VALCOBABY BASSINET Manual de usuario

BASSINET

REFERENCE GUIDE

IMPORTANT: Please read this instruction guide before assembling and/or

using your product. Retain for future reference.

DISCLAIMER: THE DRAWINGS AND PICTURES CONTAINED HEREIN ARE FOR ILLUSTRATION PURPOSES ONLY, ACTUAL PRODUCT

IMPORTANT WARNINGS AND CAUTIONS

Remember…your child’s safety is your responsibility

9BE SURE THAT ALL CLAMPS AND BUCKLES

ARE SECURELY LOCKED INTO

PLACE BEFORE USE.

9NEVER LEAVE YOUR CHILD UNATTENDED FOR ANY REASON.

9THE MAXIMUM WEIGHT FOR A CHILD IN THIS BASSINET IS 10 kg”s.

9NEVER JOG OR RUN WITH A BABY IN ANY PRAM OR STROLLER UNTIL

THE BABY CAN PROPERLY SIT UP UNASSISTED. (Approximately 6 months

but varies from child to child)

9DO NOT HANG BAGS FROM THE HANDLE AS THIS MAY AFFECT THE

STROLLERS STABILITY. ALWAYS USE THE STROLLER BASKET.

9THE MAXIMUM WEIGHT IN THE STROLLER BASKET IS 6kg’s.

9NEVER USE THIS STROLLER ON STAIRS OR ESCALATORS.

9CHECK ALL PARTS FOR BREAKAGE OR FATIGUE BEFORE USE.

DISCONTINUE USE IMMEDIATELY IF ANY PART IS FOUND TO BE

DAMAGED OR BROKEN.

9CHECK AND TIGHTEN ALL NUTS & BOLTS BEFORE USE.

9THIS PRODUCT IS INTENDED FOR DOMESTIC USE ONLY. IT IS NOT

INTENDED FOR COMMERCIAL USE.

9DO NOT CARRY ADDITIONAL CHILDREN. IT MAY BE UNSAFE TO USE

ANY ACCESSORIES OTHER THE THOSE APPROVED BY VALCO BABY.

9NEVER CARRY YOUR STROLLER WITH A CHILD IN IT.

Should you experience any difficulty with your VALCO product, your local

retailer (from where it was purchased) is the first “port of call,” as they

are in the best position to help. They will make all the necessary

arrangements to ensure that your VALCO product is operating correctly.

Should the chassis become wet, dry off promptly before storing. If this pram is used near the

ocean or salted roads, spray the chassis and seat frame with water and dry thoroughly. This is

especially important for metal parts such as wheel spokes and springs. We recommend a rust

inhibiting product should be used to prevent rust and fatigue on these metal parts.

We recommend that you wipe down axles and lubricate the wheels every 3 months. Sand and dirt

can grind down axles, if you live near the beach or in a dusty environment you must wipe down the

axles and wheels then lubricate them MONTHLY.

AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. SILICONE BASED

LUBRICANTS ARE ACCEPTABLE. DO NOT USE OIL BASED PRODUCTS.

Visit us on the web at

www.valco.com.au MAY VARY. VALCO BABY RESERVES THE RIGHT TO ALTER ANY SPECIFICATION (INCLUDING COLOUR OR FABRIC) AT ANY TIME

WITHOUT

NOTICE. VALCO BABY WILL NOT BE

LIABLE TO

SILMILARLY

ALTER PREVIOUSLY PURCHASED PRODUCT.

Your Runabout DELUXE bassinet has been designed to maintain a consistent rocking motion while in

motion. Should you wish to secure this motion, we have added an additional securing tether at the rear of

the bassinet.

Thank you for purchasing a quality VALCO product. Due to our policy of continuous product development,

this product is constantly evolving. It is possible that some features or procedures outlined here have changed

since this document was written. If you unsure of any procedure outlined here, please contact the store from

which you purchased it to obtain the most up to date information, or contact us at [email protected]

via the internet.

Using the securing tether

1. Remove the tether strap from the

pocket at the “foot” of the bassinet.

2. Drape the strap over the top of the

bassinet.

3. Thread the buckle prongs through the

space behind the plastic footplate.

4. Circle the plastic footplate with the

tether and back up to secure in the

buckle.

5. Pull the webbing to tighten

NOTE: BE SURE TO UNDO THE SECURITY

TETHER BEFORE REMOVING YOUR BASSINET

FROM THE FRAME

Using your hood

Your Runabout DELUXE bassinet was designed to be easily carried due to the unique design of the hood.

To carry the bassinet, grab the padded hood bar at the top of the hood and away you go! The hood system is

permanent and has been designed so that the hood will not collapse when carried.

To fold the hood down, press down on the hood lock (one side only) and simultaneously fold the hood back.

To secure your hood open, simply reverse the previous process till you hear the hood lock into place.

NOTE: ALWAYS TEST THAT YOUR HOOD IS SECURELY LOCKED INTO THE OPEN POSITION BEFORE USE.

Installing the bassinet

IMPORTANT:

ALWAYS TEST THAT THE BASSINET IS SECURED IN PLACE BY GRASPING ON EITHER SIDE

AND FIRMLY PULLING IT UP TOWARD YO

BEFORE USE!

1. Standing at the side of the stroller

and holding the bassinet at both

sides by the plastic hand holds;

tilt the bassinet slightly toward

you.

2. Gently slide the bassinet housing

just over the plastic locking piece

closest to you.

3. “Line up” the other side and

repeat step 2.

4. Press down gently on the bassinet

and it will slide into place.

5. To remove, simultaneously

pressing the two triggers in the

plastic hand holds, gently lift the

bassinet from the frame.

Pre-Installation

1. Remove the seat fabrics and from your RUNABOUT stroller.

2. Inside your bassinet package you will find a set of 2 plastic locking pieces.

3. With the release buttons facing inward, insert each locking piece in turn

into the plastic housing on either side of the stroller frame.

Otros manuales de Paseante de VALCOBABY

VALCOBABY

VALCOBABY ZeeTwo Manual de usuario

VALCOBABY

VALCOBABY EZ Rider Manual de instalación y operación

VALCOBABY

VALCOBABY RAD Manual de instalación y operación

VALCOBABY

VALCOBABY SPARK DUO Manual de instalación y operación

VALCOBABY

VALCOBABY Titan Manual de usuario

VALCOBABY

VALCOBABY LATITUDE Manual de instalación y operación

VALCOBABY

VALCOBABY Spark Manual de instalación y operación

VALCOBABY

VALCOBABY RAD Manual de instalación y operación

VALCOBABY

VALCOBABY RunAbout Tri-mode series Manual de instalación y operación

VALCOBABY

VALCOBABY Latitude Manual de instalación y operación

VALCOBABY

VALCOBABY prism Manual de instalación y operación

VALCOBABY

VALCOBABY SNAP Manual de instalación y operación

VALCOBABY

VALCOBABY Matrix Manual de instalación y operación

VALCOBABY

VALCOBABY Runabout Series Manual de instalación y operación

VALCOBABY

VALCOBABY MATRIX PLUS Manual de usuario

VALCOBABY

VALCOBABY Tri Mode Series Manual de instalación y operación

VALCOBABY

VALCOBABY ION Manual de instalación y operación

VALCOBABY

VALCOBABY Latitude Stroller Manual de instalación y operación

VALCOBABY

VALCOBABY Vee Bee SCOUT Manual de instalación y operación

VALCOBABY

VALCOBABY Zee Manual de instalación y operación

VALCOBABY

VALCOBABY T3 PLUS Manual de usuario

VALCOBABY

VALCOBABY URBAN ULTRALIGHT STROLLER Manual de instalación y operación

VALCOBABY

VALCOBABY VEEBEE DOUBLETAKE Manual de instalación y operación

VALCOBABY

VALCOBABY REBEL Q SPORT Manual de instalación y operación

Manuales populares de Paseante de otras marcas

Hauck

Hauck Priya Trioset Manual de usuario

CHILDHOME

CHILDHOME CWQDN Manual de usuario

Dreamer Design

Dreamer Design Rebound GST Manual de usuario

Britax

Britax STEELCRAFT AGILE Manual de usuario

Graco

Graco 7427 Manual de usuario

Comfort

Comfort COMPASS Manual de usuario

OBaby

OBaby Aura Manual de usuario

Tutek

Tutek Tirso Manual de usuario

Babify

Babify Dual Plus Manual de usuario

Graco

Graco Stroller Manual de usuario

Special Tomato

Special Tomato Jogger Manual de usuario

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manual de usuario

Otto Bock

Otto Bock Kimba neo Manual de usuario

Milly Mally

Milly Mally ROYAL Guía de inicio rápido

Hauck

Hauck DUETT 3 PRAM Manual de usuario

BOB

BOB DUALLIE Manual de usuario

Nuna

Nuna Pepp Manual de usuario

Britax

Britax B2 Manual de usuario