Turck BL67-GW-EN Guía de instalación y uso

G1005

Revised 1/14/2014

HOW TO

How to Get a BL67-GW-EN

Gateway to Communicate with a

Unitronics Touch Screen Display

2www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441 www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 3

ABOUT THIS GUIDE

This “How to”will show the user how to connect a BL67-GW-EN to a Unitronics touch screen display.

Hardware

• BL 67-GW-EN, Set Rotary Switches to 000

• BL67-B-2M12-P (Slice housing)

• BL67-4DI4DO –PD (Slice)

• Appropriate Power cable for the BL67

• An RJ45 Ethernet Switch

• Appropriate Power cable for RJ45 Ethernet Switch

• One Unitronics Touch Screen Display

• Appropriate Power cable for Unitronics Touch Screen Display

• One RJ45 to M12 cable

• Two RJ45 to RJ45 cables

• One Unitronics RJ11 to RS232 data cable

• Any type of sensor (I used a Ni20-EM30WD-AP6X-H1141)

• Appropriate sensor cable that attaches to BL67-B2M12-P slice housing

Software

• Windows XP operating system

• VisLogic software (Install VisLogic software using Unitronics Install CD)

• BL67-GW-EN VisLogic example program

www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 3

Hardware Conguration

Hook up the station in the same conguration show in the below photo. Note that RJ 45 (A) goes from the Ethernet

Switch to the Unitronics Touch Screen Display.

4www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441 www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 5

SOFTWARE CONFIGURATION

-> Open BL67-GW-EN VisLogic example program

-> Wait for the VisLogic software to open

www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 5

-> Connection -> Communications

-> Check to make sure the correct RS 232 COM Port is selected -> Click “Get OPLC Information”

6www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441 www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 7

-> Verify “OPLC Information” pops up -> Click Exit

-> Connection -> Download -> Stop – Download - Reset

www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 7

-> No

->Yes

8www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441 www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 9

UNITRONICS TOUCH SCREEN CONFIGURATION

-> Press “Activate” on the touch screen -> Notice that the status changes to “Connected”

-> Trigger the sensor and then press“Read” -> Notice that the “Read” bit is now high

www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 9

-> Remove the trigger from the sensor; press“Read” again -> Notice the “Read” bit is now low

-> Press the “write”data on the touch screen

10 www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 • TURCK • Minneapolis, MN 55441 www.turck.com • 1-800-544-7769 • Fax: (763) 553-0708 •TURCK • Minneapolis, MN 55441 11

-> Press “1” -> Press “enter”

-> Notice that the write value changed to“1”

Tabla de contenidos

Otros manuales de Puerta de turck