot be set at a lower temperature than
the actual set point for the bottom tempera-
ture sensor.
Otros manuales para WFG 185
1
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Idiomas:
Otros manuales de Enfriador de vino de Vestfrost
Vestfrost
Vestfrost Tecfrigo 32 Guía de inicio rápido
Vestfrost
Vestfrost WFG46 Manual de usuario
Vestfrost
Vestfrost FZ375W Manual de usuario
Vestfrost
Vestfrost FUNCTION Manual de usuario
Vestfrost
Vestfrost WFG 185 Manual de usuario
Vestfrost
Vestfrost Compact Manual de usuario
Vestfrost
Vestfrost WFG 22 Manual de usuario
Vestfrost
Vestfrost WFG48 Manual de usuario
Vestfrost
Vestfrost W155 Manual de usuario
Vestfrost
Vestfrost WFG 18 Manual de usuario
