V-TAC VT-519 Manual de usuario

WEEE Number: 80133970

INSTALLATION MANUAL

WALL SURFACE EMERGENCY EXIT LIGHT

VT-519

SAFETY:

• Installaon of this luminaire should only be carried out by a qualiﬁed electrician or

competent person to the current IEE Wiring Regulaons (BS7671)

• Please isolate mains prior to installaon/maintenance

• Check the total load on the circuit, including when this luminaire is ﬁed, does not

exceed the rang of the circuit cable, fuse or circuit breaker

• Please note the IP (Ingress of Protecon) rang of this luminaire when deciding the

locaon for Installaon

• This product is Class II double insulated

• This product is non-dimmable

INSTALLATION:

• Provide power to the required point of installaon

• Remove the top cover as shown below in the image

• Using the top cover as a template, mark the locaon for, and drill 2 ﬁxing holes

ensuring not to infringe with any joists, gas or water pipes or electrical cables.

• Feed the mains cable through the cable entry hole in the top cover.

• Connect mains cable into push-ﬁt terminal block ensuring correct polarity is observed,

see the following ﬁgures for maintained, non-maintained and switched maintained

wiring diagram.

• Connect ﬂying lead from baery pack to the socket on the PCB.

• Reﬁt the exit sign to the top cover ensuring all 4 lugs lock into place.

• Switch on the power supply and ensure green LED indicator is illuminated

WARNING:

• This product must be disconnected from the circuit if subjected to any high voltage or

insulaon resistance tesng. Irreparable damage will occur if this instrucon is not

followed

• Recommended roune test procedure in accordance with BS5266

• Daily check – check that the status GREEN LED indicator is illuminated

• Monthly funconal test – simulate a mains supply failure for approx. 30 secs by

operaon of key switch or switching oﬀ a circuit breaker. Ensure normal supply is

restored aer test and the indicator status LED is illuminated

• Twice yearly conduct a one hour duraon test - simulate a mains supply failure for one

hour connuous test by operaon of key switch or switching oﬀ circuit breaker. Ensure

normal supply is restored aer test and the indicator status LED is illuminated

• Annual full three hour duraon test - conduct a three hour connuous duraon test.

Simulate a mains supply failure for three hour connuous test by operaon of key switch

or switching oﬀ circuit breaker. Ensure normal supply is restored aer test and the

indicator status LED is illuminated

• If the luminaire fails any of the above tests, please contact a qualiﬁed electrician.

Live

(brown)

Neutral

(blue)

Live

(brown)

Neutral

(blue)

Non Maintained

Opera�on

Maintained

Opera�on

Switched

Maintained Opera�on

Switched

Live

(brown)

Live

(brown)

Neutral

(blue)

GENERAL:

The LEDs ﬁed in this product are non-replaceable. The unit should be recycled in the

correct manner when it reaches the end of its life. Check local authories for where

facilies exist.

Clean with a so dry cloth only, do not use aggressive cleaning products or solvents

which may damage the ﬁng.

GUARANTEE

• This product is only guaranteed against defects in manufacture.

• The warranty is valid for two years from date of purchase.

• The warranty does not cover damage caused by improper installaon or abnormal wear

caused.

• The manufacturer does not warrant damage to surfaces resulng from improper

removal Or installaon.

In case of any query/issue with the product you can reach out to us at [email protected]

Tabla de contenidos

Otros manuales de Equipo de iluminación de V-TAC

V-TAC

V-TAC VT-6072 Manual de usuario

V-TAC

V-TAC VT-11-R Manual de usuario

V-TAC

V-TAC VT-7573 Manual de usuario

V-TAC

V-TAC VT-711 Manual de usuario

V-TAC

V-TAC VT-8006 Manual de usuario

V-TAC

V-TAC VT-08 Manual de usuario

V-TAC

V-TAC VT-035 Manual de usuario

V-TAC

V-TAC VT-20201ST Manual de usuario

V-TAC

V-TAC VT-45010 Manual de usuario

V-TAC

V-TAC SMART LIGHT VT-5050 Manual de usuario

V-TAC

V-TAC VT-ST42 Manual de usuario

V-TAC

V-TAC VT-1134 Manual de usuario

V-TAC

V-TAC VT-5009 Manual de usuario

V-TAC

V-TAC GU10 Milky Cover Manual de usuario

V-TAC

V-TAC VT-511S Manual de usuario

V-TAC

V-TAC VT-1140 Manual de usuario

V-TAC

V-TAC VT-768 Manual de usuario

V-TAC

V-TAC Neon Flex VT-554 Manual de usuario

V-TAC

V-TAC 11410 Manual de usuario

V-TAC

V-TAC VT-524-S Manual de usuario

V-TAC

V-TAC VT-1147 Manual de usuario

V-TAC

V-TAC VT-6005 Manual de usuario

V-TAC

V-TAC VT-061 Manual de usuario

V-TAC

V-TAC VT-4121 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario