5
Truck System Technologies TST 507 Instructional Manual
Note: If the right front re is blinking and does not show all “Fs”
you can delete that factory test sensor code as follows:
Press the “SET” buon unl it beeps (approx. 3 seconds). The dis-
play should now show “FFF FFF.” This display indicates the re po-
sion is NOT coded and will not show on the Main Screen when
out of the coding mode.
• Normally, start coding on the right/passenger side of
the vehicle. This is posion #1 or, in the case of a trailer,
posion #T1.
• Be sure you have your rst sensor ready and keep the
remaining sensors at least two (2) feet away from the
display as to not interfere with the coding procedure.
• Hold your rst sensor to the boom of the display
and quickly press and release the “CODE” buon. The
display’s red LED should light and it should beep once.
A six (6) digit unique code should now appear on your
screen, replacing the “FFF FFF.”
Note: If a double beep is heard and the “FFF FFF” does not
change, try quickly pushing the “CODE” buon once again. This
may have to be done a few mes for the code to appear. If the
sensor does not code, check the baery voltage, be sure other
sensors are not close to the coding sensor, be sure the sensor
is touching the display, and be sure you are quickly pushing and
releasing the “CODE” buon. Call Tech Support at 770-889-9102
if none of the above works.
• Once coded, use the (+) or (-) buons to navigate to the
next re posion you want to code a sensor to.
• Again, put sensor #2 up to the boom of the display and
quickly press and release the “CODE” buon to capture
the sensor code. The “FFF FFF” should change to a new
unique code.
