2
SPECIFICATION
NAME OF APPLIANCE SUPERTRON COMMERCIAL GRILL WITH SOLID GRILL PLATE
MODEL NO. GP-300, GP-600, GP-900, GP-1200
MANUFACTURED BY TU’S BROS PTY LTD
77 MAIN ROAD, CLAYTON SOUTH
VIC 3169 AUSTRALIA
CERTIFICATE NO. 6235
General Description
Grill Plate Mild steel 300mm x 600mm with a 50mm grease trough x 15mm depth.
A Ø50mm outlet from grease trough discharges into a grease collection
box located beneath grill plate and is easily removable from front of
control panel.
Gas Cocks Self latching 2 position “Off” and “On”. AGA App. No.2143
Grill Plate Flue Is provided into splashback from rear of grill plate
Gas Cocks As description under “Hot Plate”
Burner Type H shape cast iron ported burner
No. of Ports: 53 Perside x 7mm Centres
Size of Ports: 2.50mm
N.H.G.C.: NG 22MJ/h @ 1MPa, Injector 2.05mm
LPG 22MJ/h @ 2.75MPa, Injector 1.25mm
Mixing Tube Throat Venturi
Primary Air Circular on injector entry
Grill Ignition Is by means of a pilot light located adjacent to front left hand side of the
burner. Lighting of the pilot is by piezo ignition
INSTALLATION INSTRUCTIONS
(By Authotised Personnel Only)
This appliance should be installed by authorized persons only and must be installed in accordance with AG601, 1995
refer Section 5.12.4 Catering Equipment and all Clauses to 5.12.4.5.
GAS PIPING SYSTEM
The gas inlet to the appliance is located at the rear of the unit. The connection point is 425mm above the floor facing
down. The gas point is in the centre of the unit.
The unit is supplied with a ¾" B.S.P. regulator – the installer must supply a ¾" B.S.P. gas cock to enable isolation of
the appliance for servicing. The unit must have at least a 1" B.S.P. (25mm) pipe up to the connection point, with a
minimum pressure of no less than 1.13 kpa inlet. A minimum appliance operating pressure is of no less than 0.1 kpa
with 60% of the appliance operating. The installer must use a manometer to check the pressure and test for leaks.
Test points are provided off the Regulator control and off the gas cock manifold. Alternatively a burner injector may
be used off the top burner and the manometer tube placed firmly over the injector after removing the burner.
The appliance must be installed to local Health Dept. and gas fitting regulations.
For test point pressure settings refer to data plate on the appliance.
For Service: call local gas agent or retailer in your region, or contact manufacturer for service information, should
appliance fail to operate correctly.
ADDENDA
This application must be installed by an authorized person only
