Congratulations
on purchasing your new VTech product.
For support, shopping, and everything new at VTech, visit our
website at http://businessphones.vtech.com, or call
(US) 1-800-595-9511, (Canada) 1-800-267-7377.
Charge the wireless microphone unit
1. The battery is pre-installed in your wireless microphone
unit. Pull the battery tap off from the battery door before
charging.
2. Place the wireless microphone unit into the charging
cradles at the conference phone main base until they are
flush.
• Charge the battery for 8 hours before use.
• If the wireless microphone unit becomes warm
when the battery is charging, it is normal.
• Risk of explosion! Keep the battery away from
heat, sunshine or fire. Never discard battery in fire.
• Use only the supplied battery.
TIP: If you need to replace the battery, refer to the detail
instructions in VCS704 user’s manual.
Register the wireless microphone unit
You should register your new wireless microphone unit to the
base unit following the instructions below.
To register the wireless microphone unit
As part of this process, all existing, broken, or lost wireless
microphone units will be deregistered first. Then, the base
unit will re-register the four wireless microphone units that
are placed into the charging cradles.
Before registration, unplug the telephone line cord from the
wall jack to make sure there are no incoming calls during
registration.
1. Gather the new wireless microphone unit together with
the other three wireless microphone units that are to be
registered, and then place them into the charging cradles.
2. Enter 331734 on the base unit when it is not in use,
and then press . The screen displays Please place
all wireless mics on cradle, then press ‘SELECT’.
3. Make sure all the four wireless microphone units are on
the charging cradles, and then press . The wireless
microphone units enter the deregistration mode, and the
screen displays Processing...
When deregistration is complete, registration starts. The
screen displays Registering... 1 2 3 4. The number Xblinks
while registering the X-th wireless microphone unit. You hear
a confirmation tone when each wireless microphone unit is
registered. When all the four wireless microphone unit are
registered, the base unit displays Registration done.
