URC Total Control HDA-130 Manual de usuario
HDA-130
Owner’s Manual
Total Control HDA-130
Owner’s Manual
Total Control HDA-130
Owner’s Manual
Overview....................................................................................................................... 1
Features & Benefits..................................................................................................... 1
Parts & Pieces ............................................................................................................. 2
Front Panel Descriptions ........................................................................................... 3
Rear Panel Description .............................................................................................. 5
Installation Instructions............................................................................................. 6
Connecting peakers ................................................................................................. 8
Network etup............................................................................................................. 9
HDA Modules ............................................................................................................. 10
pecifications ............................................................................................................ 11
AFETY PRECAUTION ............................................................................................ 13
Important afety Instructions.................................................................................. 14
Caution ........................................................................................................................ 14
Federal Communications Commission.................................................................. 15
Interference tatement ............................................................................................ 15
Warning! ..................................................................................................................... 15
FCC Caution ................................................................................................................ 15
Limited Warranty tatement:................................................................................... 16
End User Agreement: ................................................................................................ 18
Table of Contents
Congratulations!
The HDA-130 ingle-Zone Amplifier is URC’s powerful and discrete amplier!
This document highlights product features, LED status conditions, basic installation, and
general speaker wiring instructions
For questions on how this device operates contact your certified URC Integrator or
URC’s Technical upport Team!
Technical Suppor t
Toll Free: 800-904-0800
Main: 914-835-4484
techsupport@urc-automation.com
H o u r s : 9 : 0 0 a m - 6 p m E S T M - F
1
Total Control HDA-130
Owner’s Manual
Overview
URC’s HDA-130 amplier delivers incredible performance, reliability, and powerful
amplication to any audio zone
The HDA-130 amplier is designed with ICEpower technology to provide a robust
distributed audio system
Using URC’s HDA ampliers in conjunction with URC architectural in-ceiling
speakers delivers an incredible high-delity audio experience throughout the
home or business
HDA products are NOT compatible with URC’s legacy Total Control ampliers (DMS)
Features & Benefits
• ingle-Zone Amplifier: Each amplier channel is rated @ 30 Watts RMS/
Channel into 8Ω, 70 Watts Peak Power Output per channel
• HDA Audio treams: This device supports up to two (2) audio sources that are
converted into a digital “high resolution” audio stream over the network
• ource haring: Any zone controlled via an HDA amplier or I/O device has
access to the system’s HDA Audio Streams
• Flexible Zone Linking: Link one or more zones on the y via Total Control’s
Rooms Menu or have your programmer congure a “Party Mode” button
Room Linking is an easy way to distribute audio across the system
• Preamplifier Output for ubwoofer: Connection available for simple setup
and addition of a subwoofer
• Integrated Audio ensor: Each available input on the HDA-130 has built-in
audio sensing capabilities These sensors can be used to trigger programmed
events or activities
• Zone Input Ducking: The HDA-130 has the ability to “fade in” an audio input
over the currently selected audio input
The perfect solution to briey lower the volume on the current source to make
an audio announcement or doorbell chime
• Power Configuration Options: The HDA-130 can be powered via PoE+,
PoE++, or the supplied 48V DC adapter
2
Total Control HDA-130
Owner’s Manual
Parts & Pieces
Included with the HDA-130 is the following:
3
Total Control HDA-130
Owner’s Manual
Front Panel Descriptions
There are three (3) LEDs on the front panel of the HDA-130:
1. Power LED: Indicates one (1) of the following:
• olid Blue: Power has been applied to the device and it has
successfully initialized
• Off: Power has been removed from the device
2. tatus LED: Indicates one (1) of the following:
• olid Blue: The device has been programmed with Total Control software
and is ready for operation
• Blinking Blue: The device is receiving a download from the Total Control
programming software
• Blinking Green: The device is receiving a rmware upgrade, this light
continues to blink until the update is fully applied
• Off: The device has not been programmed with Total Control software
2
1
4
Total Control HDA-130
Owner’s Manual
3. Ethernet LED: Indicates one (1) of the following:
• olid Blue: The device has received an IP address from the local network
• Blinking Blue: The device is connected to the local network; however, it
has not received an IP address
• Off: The device is not connected to the local network
4. Reset Button: There are two (2) ways to press this button:
• ingle Press: Tap the Reset button to power cycle the device
• Factory Reset: Press-n-hold the Reset button for 10 seconds or more
This option cannot be reversed, once the device has been factory defaulted
it requires re-programming
3
4
5
Total Control HDA-130
Owner’s Manual
Rear Panel Description
Below are the available connections on the rear of the HDA-130:
1. DC IN: Connect the supplied 48V DC adapter to this port to power the
HDA-130 amplier
2. LAN: Full Duplex Gigabit LAN ONLY, for audio streaming and zone control
(Wi-Fi NOT supported, device must be hard-lined to the network)
This port is also used for PoE+/++
3. Analog/Digital Inputs: Both of the following inputs can be used
simultaneously to provide two (2) HDA “high-denition” audio streams:
• Analog - With supplied 3 5 mm adapter
• PCM Toslink (Optical)
4. ub Out: Standard RCA connector, signal is left + right full range
5. peaker Output: Terminal block/phoenix style connector that can be
congured one of the following ways:
• Powered by External 48V DC Adapter (supplied): Output power of the
amplier is 2 x 30W RM per channel @ 8Ω
• Powered by PoE++ Adapter (not included): Output power can be set as
one of the following:
■Power Output 2 x 30W RM per channel
lotted-styled screws are
used to secure the speaker wire
to the terminal block/phoenix
style connector
1
2
3
4
5
6
Total Control HDA-130
Owner’s Manual
Installation Instructions
The HDA-130 amplifier is supplied with two (2) “L” shaped brackets for
mounting on the wall or secure vertical surface
1 Insert the supplied screws into the two (2) keyed slots on the L shaped bracket
(as displayed on the image at the right)
This L shaped bracket can be pre-installed and the HDA-130 amplier can be
inserted afterwards
2 Insert the supplied screws into the four (4) keyed slots for wall mounting
Keyhole Diameter: 0 48”/12 5mm
1
2
7
Total Control HDA-130
Owner’s Manual
3 Assure that all screws have been installed securely 3
8
Total Control HDA-130
Owner’s Manual
Connecting peakers
The HDA-130 can be placed nearly anywhere and deliver power to a local zone
To connect speaker wire:
1 Connect the speaker wire to the positive (red) and negative (black) to the wire
terminals available on the speaker (be mindful of proper polarity)
Please refer to the manufacture’s owner’s manual for specic instructions on
wiring the speaker
2 Loosen the integrated slotted-style screws (turn counter-clockwise) and remove
the phoenix connector from the terminal block on the HDA-130
3 Secure the speaker wire into the phoenix connector (using the integrated
slotted-styled screws), and reinsert it into the terminal block
4 Using the integrated slotted-styled screws on the left and right sides of the
phoenix connector (image at the right),
secure the phoenix connector to the
terminal block
CAUTION! Verify the polarity of the
speakers and the wires before
returning the phoenix connector into
the terminal block on the amplier
6.5” SP-6EX
HDA-130
Tabla de contenidos
Otros manuales de Amplificador de URC
URC
URC Total Control DMS-1200 Manual de usuario
URC
URC Total Control HDA-1600-70V Manual de usuario
URC
URC Total control DMS-100 Manual de usuario
URC
URC Total Control DMS-1200 Manual de usuario
URC
URC Total control DMS-100 Manual de referencia
URC
URC Total Control HDA-IO Manual de usuario
URC
URC DMS-OUT Manual de usuario
URC
URC HDA-4100 Manual de usuario
URC
URC DMS -1200 Manual de usuario
URC
URC Total control DMS-100 Manual de usuario
