1. The surface of the bed must be falt and horizontal.
2. Remove the plastic plates and hang them on the support bar.
3. Double-click the button to activate the VENDLET system. The VENDLET
system produces an acoustic signal and the green diode over the power
symbol turns on. When the hand control has been inactive for 90 seconds,
the system is off again.
4. The patient is repositioned by operating the hand control.
During the procedures always stay focused on the patient.
WHEN VENDLET IS USED AS SIDE RAIL
QUICK GUIDE
Vers. 2.0
5. After repositioning the patient; raise the bars if these have been lowered.
6. Attach the plastic plates – 2 on each side.
See also the side rail guide.
The button works
as a stop button
Scan the QR code
to watch instruction
videos
VENDLET
V5 and V5+
T: +45 9631 0050 • M: vendlet@vendlet.dk • W: vendlet.com
VENDLET must be used
and installed in accordance
with the manual
Tighten the sheet on
the red bar
Slacken the sheet on
the red bar
Raise
the red bar
Lower
the red bar
Raise
the blue bar
Lower
the blue bar
Tighten the sheet on
the blue bar
Slacken the sheet on
the blue bar
Power w.
illuminated diode/
stop
Under bed light
(accessory)
