V-tech VC2610 Manual de usuario
RM5887 Floor Stand
2
1. Insert the First extension (A) onto the Second
extension (B), aligning the slot in between.
Make sure the DC socket is out on opening of
the Second extension and ready for connection.
2. Let the cable jack of the Extension cable pass
through from the back of the base.
3. Pick one pole and pass the cable jack through
the pole, then connect the pole with the Base.
Install the oor stand
4. Pass the cable jack through the connector (K)
pipe, the second pole, the second connector
(K) pipe, and the third pole in turn.
Align the slot between the poles and
connector (K) pipes and connect all three poles
firmly with the pipes.
A
B
3
6. Pass the cable jack through the Second
extension (B), to the opening.
Then connect the Second extension to the
connector (J) pipe.
5. Pass the cable jack through the connector (J)
pipe, then connect the pipe with the third
pole.
7. Connect the cable jack with the DC socket, then secure the
cable with the Extension cover (C).
B
D
C
4
8. Place the floor stand near the crib. Open the base cover, and put the water bag into the base to
prevent the stand from falling. Then, cover the base cover.
5
9. Install the Baby Unit onto the First extension (A). Connect the adapter to the end of the cable and the
power supply to power up the Baby Unit.
Slide the switch to ON to power your Baby Unit on.
Floor stand installation is completed.
Otros manuales de Rack y soporte de V-tech
