TypeS BT530028 Manual de usuario
Important, retain for future reference:
Read carefully
HD BACKUP CAMERA
5” HD Monitor Wirelessly Displays Rearview
WP ITM. BT530028
Care & Use Instructions
TABLE OF CONTENTS
1. Introduction ........................................................................................................................................................................ 1
2. Package Contents ............................................................................................................................................................. 2
3. Product Specications .................................................................................................................................................... 3
4. Product Overview .............................................................................................................................................................. 3
5. Camera Status & LED Indicators.................................................................................................................................... 4
6. Connect to power .............................................................................................................................................................. 5
7. Installation Guide .............................................................................................................................................................. 7
8. Settings and Operation .................................................................................................................................................. 9
9. Safety Information .......................................................................................................................................................... 13
10. Maintenance & Warranty ...........................................................................................................................................16
11. General Information .....................................................................................................................................................19
1
Please read all of the installation instructions carefully before installing the product. Improper
installation will void manufacturer’s warranty. The installation instructions do not apply to all types of
vehicles, and are written as guidelines to assist in installing the system.
Consult an experienced technician if you are not comfortable installing the product. You can also
contact TYPE S at 866.294.9244 to speak to one of our installation specialists if you have any specic
questions regarding the HD Backup Camera - 5”HD Monitor Wirelessly Displays Rearview.
BEFORE using the HD Backup Camera - 5”HD Monitor Wirelessly Displays Rearview, please read
the safety information provided in this user manual. ALWAYS use the product as outlined in this
user manual.
Please make sure to read and understand all local laws and regulations regarding cameras and their
use in a vehicle. Laws vary by state.
1. INTRODUCTION
2
2. PACKAGE CONTENTS
Hardwire Installation Kit Spare Fuse (250V 2A)
HD Backup Camera 5”HD Monitor
12V / 24V CLA Power Adapter Windshield Mount Dash Mount
3
3. PRODUCT SPECIFICATIONS
4. PRODUCT OVERVIEW
Frequency: 2.4 GHz
Camera Resolution: 110º
Camera View Angle: HD 720P
Camera Water Resistance Rating: IP67 Waterproof Rating
Operating Temperature: 14ºF ~ 122ºF (-10ºC ~ 50ºC)
Operating Voltage: DC 12V / 24V
LED Light
Camera Lens
133mm / 5.23“ 45.6mm / 1.79“
53 mm
/ 2.08“
(without interference or obstruction)
Maximum Signal Range: 33 Feet / 10 Meters
4
5. CAMERA STATUS & LED INDICATORS
Power / Mode Status Backup Camera LED Indicator 5”HD Monitor LED Indicator
Power On Blue LED light ashes 2 times when the Backup
Camera is powered on. Blue LED light stays on when the Backup
Camera is powered on.
Power O LED light is o. LED light is o.
Pairing Mode Blue LED light ashes until update is successful. Blue LED light stays on.
139mm / 5.47“
76 mm
/ 2.99“
21.5 mm
/ 0.85“
21.5 mm / 0.85“
5
6. CONNECT TO POWER
This installation is based on powering the camera over the reverse tail lights.When installed as directed,
the camera image will only appear when the vehicle is in reverse.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical system.
Connecting to other types of electrical systems will cause damage to your vehicle. Please contact the
manufacturer if you are unaware of the system type in your vehicle.
1. Remove your license plate.
2. Determine the best route for the Camera Cable from the top of your license plate to the inside
of the vehicle. You may need to drill a small hole in the panel behind where the license plate is
situated.
3. Take the Camera and run the cable through the Rubber Ring Grommet, then from the outside of
your car to the inside. Pull the cable through so that there is a small amount of slack and you can
still move the Camera around the license plate.
4. Locate the reverse taillights wiring behind your reverse light. You may need to remove the interior
panel in order to locate. You only need to attach the Camera to ONE of the reverse lights, not
both. If you cannot manually locate the taillight cables, please contact the vehicle manufacturer
or reference a wiring diagram for your vehicle.
5. At your taillight, remove the light bulb socket from the reverse light housing.
6
Hardwire cable for Camera
Snap!
Reverse Light Power Wires
6. Determine the reverse light power wires for your car, designating the positive and negative wires.
If you are not sure of which are the power wires, then please contact your vehicle manufacturer or
reference a wiring diagram for your vehicle.
7. Connecting the Camera Power Cable:
a. Take the open wire end of this cable, and connect it to the power wires of your car (as
determined in step 4). Using the Snap Lock Splice Connectors, connect the Camera’s Red
wire to reverse light’s Positive wire. Connect the Camera’s Black Wire to reverse light’s
Negative wire.
b. Use pliers to squeeze the metal tabs of the Snap Lock Splice Connectors and ensure a solid
connection, then snap the plastic cover closed.
8. While sitting in the driver’s seat of your car with the key in the accessory position. The monitor will
automatically start when connected to a power source. If the monitor shows no image when you
place the vehicle in reverse, go to the section“Settings and Operation” for more information.
7
7. INSTALLATION GUIDE
HD BACKUP CAMERA INSTALLATION
1. Peel o the cover of the double-sided tape from the HD Backup Camera and attach the Camera to
the license plate. Press rmly to the license plate to secure the Camera.
RECOMMENDATION: Thoroughly clean & dry the mounting surface area of the license plate
before attaching.
2. Press the license plate and the Camera rmly to the car to secure and get full contact between the
license plate and the double-sided tape. Screw the license plate back onto the rear of your vehicle.
3. As a last check, note the position of the view from the Camera when you place the vehicle in
reverse. Adjust the position of the Camera as necessary to achieve the best rear view.
9. Put the vehicle in reverse. If you can see clear picture, put the vehicle back in park and turn the key
to the o position. You are now ready for nal steps.
10. Use the provided zip ties to secure wires neatly within your car.
11. Replace the light socket back into the reverse light housing.
12. Replace any interior panels that may have been removed to access the taillight and close your
trunk or rear hatch.
8
5”HD MONITOR INSTALLATION
1. Place Magnetic Windshield Mount on the windshield and adjust to your desired position.
2. Attach the 5”HD Monitor on to the Magnetic Windshield Mount.
3. Remove the 5”HD Monitor protective overlay.
4. To power the 5” HD Monitor: Take the 12V/24V Power Adapter and plug adapter into the right side
of the 5”HD Monitor. Plug the other end into 12V/24V power port in your car.
WARNING: Many vehicles provide constant power to the 12V outlet. If your outlet provides
constant power, please remember to unplug the 5” HD Monitor when not in use to avoid draining
the vehicle battery.
OR
Tabla de contenidos
Idiomas:
Otros manuales de Cámara digital de TypeS
