Uniden MHS050 Manual de usuario
MHS050
Handheld VHF Marine Transceiver
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz
NOTE
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
Floating/Waterproof: JIS8
Uniden’s MHS050 radio is designed to meet the water proong
standard of JIS8 and will oat in water.
This Means: Protected against the effects of continuous immersion in water.
The MHS050 can withstand immersion in water up to 1.5m depth for 1hr.
Note this is not suitable for scuba diving.
NOTE
The MHS050 will only meet this rating if fully assembled
and all rubber seals are well maintained and correctly tted.
This means that the carabiner clip is not connected and the
battery cover securely fastened.
After your radio is submerged in water, you might notice that the sound
is distorted. This is because there is still water remaining in and around
the speaker and microphone. Just shake the radio to clear excess water,
and the sound should return to normal.
NOTE
If your radio is exposed to salt water, clean your radio
thoroughly with fresh water, and dry it before turning it on.
Ni-MH Battery Pack Warning
• This equipment contains a Ni-MH Battery Pack.
• The Ni-MH Battery Pack contained in this equipment may
explode if disposed of in a re.
• Do not short-circuit the Battery Pack.
• Do not charge the Ni-MH Battery Pack used in this equipment with any
Adaptor other than the one designed to charge this Battery Pack. Using
another Adaptor may damage the Battery Pack or cause the Battery
Pack to explode.
• Ni-MH batteries must be disposed of properly.
2
Warning
UNIDEN MHS050 Handheld VHF Marine Transceiver
Introduction
Features 4
Included in your Package 5
Optional Accessories 5
Controls and Indicators 6
Getting Started
Install the Battery Pack 8
Attaching the Beltclip 9
Using the Carabiner Clip 9
Charging the Battery Pack 9
Battery Level Display 10
Operation
Power On/Off 12
Volume 12
Selecting a Channel 13
Squelch 14
To Transmit and Receive 16
One-touch Channel 16/09 18
Triple Watch 18
Scanning 19
Programming Scan Channels 20
Drop-Out Delay 20
Power Save 21
Back Lighting 21
Monitor 21
Keypad Lock 22
Marine Channels - International 23
Warranty 26
3
Contents
UNIDEN MHS050 Handheld VHF Marine Transceiver
4
Introduction
UNIDEN MHS050 Handheld VHF Marine Transceiver
The MHS050 is a oating, waterproof, portable two-way VHF transceiver. It
is compact, lightweight, rugged and ts easily in your hand. This handheld
VHF marine radio will give you consistent, outstanding performance in
virtually all conditions and situations.
To ensure that you get the most from the MHS050’s features, please read
this operating guide carefully before using the unit.
Features
• International Marine Channels
• Built-in precision matched Antenna
• Floating / Waterproof to JIS8*
• Carabiner Clip
• Emergency 16CH / 09CH mode
• Battery Level Display
• Memory Scan
• Triple Watch
• TX Power Select
• Channel Select
• Volume Select
• Audio Monitor (Fixed Squelch)
• Key Lock On/Off
• Battery Save
*Protected against the effects of continuous immersion in water. The
MHS050 can withstand immersion in water up to 1.5m depth for 1hr.
Note this is not suitable for scuba diving.
5
Included in your Package
UNIDEN MHS050 Handheld VHF Marine Transceiver
* MHS050 (x1), MHS050-2 (x2)
** MHS050: DTMHS1, MH050-2: DTMHS2
NOTE
If any of these items are missing from the box, contact your
place of purchase, immediately.
MHS050*
AC Adapter
(AAD-050S(M))*
MHS050
CHARGING CRADLE
LIQUID CRYSTAL DISPLAY
SCAN
TRI
TX
MEM LOCK
LO
HI
Drop-in Charger
(Single charger shown)
(DTMHS1)**
NiMH Battery Pack
(BP38)*
Beltclip*
Carabiner Clip* Owner’s Manual
MHS050
Handheld VHF Marine Transceiver
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz
6
Controls and Indicators
UNIDEN MHS050 Handheld VHF Marine Transceiver
1 Antenna
2 PTT (Push-To-Talk) Button
3 Power Boost Button
4 Monitor Button
5 Channel Up/Down Key
6 Hi/Lo (Transmit Power) /
Keylock Key
7 Scan / Memory Key
8 Power key
9 Volume Up/Down key
10 16/9 / TRI (Triple Watch) Key
11 Sql (Squelch) Key
(single charger shown)
12 Microphone
13 Speaker
14 Channel Indicator
15 Scan Indicator
16 TX Indicator
17 TX Power Indicator
18 Triple Watch Indicator
19 Memory Indicator
20 Keylock Indicator
21 Battery Level Indicator
22 Charging Contacts
1
2
3
4
5
6
7
8
9
10
11
12
13
MHS050
22
CHARGING CRADLE
14
15
16
19
20
18 21
LIQUID CRYSTAL DISPLAY
17
SCAN
TRI
TX
MEM LOCK
LO
HI
1
2
3
4
5
6
7
8
9
10
11
12
13
MHS050
22
CHARGING CRADLE
14
15
16
19
20
18 21
LIQUID CRYSTAL DISPLAY
17
SCAN
TRI
TX
MEM LOCK
LO
HI
1
2
3
4
5
6
7
8
9
10
11
12
13
MHS050
22
CHARGING CRADLE
14
15
16
19
20
18 21
LIQUID CRYSTAL DISPLAY
17
SCAN
TRI
TX
MEM LOCK
LO
HI
1
2
3
4
5
6
7
8
9
10
11
12
13
MHS050
22
CHARGING CRADLE
14
15
16
19
20
18 21
LIQUID CRYSTAL DISPLAY
17
SCAN
TRI
TX
MEM LOCK
LO
HI
1
2
3
4
5
6
7
8
9
10
11
12
13
MHS050
22
CHARGING CRADLE
14
15
16
19
20
18 21
LIQUID CRYSTAL DISPLAY
17
SCAN
TRI
TX
MEM LOCK
LO
HI
7
Getting Started
UNIDEN MHS050 Handheld VHF Marine Transceiver
Connect Drop-In Charger with AC adaptor
Plug one end of the AC adaptor into the wall
outlet and the other end into the drop-in charger.
NOTE
• The drop-in charger is not water proof. Ensure the radio is
dry before connecting to the charger.
• Don’t use the charger when the ambient temperature is
below 0º C (32º F) or above 45º C (113º F)
(single charger shown)
8
Getting Started
UNIDEN MHS050 Handheld VHF Marine Transceiver
Install the Battery Pack
Your radio uses the supplied NiMH battery pack.
To install the NiMH battery pack:
1. Make sure the radio is off.
2. Turn the screw holding the battery compartment counterclockwise with
a screwdriver, and hold up the battery cover.
3. Put the NiMH battery pack in the battery compartment applying the
battery contacts to the lower charge contacts. Be sure to follow the
instructions written on the battery pack’s label. Installing the battery
pack incorrectly will prevent the unit from operating.
4. Before placing the battery cover back on the radio, check the rubber
seal around the battery compartment and the ribbon of the battery
pack: make sure that the seal is in good condition and that there is
no foreign matter under the seal.
5. Replace the battery compartment door. Tighten the screws securely.
NOTE
If the rubber seal appears warn, nicked, or dried out,
replacement seals are available. Visit the website on the
cover of this manual.
CAUTION
Use only the supplied NiMH battery pack. Do not charge
alkaline or non rechargeable batteries.
9
Getting Started
UNIDEN MHS050 Handheld VHF Marine Transceiver
Attaching the Beltclip
To attach the belt clip:
Slide the belt clip until it snaps into place.
To remove the belt clip:
To remove the belt clip, press and hold belt clip locker, slide the belt clip
at the same time until released.
Using the Carabiner Clip
Use the carabiner clip to conveniently secure the MHS050 to a belt or strap.
NOTE
The MHS050 will oat when the carabiner clip is not
connected and the battery cover securely fastened.
Charging the Battery Pack
Your radio includes charging cradle and rechargeable battery pack.
Follow these instructions to recharge the radio in the charging cradle.
NOTE
For the initial battery charge, make sure the
radio is off for optimum charging.
1. Connect the adapter’s plug to DC IN 12V jack
of the charging cradle and plug the other end into
an AC outlet.
2. Set the charging cradle on the desk or tabletop, and
place the radio in the charging cradle with the keypad
facing forward.
3. Make sure that the LED illuminates. Charge the battery
pack for 13 hours and remove the radio from the
charging cradle after charging. (single charger shown)
10
UNIDEN MHS050 Handheld VHF Marine Transceiver
Getting Started
NOTE
• Charge time may vary depending on the battery life remaining.
• For fastest charging, turn off the radio before charging.
WARNING
• The charging cradle is not waterproof. If the charging
cradle falls into water, unplug it before attempting to
remove it from the water. Allow the cradle to dry completely
before reconnecting the power.
• Wipe off dirt or shake water from your radio before placing
in the charging cradle if your radio is soiled or wet.
Tabla de contenidos
Otros manuales de Transceptor de Uniden
Uniden
Uniden UH8080S Manual de usuario
Uniden
Uniden UH078SX-NB Manual de usuario
Uniden
Uniden UH7760NB Manual de usuario
Uniden
Uniden UH5000 Manual de usuario
Uniden
Uniden UH001 Manual de usuario
Uniden
Uniden UH810S-2 Manual de usuario
Uniden
Uniden MHS115 Manual de usuario
Uniden
Uniden MHS127 Manual de usuario
Uniden
Uniden ATLANTIS250 BK - ATLANTIS 250 VHF Radio Manual de servicio
Uniden
Uniden JACKSON Manual de usuario
Uniden
Uniden Handheld UHF Transceiver UH076SX Manual de usuario
Uniden
Uniden Jackson UT-547C/D Manual de usuario
Uniden
Uniden UH200 Series Manual de usuario
Uniden
Uniden UH076DLX Manual de usuario
Uniden
Uniden UH078SX-NB Manual de usuario
Uniden
Uniden SUNDOWNER UH-099 Manual de usuario
Uniden
Uniden SPH 51DT Manual de usuario
Uniden
Uniden XTRAK 50 Series Manual de usuario
Uniden
Uniden UH076SX-NB Manual de usuario
Uniden
Uniden AX55 Manual de usuario
