USX-MOUNT WML016-01 Manual de usuario
47-90" Full Motion TV Wall Mount
Model: WML016-01
PRODUCT GUIDE
Congratulations on your latest purchase.Follow these simple instructions and
you'll have your TV mounted in no time.
This mount fits most TVs 47 in - 90 in (119.38 cm - 228.60 cm) ,up to 132 lbs(60 kg).
This mount fits standard TV VESA
200mm×100mm; 200mm×200mm; 200mm×300mm; 200mm×400mm;
300mm×200mm; 300mm×300mm; 400mm×200mm;
400mm×300mm; 400mm×400mm; 600mm×400mm;
?
422mm
64mm
+5°
-15°
+45°/-45°
If you have any questions along the way, just give us a call
1-800-460-0956 or mail to [email protected].
We’re ready to help!
DIMENSIONS:
TV INTERFACE: SIDE VIEW-RETRACTED:
TOP VIEW: SIDE VIEW-EXTENED:
MAX:600mm
MIN:200mm
267mm
420mm
MAX:400mm
MIN:100mm
679mm
435mm
165mm
SAFETY WARNING:
1.Never let children climb on product or play with product.
2.Do not sit or stand on product.
3.Do not fasten a TV that is heavier than the recommended load rating to the mount.
4.Using suitable concrete wall or wood stud wall.
5.Improper installation may cause property damage and/or personal injury, so the
installation must be done by two qualified contractors. The manufacture is not liable for
damage or injury caused by incorrect mounting, assembly or use.
6.Improper handling can result in cuts or lacerations.
CAUTION : This mount is intended for use with TV weights not exceeding "
maximum weight capacity 132 lbs." The wall itself has to be capable of supporting 4
times standard weight. Please don't over tighten screws in order to avoid any injury.
Use with products heavier than the maximum weights indicated may result in collapse
of the mount and its accessories causing possible injury.
①
Parts list:
ASSEMBLY TIPS:
1.Become familiar with the instructions and all parts.
2.Make sure that all parts are in the box and in good condition.
3.Assemble the product on the open flat carton or a rug to protect the product and your
floor.
4.Some heavy products need a second person to assist in the assembly. Do not install
on sloping surface.
A--Wall plate
1pc
B--Extension arm
2pcs
C--Extension arm
2pcs
D--End Support
2pcs
E--Bracket
2pcs
Hanging template
1pc
HANGING TEMPLATE
②
Step 1Install wall plate on the wall.
For concrete wall: Hold hanging template against wall at desired position on
concrete wall, then using a pencil mark 4 hole locations. Then drill holes
according pencil marks using 3/8" size drill bit to a depth of 2.5". Please remove
the hanging template on the surface of concrete wall when assembling mount on the
concrete wall. Then you will need to use wall anchors (G). Insert wall anchors (G)
into holes, you may need to use hammer to lightly tap wall anchors into wall.
Then fix wall plate unit (A) to the wall with lag bolts (F). (Figure 1)
CAUTION: The concrete wall minimum thickness no less than 8 inches, and
surface covering can't more than 3/8 inches.
CAUTION: Don't use anchor on the concrete block.
F
G
Figure 1 (keep the wall plate level)
A
L
3/8"
Hanging template
TV mounting hardware:
Wall mounting and TV bracket assembly hardware:
K--Allen key
1pc
H--M5X12 screw
4pcs
I--M6X16 screw
2pcs
J--M6X12 screw
4pcs
L--Bubble Level
1pc
F--Lag bolt
4pcs
G--Anchor
4pcs
a--M4x12 screw
4 pcs
d--M4x30 screw
4 pcs
b--M6x12 screw
4 pcs
e--M6x35 screw
4 pcs
c--M8x25 screw
4 pcs
f--M8X45 screw
4pcs
k--M4 washer
4pcs
l--M6 washer
4pcs
h--10mm spacer
4pcs
i--2.5mm spacer
8pcs
g--M8 spacer
4pcs
j--M6 spacer
4pcs
③
For wood studs: If you mount TV mount into wood studs,hold hanging template
at desired position of wood stud pre-drill the mark 4 holes using 7/32" drill bit to a
depth of 2.5", fix wall plate unit (A) to the wall with lag bolts (F). (Figure 2)
CAUTION: The wood stud min size is 2x4 inches, and surface covering can't more
than 5/8 inches. Drill hole on the wooden stud middle line.
Figure 2 (keep the wall plate level)
F
A
Step 2Assemble extension arms (B,C) as picture shows, align the extension arm
holes with the wall plate unit, then fasten them with screws (J) using allen
key (K).(Figure 3)
Step 3: Attach end support (D) onto arm extensions (B,C) using screwdriver and
screw (H).(Figure 4)
Figure 3
Figure 4
H
D
C
C
B
J
K
NEVER USE ANCHOR (G) FOR WOOD STUDS ASSEMBLY
L
16"
C
B
Stud
finder
16"
Hanging template
7/32"
④
Figure 6
TV
1 2
Step 4Attach bracket (E) to the back of TV, choose corresponding screw, washer,
spacers to fix the holes of TV rear. Please refer following ①/②/③/④
to choose appropriate combination parts for your TV. (Figure 5)
CAUTION: Using incorrect spacers may damage your TV.
c
k/l
a/b
k/l
d/e
g/h/i
f
Figure 5
Step 5Hang the pre-assembled TV unit onto extension arms (B,C).
Fasten the tube clips with brackets by using screw (I) with a screwdriver.
(Figure 6)
I
CAUTION: This step must require 2 or more people to finish.
i/j
E
E
E
E
h/i
①②③④
⑤
Figure 8
Step 6Make sure the TV unit is horizontal, you can adjust the TV plate a little bit
(+4/-4 degrees) to level the TV, by loosening or tightening (4) leveling screws
with allen key (K). (Figure 7)
Step 7You may need loosen the screws to tilt TV to your desired angle,
please remember to fasten the screws tightly after adjustment. (Figure 8)
(4) Leveling screws
K
±45°
-15°
+5°
±4°
Figure 7
K
±4°
⑥
PAY EXTRA CARE AND ATTENTION WHEN YOU FASTEN TWO TV BRACKETS
TO THE BACK PANEL OF TV IN STEP 4 . MAKE SURE THE APPROPRIATE
MOUNT HARDWARE IS BEING USED PROPERLY .
1. Select correct Mounting Hardware according to the screw hole size of your TV,
discard any remaining screws or spacers.
2. Carefully lay your TV on its face on a non-abrasivesurface, making sure to lay
padding underneath it so as not to damage the screen .
3. Place left TV bracket and right TV bracket in the appropriate position, making sure
CENTERED on the back of the TV and LEVEL with on another .
4. This product only install on the perpendicular wall,not install on the ceiling.
Step 8Manage TV cables orderly and guide them through the velcros. (Figure 9)
Figure 9
Tabla de contenidos
Otros manuales de Soporte de TV de USX-MOUNT
USX-MOUNT
USX-MOUNT XML008-K-1 Manual de usuario
USX-MOUNT
USX-MOUNT XML032-K Manual de usuario
USX-MOUNT
USX-MOUNT XMM011-09 Manual de usuario
USX-MOUNT
USX-MOUNT XAS005 Manual de usuario
USX-MOUNT
USX-MOUNT XTL006-1 Manual de usuario
USX-MOUNT
USX-MOUNT XMM016-01 Manual de usuario
USX-MOUNT
USX-MOUNT XMS004-M-1 Manual de usuario
USX-MOUNT
USX-MOUNT XML009-1 Manual de usuario
USX-MOUNT
USX-MOUNT XMS008-01 Manual de usuario
USX-MOUNT
USX-MOUNT XAS405-1 Manual de usuario
USX-MOUNT
USX-MOUNT XMM011-1 Manual de usuario
USX-MOUNT
USX-MOUNT XMM006 Manual de usuario
USX-MOUNT
USX-MOUNT XML025-03 Manual de usuario
USX-MOUNT
USX-MOUNT XAS404-1 Manual de usuario
USX-MOUNT
USX-MOUNT SML025-01 Manual de usuario
USX-MOUNT
USX-MOUNT XMM021-03 Manual de usuario
USX-MOUNT
USX-MOUNT XMM010-1 Manual de usuario
USX-MOUNT
USX-MOUNT SMM015-1 Manual de usuario
USX-MOUNT
USX-MOUNT XFL006-1 Manual de usuario
USX-MOUNT
USX-MOUNT XML025-09 Manual de usuario
