TT electronics S19A01 Manual de usuario
Quick Start Guide
S-2CONNECT Hub S19A01
This is the quick start guide for S-2CONNECT Hub.
For the full user guide visit: www.s-2connect.com
Introduction
Please read the full user guide
found on the website thoroughly
before bringing this device into
service.
Packet contents
• S-2CONNECT Hub
• Quick start guide
The power supply is provided
separately.
Installation and usage
1. Make sure there is no damage to the
equipment.
2. Choose your suitable installation location.
Consider the environmental requirements
and be advised that this device contains
antennas that could be affected from other
equipment within close range.
3. Connect the power supply
4. Check the LED’s to verify proper operation
This symbol on the device or the
package means that all electronic
and electric equipment should not
be mixed with general household
waste.
Visit www.s-2connect.com/
documentation
Switching the device on
This device switches on automatically following
charging of the battery.
The battery is fully charged when the charging LED
switches off. It may take up to 9 hours to charge a fully
discharged battery.
USB/Power
connector
Using the device
This device is intended for strictly remote operation. Log in to
your user interface to interact with the device.
Battery operation
This device is primarily battery operated, but the external power
supply can be continuously connected. The battery operation
time can be up to 12 months, dependent on conguration,
surrounding temperature and other parameters.
LED functionality
Cellular
network GNSS Charging Low
battery
Humidity and Temperature sensor
LED Colour Function
GNSS Yellow Flashing = Satellite search
Cellular
Network
Orange Slow flash 20% ON, 80% OFF = Network
Searching
Slow flash 80% ON, 20% OFF = Idle mode
Fast flash 50% ON, 50% OFF = Data
transfer
Charging Green Solid = Charging
Low battery Red Flashing = Low battery charge immediately
To maintain battery life all LEDs remain inactive unless communicating a function, as outlined in the table below.
Declaration of Conformity
TT Electronics hereby declares that S-2CONNECT Hub
complies with the essential requirements of EU directive
RED2014/53/EU
Full details are available at:
www.s-2connect.com/documentation.com
FCC Compliance
S-2CONNECT Hub has been tested to full the FCC
requirements. Test reports are available upon request.
www.ttelectronics.com
Radio frequencies
Radio
technology
Frequency
band
Maximum radio-
frequency power
LT E 1,2,3,4,5,8,12,13,
18,19,20,25,28,39 24 dBm
2G 2,3,5,8 33 dBm
GNSS GPS, GLONASS,
QZSS
Bluetooth 2.4 GHz BLE
S-2CONNECT Hub must be used in compliance with
applicable and international regulations that restrict
utilisation of radio communication modules. Refer to the
full S-2CONNECT Hub user guide for more information
which can be downloaded from
www.s-2connect.com/documentation
Otros manuales para S19A01
1
Otros manuales de Cambiar de TT electronics
