VALCOBABY RAD Manual de instalación y operación

Product Reference Guide

Read and follow the instructions contained within carefully before use. Retain this guide in a

safe and easily accessible place for future reference.

Drawings, pictures and specifications contained in this manual are for illustration purposes only – actual

product may vary. VALCO BABY reserves the right to alter any specification(s), colour and/or features without

prior notice or incurring any obligation to similarly alter products previously purchased.

Thank you for purchasing a quality VALCO product. Due to our policy of continuous product

development, this model is constantly evolving. It is possible that some features or procedures

outlined here have changed since this document was written. If you are unsure of any procedure

outlined here please contact the store from which you purchased it to obtain the most up to date

information, or contact us via the internet. See relevant web contact addresses on the back page.

Assemblin

/ O

enin

our stroller

Remove the stroller from the carton and dispose of all packaging immediately. The rear wheels, front bar and hood all need to

be installed prior to use.

1. Release the frame locking strap

by simultaneously pressing the

two buckle sides in a pincer

motion.

1. Lift the handle until you hear

the frame lock into the open

position.

Wheels and brakes

1. Line up the rear wheel/brake

assembly so that the brake bar

is facing AWAY from the

stroller.

2. Lift the rear assembly inserting

the frame tubes and continuing

until the assembly is securely

locked into place.

1. line the rear wheel pin with the

rear axle housing

1. Press down on the brake lever

to simultaneously engage the

brake in both wheels.

2. To release, simply lift the lever

with you foot.

ALWAYS test that the brakes are

fully engaged by pushing the stroller

forward and backward.

1. Insert the wheel pin into the

housing.

2. Release the wheel lock and insert

the heel as far as it can go.

ALWAYS test that the wheel is secured

in the housing

Front wheel o

eration

The wheels on your RAD stroller can swivel through 3600or be fixed in

position:

1. To fix your wheel in position, turn each dial lock so that the centre

line is VERTICAL.

2. To release your locked wheel, turn each dial lock so that the centre

line is HORIZONTAL

ALWAYS ensure that BOTH wheels are set to the same action.

IMPORTANT WARNING: Always test that the wheels and/or brakes are securely engaged before use.

Your seat section

1. Line up each of the seat

connectors with the corresponding

housing located on either side of

the stroller frame.

2. Insert the connecters into the

housing until the seat is securely

in place.

1. Insert the two bumper bar pins in to

the housing located in the side

connectors of the seat.

2. To remove the bar, press on each of

the buttons and lift the bar out of

the housing. Your bar can also

operate as a “gate” by opening only

one side!

To remove the seat or face it in the

opposite direction:

1. Simultaneously press both grey

buttons located on either side of

the seat unit and lift the seat unit

from the frame.

NEVER remove the seat with a child in

it.

1. To install your hood, place each

clamp around the seat tube so

that the locking rivet is located in

the centre of the plastic clamp.

2. To remove, lift each clamp over the

locking rivet and lift off the canopy.

1. To adjust your footrest,

simultaneously press the two

adjusting buttons on either side of

the footrest and move it up or

down to the desired position.

our handle can be adjusted to

multiple positions.

2. Press the centre locking button

while simultaneously moving the

handle up or down.

3. Releasing the locking button will

allow the handle to lock into the

next available handle position.

Usin

our harness

our stroller is fitted with a multi point safety harness system. Your child MUST always be harnessed while in the stroller.

1. Insert Buckles (A) and (B) into either side of the Buckle Housing

(C). Keep inserting until they click into place securely.

2. Carefully adjust the harness straps to snugly fit your child by

adjusting the Sliders (D) located on all Shoulder Straps, Waist

Straps and the Crotch Strap.

3. To open the harness, release the Buckle Prongs by squeezing on

the top and bottom prongs simultaneously and pull apart from the

Buckle Housing.

This process may be difficult, as your buckle system has been

designed to meet very stringent safety standards to ensure

that a child cannot release the harness unaided.

The harness should be snugly fitted to the baby’s body, tight enough so that the baby cannot

wriggle itself free of the straps but loose enough so as not to cause the baby any discomfort.

IMPORTANT WARNING: Always check that all chassis hinges are securely engaged before use.

Foldin

our RAD

1. Gently lower the handle to the

floor.

2. Lock the frame using the frame

lock strap

our RAD stroller can be folded with or without

the seat unit in place.

1. Squeeze the frame lock button.

2. While keeping the button depressed push

the handle all the way inward until you feel

resistance by the secondary lock.

3. Press the grey button to release the

secondary lock and continue to push the

handle downward until you feel the frame

release.

Your child’s safet

our res

onsibilit

………

Be sure to check that all hinges, clamps and buckles are securely fixed and in place before use.

Check all parts for breakage or fatigue before use. Discontinue immediately if any part is found to be damaged or broken.

The maximum weight of the child for which this stroller is intended is 20 kg’s (44 lbs) and height of 96 cm (38 in)

Exceeding the recommended load may cause this unit to become unstable.

Care MUST be taken when folding the stroller to prevent finger entrapments.

Can be used from 6 months +. A bassinet specially designed to be used with a stroller is recommended when using this

stroller for a newborn.

NEVER jog with a newborn baby in any pram or stroller.

ALWAYS ensure that the child is clear of all moving parts when adjusting the stroller.

ALWAYS engage the brake system when the stroller is at rest.

NEVER leave any child unattended in the stroller.

NEVER use on escalators or stairs.

When in the stroller the child must ALWAYS wear the safety harness, correctly fitted and adjusted, at all times.

DO NOT hang shopping bags from the handle as this may affect the stroller’s stability.

Always use the basket provided, the maximum weight in the basket is 6 kg’s (13 lbs)

Do not carry additional children. It may be unsafe to use any accessories other than VALCO approved ones.

ALWAYS be aware of the risks provided by fire and other significant sources of heat such as radiators etc. which may be

in the immediate vicinity of your stroller.

This product is intended for domestic use only. It is not intended for commercial use.

Continued and extended exposure to sunlight and the elements can change the colours of many materials. To avoid

fadin

, alwa

s cover and store in a shaded area.

WARNINGS

Carin

for

our stroller

ht VE 2005

www.valco.com.au

www.valco.co.nz

In Australia/NZ In North America

Moving parts may be lubricated with silicone based lubricants – do not use oil. Fabrics can be hand washed

using a mild detergent.

www.valcobaby.com

1 800 610-7850

Otros manuales de Paseante de VALCOBABY

VALCOBABY

VALCOBABY Titan Manual de usuario

VALCOBABY

VALCOBABY ORION Manual de instalación y operación

VALCOBABY

VALCOBABY REBEL Q Manual de instalación y operación

VALCOBABY

VALCOBABY Mini Marathon Manual de instalación y operación

VALCOBABY

VALCOBABY VEEBEE CO-RIDER Manual de usuario

VALCOBABY

VALCOBABY Tri-Mode Twin Manual de instalación y operación

VALCOBABY

VALCOBABY LATITUDE Manual de instalación y operación

VALCOBABY

VALCOBABY Vee Bee SCOUT Manual de instalación y operación

VALCOBABY

VALCOBABY TRI MODE EX Manual de instalación y operación

VALCOBABY

VALCOBABY URBAN ULTRALIGHT STROLLER Manual de instalación y operación

VALCOBABY

VALCOBABY Zee Manual de instalación y operación

VALCOBABY

VALCOBABY Vee Bee Dash Manual de instalación y operación

VALCOBABY

VALCOBABY BUGGSTER BASSINET Manual de instalación y operación

VALCOBABY

VALCOBABY VEE BEE LIO Manual de instalación y operación

VALCOBABY

VALCOBABY ION STROLLER Manual de instalación y operación

VALCOBABY

VALCOBABY REBEL Q Manual de instalación y operación

VALCOBABY

VALCOBABY MATRIX PLUS Manual de usuario

VALCOBABY

VALCOBABY Spark Manual de instalación y operación

VALCOBABY

VALCOBABY EVO2 for 2 Manual de instalación y operación

VALCOBABY

VALCOBABY zee two Manual de instalación y operación

VALCOBABY

VALCOBABY T3 PLUS Manual de usuario

VALCOBABY

VALCOBABY Latitude Manual de instalación y operación

VALCOBABY

VALCOBABY VEEBEE DOUBLETAKE Manual de instalación y operación

VALCOBABY

VALCOBABY prism Manual de instalación y operación

Manuales populares de Paseante de otras marcas

Hauck

Hauck Priya Trioset Manual de usuario

CHILDHOME

CHILDHOME CWQDN Manual de usuario

Dreamer Design

Dreamer Design Rebound GST Manual de usuario

Britax

Britax STEELCRAFT AGILE Manual de usuario

Graco

Graco 7427 Manual de usuario

Comfort

Comfort COMPASS Manual de usuario

OBaby

OBaby Aura Manual de usuario

Tutek

Tutek Tirso Manual de usuario

Babify

Babify Dual Plus Manual de usuario

Graco

Graco Stroller Manual de usuario

Special Tomato

Special Tomato Jogger Manual de usuario

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manual de usuario

Otto Bock

Otto Bock Kimba neo Manual de usuario

Milly Mally

Milly Mally ROYAL Guía de inicio rápido

Hauck

Hauck DUETT 3 PRAM Manual de usuario

BOB

BOB DUALLIE Manual de usuario

Nuna

Nuna Pepp Manual de usuario

Britax

Britax B2 Manual de usuario